单/双涵道模式转换动态过程的数值研究

推进技术 ›› 2017, Vol. 38 ›› Issue (8): 1699-1708.

单/双涵道模式转换动态过程的数值研究

刘佳鑫,王志强,严伟,胡骏

南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016

发布日期:2021-08-15
作者简介:刘佳鑫，男，硕士生，研究领域为叶轮机气体动力学。

Numerical Simulation of Transition Between Single and Double Bypass Mode

Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China,Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China,Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China and Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究变循环发动机单/双涵道模式转换动态过程中流场参数的变化规律，基于本项目组设计的模拟模式转换过程的试验台，利用动网格技术对该试验台进行了二维数值模拟。结果表明:在模式转换动态过程中，内外涵流量和总压的变化滞后于阀门缓慢关闭的状态；并且阀门变化速率越快，其内涵总压和流量的动态响应越滞后；而静压的变化规律则相反。此外，还研究了在阀门关闭过程中，不同初始涵道比对这种流场参数变化滞后性的影响。发现初始涵道比越小，滞后性越强；并且这种滞后性在阀门关闭至22°位置时达到最大。

关键词: 变循环发动机；模式转换；数值计算；动网格技术

Abstract: To explore the flow field structure during the dynamic process of single/double bypass model selection in variable cycle engine(VCE)，an experimental equipment designed by our group is used to imitate the dynamic process，and a two-dimensional numerical simulation by dynamic mesh is carried out on this experimental equipment. During the dynamic process，the mass flow’s and total pressure’s variations were found to lag behind the condition of valve’s switching at a low speed，and with the switching speed increased，the lag will become larger. However，the regulation of static pressure’s variation is contrary. Furthermore，we studied the effects of different initial bypass ratios on the lag during the closing process，and found that the smaller initial bypass ratio，the larger the lag will become，the lag reaches the maximum when the valve is closed to 22° on closing process.

Key words: Variable cycle engine；Model selection；Numerical simulation；Dynamic mesh

刘佳鑫,王志强,严伟,胡骏. 单/双涵道模式转换动态过程的数值研究[J]. 推进技术, 2017, 38(8): 1699-1708.

LIU Jia-xin,WANG Zhi-qiang,YAN Wei,HU Jun. Numerical Simulation of Transition Between Single and Double Bypass Mode[J]. Journal of Propulsion Technology, 2017, 38(8): 1699-1708.

参考文献

[1] 方昌德. 变循环发动机[J]. 燃气涡轮试验与研究,2004, (3): 1-5.
[2] 刘洪波, 王荣桥. 变循环发动机总体结构和模式转换机构研究[J]. 航空发动机, 2008, (3): 1-5.
[3] 骆广琦, 李游, 刘琨, 等. 变循环发动机组合变几何调节方案[J]. 航空动力学报, 2014, 29(10): 2273-2278.
[4] Jeffrey J B, William J H, Pual F S. A Compar-Ative Propulsion System Analysis for High-Speed Civil Transport[R]. NASA/TM-2005-213414.
[5] Anders H, Bjon M. An Overview of Propulsion Systems for Flying Vehicles[M]. Sweden: Swedish Defense Research Agency Systems Technology, 2005.
[6] 周红, 王占学, 刘增文, 等. 双外涵变循环发动机可变几何特性研究[J]. 航空学报, 2014, (8): 2126-2135.
[7] 刘增文, 王占学, 蔡元虎. 变循环发动机模态转换数值模拟[J]. 航空动力学报, 2011, 26(9): 2128-2132.
[8] 刘华坪, 陈浮, 马波. 基于动网格与UDF技术的阀门流场数值模拟[J]. 汽轮机技术, 2008, (2): 106-108.
[9] Batina, John T. Unsteady Euler Algorithm with Unstructured Dynamic Mesh for Complex-Aircraft Aerodynamic Analysis[J]. ?AIAA Journal, 1991, 29(3): 327-333.
[10] Zhang Shengzhuo, Hongguang Xu, Song-jing Li. A Numerical Study of Fow Field in a Flapper-Nozzle Pilot Valve under Working Condition[C]. China: Fluid Power and Mechatronics, 2015 International Conference on IEEE, 2015.
[11] Chattopadhyay, Himadri. Analysis of Flow Structure Inside a Spool Type Pressure Regulating Valve[J]. Energy Conversion and Management, 2012, 53(1): 196-204.
[12] Qian Jin-yuan. CFD Analysis on the Dynamic Flow Characteristics of the Pilot-Control Globe Valve[J]. Energy Conversion and Management, 2014, 87: 220-226.
[13] Farhat C, Degand C, Koobus B, et al. Torsional Springs for Two Dimensional Dynamic Unstructured Fluid Meshes[J]. Computer Methods in Applied Mechanics and Engineering, 1998, 163(1-4): 231-245.
[14] Dumont Kris. Validation of a Fluid-Structure Interaction Model of a Heart Valve Using the Dynamic Mesh Method in Fluent[J]. Computer Methods in Biomechanics and Biomedical Engineering, 2004, 7(3): 139-146.
[15] 张来平, 邓小刚, 张涵信. 动网格生成技术及非定常计算方法进展综述[J]. 力学进展, 2010, (4): 424-447.
[16] 李鹏. 非结构动网格技术在子母弹分离流场仿真中的应用[D]. 南京:南京理工大学, 2012.　　　　　　　　　　　　　　收稿日期:2016-03-17；修订日期:2016-06-28。作者简介:刘佳鑫 ,男,硕士生,研究领域为叶轮机气体动力学。E-mail: 806918651@qq.com(编辑:张荣莉)