动力涡轮导叶可调的三轴式船用燃气轮机动态实时仿真

推进技术 ›› 2018, Vol. 39 ›› Issue (1): 212-219.

动力涡轮导叶可调的三轴式船用燃气轮机动态实时仿真

王涛^1,2,尹钊¹,田拥胜¹,高庆^1,2,谭春青^1,2

中国科学院工程热物理研究所，北京 100190; 中国科学院大学，北京 100049,中国科学院工程热物理研究所，北京 100190,中国科学院工程热物理研究所，北京 100190,中国科学院工程热物理研究所，北京 100190; 中国科学院大学，北京 100049,中国科学院工程热物理研究所，北京 100190; 中国科学院大学，北京 100049

发布日期:2021-08-15
作者简介:王涛，男，博士生，研究领域为燃气轮机总体仿真与控制技术。
基金资助:
中国科学院创新基金项目(CXJJ-16S034)。

Dynamic Real-Time Simulation of Triaxial Marine Gas Turbine with Variable Power Turbine Guide Vane

Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China; University of Chinese Academy of Sciences，Beijing 100049，China,Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China,Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China,Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China; University of Chinese Academy of Sciences，Beijing 100049，China and Institute of Engineering Thermophysics，Chinese Academy of Sciences，Beijing 100190，China; University of Chinese Academy of Sciences，Beijing 100049，China

Published:2021-08-15

摘要/Abstract

摘要： 鉴于传统的燃气轮机建模方法用于动力涡轮导叶可调的三轴式船用燃气轮机动态实时仿真时具有一定局限性，提出了一种新型的基于径向基函数(Radical basis function，RBF)的神经网络与部件法(Component modeling method，CMM)的复合建模方法(HMRC)。该方法针对该型燃气轮机的结构和总体性能特点，合理地选取了样本点以减小样本规模。通过神经网络与部件法分别计算燃气发生器与动力涡轮相关参数，采用MATLAB/SIMULINK仿真软件建立实时仿真模型。与传统的部件法建立起来的仿真模型对比，新方法计算结果与部件法吻合度高，误差低于1%，同时模型的实时性得到了大幅提升，计算速度约为部件法的7倍。

关键词: 导叶可调；船用燃气轮机；实时仿真；RBF神经网络；部件建模法

Abstract: There are some limitations in using traditional gas turbine modeling approaches for dynamic real-time simulation of triaxial marine gas turbine with variable power turbine guide vane. Therefore， Hybrid Method (HMRC) of Radial basis function (RBF) neural net algorithm and Component modeling method (CMM) is developed. After analyzing the characteristics of the gas turbine structure and overall performance， sample points are selected reasonably to minimize sample size. Using neural net algorithm and component modeling method to calculate gas generator and power turbine relevant parameters respectively， the real-time simulation model is built by MATLAB/SIMULINK. Through the comparison between new model and CMM model， computational results of the new model are very close to those of CMM model with the error less than 1%. Meanwhile， the new model real-time performance is improved significantly as the new model is about 7 times CMM model computation speed.

Key words: Variable guide vane；Marine gas turbine；Real-time simulation；RBF neural net；Component modeling method

王涛,尹钊,田拥胜,高庆,谭春青. 动力涡轮导叶可调的三轴式船用燃气轮机动态实时仿真[J]. 推进技术, 2018, 39(1): 212-219.

WANG Tao^1,2,YIN Zhao¹,TIAN Yong-sheng¹,GAO Qing^1,2,TAN Chun-qing^1,2. Dynamic Real-Time Simulation of Triaxial Marine Gas Turbine with Variable Power Turbine Guide Vane[J]. Journal of Propulsion Technology, 2018, 39(1): 212-219.

