推进技术 ›› 2009, Vol. 30 ›› Issue (3): 297-301.

• • 上一篇    下一篇

进气道旋流模拟及测量的实验研究

叶飞,张堃元,姜健,史建邦   

  1. 南京航空航天大学能源与动力学院;南京航空航天大学能源与动力学院;中国飞行试验研究院发动机所;中国飞行试验研究院发动机所
  • 发布日期:2021-08-15
  • 基金资助:
    装备预先研究项目(61901080202)

Experimental investigation on simulation and measurement for intake swirl

  1. Coll.of Energy and Power,Nanjing Univ.of Aeronautics and Astronautics,Nanjing 210016,China;Coll.of Energy and Power,Nanjing Univ.of Aeronautics and Astronautics,Nanjing 210016,China;Engine Dept.of Chinese Flight Establisment,Xi’an 710089,China;Engine Dept.of Chinese Flight Establisment,Xi’an 710089,China
  • Published:2021-08-15

摘要: 进气道出口旋流是影响进气道/发动机相容性中的一个重要因素。为在地面试验中评价进气道旋流对发动机稳定性的影响,设计了叶片式旋流发生器,并在风洞中进行了整体涡旋流、对涡旋流两种基本旋流流场的模拟,实验中利用在固定马赫数下校准的五孔探针测量了所模拟的旋流场。风洞实验结果表明,按照不同布局方式来安装叶片,可以得到不同形式的旋流场;旋流发生器叶片攻角对旋流强弱的影响较为明显;旋流的诱导速度对旋流中心位置有很大的影响。

关键词: 发动机进气道相容性+;旋流发生器+;五孔探针+;风洞实验

Abstract: Intake swirl is a major disturbance parameter in engine-intake compatibility.To study swirl and evaluate criterion of engine-intake compatibility,a set of vane type swirl generator was designed.Two typical swirls were simulated using designed generator.Simulated swirl was measured by a calibrated five-hole pressure probe.The wind tunnel test results show that essential two kinds of swirl can be simulated by different vane distribution,intensity of swirl can be adjusted by different angles of vane attack.The position of swirl can be affected by induced activity of swirl.

Key words: Engine/intake compatibility+;Swirl generator+;Five-hole pressure probe+;Wind tunnel test