总压畸变对跨声速压气机静叶端区流场结构影响研究

推进技术 ›› 2014, Vol. 35 ›› Issue (5): 641-647.

总压畸变对跨声速压气机静叶端区流场结构影响研究

高海洋,孙鹏,钟兢军

大连海事大学轮机工程学院，辽宁大连 116026;大连海事大学轮机工程学院，辽宁大连 116026;大连海事大学轮机工程学院，辽宁大连 116026

发布日期:2021-08-15
作者简介:高海洋(1985—)，男，博士生，研究领域为发动机气动热力学。E-mail :gaohydlmu@163.com
基金资助:
国家自然科学基金青年基金资助项目(51006014)；中央高校基本科研业务费专项资金资助。

Effects of Total Pressure Distortion on Stator End-Wall Flow Structure of a Transonic Compressor

Marine Engineering College，Dalian Maritime University，Dalian 116026，China;Marine Engineering College，Dalian Maritime University，Dalian 116026，China;Marine Engineering College，Dalian Maritime University，Dalian 116026，China

Published:2021-08-15

摘要/Abstract

摘要： 为了进一步研究总压畸变对静叶流场结构的影响，分析影响静叶流动稳定性的因素，采用全流道非定常数值模拟方法，对两种畸变条件下的跨声速压气机流场进行求解，重点分析静叶根部和顶部附近流场参数变化情况，角区分离在各静叶流道内的发展过程，以及畸变深度对静叶流场结构的影响。研究表明，进口总压畸变引起静叶端壁角区分离，其流场结构因静叶流道相对畸变区位置不同而不同。38.2%深度畸变造成的静叶损失高于27.2%深度畸变，并且流道内流动更复杂，存在“扰动稳定区”并且有空间旋涡环生成。静叶角区分离的主要原因是畸变流体改变了进口气流角，从而使进口冲角周向分布不均匀。

关键词: 总压畸变；数值模拟；压气机；静叶；角区分离

Abstract: In order to study the effects of total pressure distortion on the stator flow field and analyze the factors that influence the stator flow stability，unsteady numerical simulation was carried out to study a transonic compressor stator flow field with two different distorted inlets. Flow parameters near hub and casing and development of corner separation in different passages were analyzed in detail. The effects of distortion depth on stator flow structure were discussed. Study shows that corner separation is induced by distorted flow near end walls in stator. Flow structure in each passage is different due to the relative position to the distorted region. Stator loss caused by 38.2% distorted inlet is higher than that caused by 27.2% distorted inlet. The stator flow structure，with 38.2% distorted inlet，is more complex. The turbulence stability region and space vortex ring exist. The main reason of corner separation in stator is that the incidence angle increases because low energy fluid changes inlet velocity angle.

Key words: Total pressure distortion；Numerical simulation；Compressor；Stator；Corner separation

高海洋,孙鹏,钟兢军. 总压畸变对跨声速压气机静叶端区流场结构影响研究[J]. 推进技术, 2014, 35(5): 641-647.

GAO Hai-yang,SUN Peng,ZHONG Jing-jun. Effects of Total Pressure Distortion on Stator End-Wall Flow Structure of a Transonic Compressor[J]. Journal of Propulsion Technology, 2014, 35(5): 641-647.

参考文献

[1] K Dragan， S Udo， L Eugen. Hub-Corner Stall in Compressor Cascades: A Comparison Between Experimental And Numerical Results[R]. ISABE -2009-1335.
[2] 李传鹏，胡骏，王英锋，等. 进气畸变对压气机稳定性的影响[J]. 工程热物理学报， 2006， 27(5): 778-780.
[3] Feng Lin， Meilin Li， Jingyi Chen. Long-to-Short Length Scale Transition: A Stall Inception Phenomenon in an Axial Compressor with Inlet Distortion[R]. ASME GT 2005-68656.
[4] 黄健，吴虎，杜文海. 45°周向压力畸变对轴流压气机影响的实验研究和机理分析. 航空动力学报[J]. 2007， 22(3): 460-464.
[5] Peng Sun， Haiyang Gao， Jingjun Zhong， et al. Study on the Influence of Total Pressure Distortion on End Wall Flow Field in a Supersonic Compressor[R]. ASME GT 2013-94729.
[6] 孙鹏，高海洋，钟兢军. 总压畸变对超声速压气机动叶端区流场结构的影响[J]. 推进技术， 2013， 34(6) : 747-753. (SUN Peng， GAO Hai-yang， ZHONG Jing-jun. Effect of Total Pressure Distortion on Rotor End Wall Flow Structure of a Supersonic Compressor[J]. Journal of Propulsion Technology ， 2013， 34(6): 747-753.)
[7] 李美林，林峰，陈静宜，等. 周向进口畸变对压气机失速过程的影响[J]. 工程热物理学报， 2005， 26(6): 931-934.
[8] 屠宝峰，胡俊. 径向进气总压畸变对压气机气动稳定性的影响[J]. 推进技术， 2012， 33(2): 167-173. ( TU Bao-feng， HU Jun. Effect of Total Pressure Distortion on Aerodynamic Stability of Compressor[J]. Journal of Propulsion Technology ， 2012， 33(2): 167-173.)
[9] K Dragan， S Udo， L Eugen. Hub-Corner Stall in Compressor Cascades: A Comparison Between Experimental And Numerical Results[R]. ISABE -2009-1335.
[10] 田江涛，吴艳辉，李清鹏. 静子轮毂角区失速与尖隙流动相互作用机理分析[J]. 工程热物理学报， 2011， 32(12):2034-2039.
[11] 杜鑫，王松涛，王仲奇. 弯叶片对大展弦比扩压叶栅角区分离控制机理研究(一)—弯叶片对角区分离起始和发展的影响[J]. 汽轮机技术， 2010， 52(3): 195-198.
[12] 罗锯，胡骏，李亮，等. 弯曲叶片对压气机轮毂-角区失速的影响[J]. 南京航空航天大学学报， 2012， 44(2): 139-145.
[13] 张华，胡波， Muhammad Yamin Younis，等. 角区三维分离流附着鞍点拓扑结构及其演化[J]. 北京航空航天大学学报. 2012， 38(7): 1-5.
[14] 韩少冰，钟兢军，陆华伟，等. 叶尖泄漏与压气机叶栅三维角区分离相互作用实验研究[J]. 推进技术， 2013， 34(2): 187-193.( HAN Shao-bing， ZHONG Jing-jun， LU Hua-wei， et. al. Experimental Investigation on Interaction Between Tip Clearance Flow and Three-Dimensional Separation in Compressor Cascade[J]. Journal of Propulsion Technology ， 2013， 34(2): 187-193.)