涡流阀固体变推力发动机控制流参数影响规律研究

推进技术 ›› 2017, Vol. 38 ›› Issue (6): 1235-1240.

涡流阀固体变推力发动机控制流参数影响规律研究

魏祥庚¹,李娜¹,李江¹,孙兵²

西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,内蒙古动力机械研究所，内蒙古呼和浩特 010010

发布日期:2021-08-15
作者简介:魏祥庚，男，博士，副教授，研究领域为组合推进及推力控制技术。

Research on Influence Law of Vortex Valve SRM Thrust Modulation Affected by Control Flow Parameters

Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory， Northwestern Polytechnical University，Xi’an 710072，China,Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory， Northwestern Polytechnical University，Xi’an 710072，China,Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory， Northwestern Polytechnical University，Xi’an 710072，China and Inner Mongolia Power Machinery Research Inst.，Hohhot 010010，China

Published:2021-08-15

摘要/Abstract

摘要： 为快速求解涡流阀固体变推力发动机的工作参数、研究控制流参数对涡流阀固体变推力发动机的影响规律，改进了求解涡流阀固体变推力发动机工作参数的理论计算模型，并利用该模型研究了控制流参数对涡流阀固体变推力发动机推力调节性能的影响规律。结果表明:该模型最大相对误差为10.83%，可用于涡流阀固体变推力发动机的计算分析；在控制流压强与控制流流量相同及分子量相当的情况下，提高控制流温度可以提高推力调节比；控制流流量是决定涡流阀固体变推力发动机推力调节比最重要的参数；增加燃气发生器的燃面，不仅可以提高涡流阀固体变推力发动机的推力调节比，同时可以减小发动机的比冲损失。

关键词: 固体火箭发动机；推力调节；涡流阀；控制流；数值计算

Abstract: In order to obtain a calculation method which can solve the operating parameters of the vortex valve SRM thrust modulation fastly and study the influence law of vortex valve SRM thrust modulation affected by control flow parameters，a theoretical calculation model which provides evidence for further study of the vortex valve SRM thrust modulation’s design and theoretical analysis was improved. The results show that: (1)The model’s maximum relative error is 10.84%;(2)Improving the temperature of the control flow can promote the thrust modulation under a working condition with similar pressure，flow and molecular weight; (3)Comparing with the pressure of the control flow，flow has greater effect on thrust modulation; (4)Increasing the gas generator’s burning surface can not only increase the vortex valve SRM thrust modulation，but also decrease the engine’s specific impulse loss.

Key words: Solid rocket motor；Thrust modulation；Vortex valve；Control flow；Numerical calculation

魏祥庚,李娜,李江,孙兵. 涡流阀固体变推力发动机控制流参数影响规律研究[J]. 推进技术, 2017, 38(6): 1235-1240.

WEI Xiang-geng¹,LI Na¹,LI Jiang¹,SUN Bing². Research on Influence Law of Vortex Valve SRM Thrust Modulation Affected by Control Flow Parameters[J]. Journal of Propulsion Technology, 2017, 38(6): 1235-1240.

参考文献

[1] 徐温干. 固体火箭发动机推力大小调节技术的发展[J]. 推进技术, 1994, 15(1): 39-44. (XU Wen-gan. The Development for Technique of Adjusting Thrust of Solid Rocket Motor[J]. Journal of Propulsion Technology, 1994, 15(1): 39-44.)
[2] 张淑慧, 胡波, 孟雅桃. 推力可控固体火箭发动机应用及发展[J] . 固体火箭技术, 2002, 25(4): 12-15.
[3] Nelson C, Roberts R, Fish V. The Vortex Valve Controlled Rocket Motor[R]. AIAA 68-538.
[4] Kasselmann J T, Delozier T R. Fluidic Valve for Warm Gas Flow Control[R]. AIAA 69-118.
[5] Lewellen W S, Burn W J, Strickland H J. Transonic Swirling Flow[J]. AIAA Journal, 1969, 7(7): 1290-1297.
[6] Walsh R F, Lewellen W S, Stricker D B. Investigation of a Solid Propellant Rocket Motor Modulated by a Fluidic Vortex Valve[R]. AIAA 70-643.
[7] Walsh R F, Lewellen W S. Stricker D B. A Solid Propellant Rocket Motor Modulated by a Fluidic Vortex Valve[R]. AIAA 77-79.
[8] Lin Ray-Sing, Nathan Hariharan. Analysis of Fluidic Vortex Valves for Airflow Control in Combustors[R]. AIAA 2002-2946.
[9] 张为华, 程谋森, 刘分元. 固体发动机推力随机调节的涡流阀方案研究[J]. 推进技术, 1995, 16(5): 34-39. (ZHANG Wei-hua, CHENG Mou-sen, LIU Fen-yuan. A Study on Vortex Valve for Thrust Random Modulation of SRM[J]. Journal of Propulsion Technology, 1995, 16(5): 34-39.)
[10] 谢伦娅, 郭建, 张为华, 等. 固体发动机推力调节涡流阀方案实验研究[J] . 湖北航天科技, 1996, (3).
[11] 魏祥庚, 何国强, 李江, 等. 涡流阀几何参数对固体发动机推力调节特性的影响[J]. 推进技术, 2007, 28(4): 352-355. (WEI Xiang-geng, HE Guo-qiang, LI Jiang, et al. Effects of Vortex Valve Geometry Parameters on SRM Thrust Modulation[J]. Journal of Propulsion Technology, 2007, 28(4): 352-355.)
[12] WEI Xiang-geng, HE Guo-qiang, LI Jiang, et al. Experimental Investigation on Thrust Modulation of SRM Based on Vortex Valve[R]. AIAA 2007-5827.
[13] Yu X J, He G Q, Li J, et al. Numerical Analysis of Flow in Variable Thrust SRM[R]. AIAA 2007-5801.
[14] 余晓京, 何国强, 李江, 等. 涡流阀式变推力发动机性能影响因素数值研究[J]. 西北工业大学学报, 2009, 27(2).
[15] 金蔚, 李江, 魏祥庚. 涡流阀变推力发动机推力计算方法[J]. 固体火箭技术, 2012, 35(3): 330-334.
[16] Greenberg I, Wolff H. Cold Flow Evaluation of Parameters Influencing Thrust Modulation by a Fluidic Vortex Valve[J]. Israel Journal of Technology, 1975, 13: 73-81.　　　　　　　　　　　　　*　收稿日期:2016-03-11；修订日期:2016-05-05。作者简介:魏祥庚,男,博士,副教授,研究领域为组合推进及推力控制技术。E-mail: realysnow@nwpu.edu.cn(编辑:朱立影)