旋转轴角度对受限层板换热能力的影响

推进技术 ›› 2014, Vol. 35 ›› Issue (8): 1063-1069.

旋转轴角度对受限层板换热能力的影响

白国强,常海萍

江苏省航空动力系统重点实验室,南京航空航天大学能源与动力学院,江苏南京 210016;江苏省航空动力系统重点实验室,南京航空航天大学能源与动力学院,江苏南京 210016

发布日期:2021-08-15
作者简介:白国强(1984—),男,博士生,研究领域为航空发动机高温部件冷却技术。

Effects of Rotation Axis Angle on Heat Transfer in Limited Lamilloy in Rotating State

Jiangsu Province Key Laboratory of Aerospace Systems,College of Energy and Power Engineering,Nanjing University of Aeronautics and Astronautics,Nanjing 210016,China;Jiangsu Province Key Laboratory of Aerospace Systems,College of Energy and Power Engineering,Nanjing University of Aeronautics and Astronautics,Nanjing 210016,China

Published:2021-08-15

摘要/Abstract

摘要： 应用数值模拟的方法对旋转状态下受限层板在不同旋转角度下换热能力进行数值仿真研究。通过改变旋转轴和层板之间的角度,得出了旋转轴角度对层板换热能力的影响规律。研究结果表明:旋转轴与层板所成角度不同时,对流换热系数呈现一定的相似性；旋转轴与层板所成角为90°和270°时对流换热系数最高,浮升力最小,旋转轴与层板所成角度为0°和180°时,对流换热系数最低,浮升力最大；最高对流换热系数和最低对流换热系数相差55%左右；平行于层板的哥氏力比垂直于层板的哥氏力对流体的影响强烈。

关键词: 受限层板；对流换热系数；哥氏力；浮升力；旋转轴角度

Abstract: The effects of the rotation angle on heat transfer in limited lamilloy in rotating state was researched by numerial simulation. The relation between lamilloy heat transfer and rotation angle was acquired by changing rotation axis angle. Results show that heat convection coefficients put up similar characteristic with different rotation axis angles. The heat transfer coefficient is the highest and the buoyancy force is the smallest when the rotation axis angles are 90°and 270°,respectively. The heat transfer coefficient is the lowest and the buoyancy is the highest when the rotation angles are 0°and 180°,respectively. The difference between maximum and minimum heat transfer coefficient is about 55%. The effect of coriolis force paralleling to the lamilloy on air is more remarkable than that of coriolis force perpendicular to the lamilloy.

Key words: Limited lamilloy；Heat transfer coefficient；Coriolis force；Buoyancy force；Rotation axis angle

白国强,常海萍. 旋转轴角度对受限层板换热能力的影响[J]. 推进技术, 2014, 35(8): 1063-1069.

BAI Guo-qiang,CHANG Hai-ping. Effects of Rotation Axis Angle on Heat Transfer in Limited Lamilloy in Rotating State[J]. Journal of Propulsion Technology, 2014, 35(8): 1063-1069.

参考文献

[1] Parsons J A,Han J C,Zhang Y M.Wall Heating Effect on Local Heat Transfer in a Rotating?Two-Pass?Square?Channel?with?90-Degree?Rib?Turbulators[J].International Journal of?Heat?and?Mass?Transfer,1994 ,(37):1411-1420.
[2] Johnson B V,Wagner J H,Steuber G D.Heat Transfer?in?Rotating?Serpentine?Passages With Selected Model Orientations for Smooth or Skewed Trip Walls[J].Journal of? Turbomachinery ,1994,(116):738-744.
[3] Griffith Todd S,Luai Al-Hadhrami,Je-Chin Han.Heat Transfer in Rotating Rectangular Cooling?Channels (AR=4) with?Dimples[J].Journal of Turbomachinery,2003,(125):555-563.
[4] Guoguang Su,Hamn-Ching Chen,Je-Chin Han,et al.Computation of Flow and Heat Transfer in Rotating Two-Pass Rectangular Channels (AR = 1:1,1:2,and 1:4) with Smooth Walls by a Reynolds Stress Turbulence Model[J].International Journal of Heat and Mass Transfer,2004,(47):5665-5683.
[5] Luai Al-Hadhrami,Je-Chin Han.Effect of Rotation on Heat Transfer in Two-Pass Square Channels with Five Different Orientations of 45° Angled Rib Turbulators[J].International Journal of Heat and Mass Transfer,2003,(46): 653-669.
[6] Mohammad Al-Qahtani,Hamn-Ching,Chen Je-Chin Han.A Numerical Study of Flow and Heat Transfer in Rotating Rectangular Channels (AR = 4) with 45° Rib Turbulators by Reynolds Stress Turbulence Model[R].ASME 2002-GT-30216.
[7] Basha M,M AL-Qahtani,Yilbas B S.Entropy Generation in a Channel Resembling Gas Turbine Cooling Passage: Effect of Rotation Number and Density Ratio on Entropy generation[J].Sadhana,2009,(34): 439-454.
[8] Nealy D A,Relder S B.Evaluation of Laminated Porous wall Material for Combustor Liner Cooling[R].ASME 1980-GT-102.
[9] 桂忠楼,张鑫华,钟振纲等.高效冷却单晶涡轮叶片制造技术的发展[J].航空工程与维修,1998,(2) : 11～ 13
[10] Michael Huh,Jiang Lei,Je-Chin Han.Influence of Channel Orientation on Heat Transfer in a Two-Pass Smooth and Ribbed Rectangular Channel (AR=2:1) Under Large Rotation Numbers[J].Journal of Turbomachinery,2012,(134): 1-14.
[11] Liou T M,Chang S W,Hung J H,et al.High Rotation Number Heat Transfer of a 45° Rib-Roughened Rectangular Duct with Two Channel Orientations[J].International Journal of Heat and Mass Transfer,2007,(50):4063-4078.
[12] 徐磊,常海萍,潘金栋.旋转条件下带出流孔的受限空间内冲击换热[J].推进技术,2008,29(2):149-152.(XU Lei,CHANG Hai-ping,PAN Jin-dong.Heat Transfer of Impingement in Limited Room Configuration with Effusion in Rotating State[J].Journal of Proulsion Technology,2008,29(2): 149-152.)
[13] 徐磊,常海萍,潘金栋.旋转条件下“冲击/出流”双层壁内部换热试验[J].航空动力学报,2007,22(10):1658-1662.
[14] 张镜洋,常海萍,徐磊.转子叶片径向受限的“冲击-气膜出流”冷却结构流动与换热[J].推进技术,2011,32(1):125-139.(ZHANG Jing-yang,CHANG Hai-ping,XU Lei.Flow and Heat Transfer Characteristics of "Impingement Film Cooling" Configuration in Limited Space of Rotating Blade[J].Journal of Proulsion Technology,2011,32(1):125-139.)
[15] 白云峰.旋转条件下冲击冷却数值模拟及实验研究[D].南京: 南京航空航天大学,2004.(编辑:朱立影)收稿日期:2013-06-14；修订日期:2013-10-20。作者简介:白国强(1984—),男,博士生,研究领域为航空发动机高温部件冷却技术。E-mail:sxbgqsxbgq@163.com