参考文献

[1] 冯永明, 黄全军, 刘顺隆, 等. 舰船燃气轮机变几何动力涡轮通流特性的数值研究[J]. 燃气轮机技术, 2005, 18(2): 37-43.
[2] Smith D L, Stammetti V A. Sequential Linearization as an Approach to Real Time Marine Gas Turbine Simulation[R]. ASME GT 1989-203.
[3] Qusai Z A, Munzer S Y. Modeling and Simulation of a Gas Turbine Engine for Power Generation[J]. Journal of Engineering for Gas Turbines and Power, 2006, 128(2): 302-311.
[4] 李淑英, 李铁磊, 王志涛. 船舶燃气轮机发电机组实时仿真新方案[J]. 哈尔滨工程大学学报, 2014, 35(1): 69-73.
[5] Alcaide I X, Hernandez I, Garduno R. Real-Time Simulation of a Gas Turbine Driven Power Plant for Control System Design[R]. IFAC, 9555-9560, 2011.
[6] Jaw L C, Mat C, Mattingly J D. Aircraft Engine Controls, Design, System Analysis, and Health Monitoring[M]. Virginia: American Institute of Aeronautics and Astronautics, 2009.
[7] Lietzau K, Kreiner A. Model Based Control Concepts for Jet Engines[R]. ASME GT 2001-0016.
[8] 左志涛. 燃气轮机整机性能仿真研究[D]. 北京:中国科学院工程热物理研究所, 2012.
[9] Chacartegui R, Sánchez D, Mu?oz A, et al. Real Time Simulation of Medium Size Gas Turbines[J]. Energy Conversion and Management, 2011, 52(1): 713-724.
[10] Camporeale S M, Fortunato B, Mastrovito M. A Modular Code for Real Time Dynamic Simulation of Gas Turbines in Simulink[J]. Journal of Engineering for Gas Turbines and Power, 2006, 128(7): 506-517.
[11] 苏明, 陈德来, 张园蔚, 等. 一种燃气轮机模块化非线性仿真模型[J]. 热能动力工程, 1998, 13(6): 435-437.
[12] Chung G Y, Prasad J V R, Dhingra M, et al. Real Time Analytical Linearization of Turbofan Engine Model[J]. Journal of Engineering for Gas Turbines and Power, 2014, 136(1): 1250-1262.
[13] 宋志平, 韩崇昭, 魏瑞轩. 基于发动机非线性响应的辨识线性模型方法[J]. 推进技术, 2005, 26(2): 155-157. (SONG Zhi-ping, HAN Chong-zhao, WEI Rui-xuan. Method to Identify the Multimode Linear Model of Aeroengine Based on Nonlinear Response[J]. Journal of Propulsion Technology, 2005, 26(2): 155-157.)
[14] 吴海燕. 分轴燃气轮机的建模和仿真研究[D]. 上海:上海交通大学, 2013.
[15] 李永进, 张海波, 张天宏. 一种考虑非线性余项的机载发动机自适应模型建立及其在寻优控制中的应用[J]. 推进技术, 2016, 37(1): 172-180. (LI Yong-jin, ZHANG Hai-bo, ZHANG Tian-hong. Establishment and Application in Performance Seeking Control of an On-Board Adaptive Aero-Engine Model Considering Nonlinear Remainders[J]. Journal of Propulsion Technology, 2016, 37(1): 172-180.)
[16] 曾进, 任庆生, 翁史烈, 等. 基于神经网络的燃气轮机动态过程仿真[J]. 热能动力工程, 2000, 15(4): 423-425.
[17] 苏明, 翁史烈, 张伯年. 船用三轴燃气轮机动态过程实时仿真的数学模型[J]. 上海交通大学学报, 1990, 24(3): 1-7.
[18] 冯永明, 刘顺隆. 舰船燃气轮机变几何动力涡轮三维粘性流场的数值分析[J]. 哈尔滨工程大学学报, 2005, 26(5): 580-585.
[19] 李天禄, 乔渭阳. 变几何涡轮流动机制及气动性能数值模拟研究[J]. 科学技术与工程, 2012, 12(35): 9602-9607.
[20] Fawke A J, Saravanamuttoo H I H. Digital Computer Simulation of Dynamic Response of Twin-Spool Turbofan with Mixed Exhausts[J]. Aeronautical Journal, 1973, 77: 471-478.
[21] 曾进, 任庆生, 翁史烈, 等. 基于神经网络的燃气轮机动态过程仿真[J]. 热能动力工程, 2000, 15(4): 423-425.
[22] 穆云峰. RBF神经网络学习算法在模式分类中的应用研究[D]. 大连:大连理工大学, 2006.
[23] 乔俊飞, 韩红桂. RBF神经网络的结构动态优化设计[J]. 自动化学报, 2010, 36(6): 865-872.
[24] 王志涛, 李淑英, 谭智勇. 基于 BP和 RBF 神经网络压气机特性曲线拟合方法的研究[J]. 汽轮机技术, 2009, 51(2): 94-96.(编辑:张荣莉)　　　　　　　　　　　　　*　收稿日期:2016-08-25；修订日期:2016-11-16。基金项目:中国科学院创新基金项目(CXJJ-16S034)。作者简介:王涛,男,博士生,研究领域为燃气轮机总体仿真与控制技术。E-mail: wangtao15@iet.cn