基于高低周复合疲劳试验技术的叶片失效故障复现

doi:10.13675/j.cnki.tjjs.190604

推进技术 ›› 2020, Vol. 41 ›› Issue (5): 1130-1137.DOI: 10.13675/j.cnki.tjjs.190604

基于高低周复合疲劳试验技术的叶片失效故障复现

由于¹，张伟¹，燕群¹，徐健¹，王春生²，李忠义²，孙贺²

1.中国飞机强度研究所航空声学与振动航空科技重点实验室，陕西西安 710065;2.航空工业空气动力研究院，黑龙江哈尔滨 150001

发布日期:2021-08-15

Blade Failure Recurrence Based on High-Low Cycle Complex Fatigue Experimental Technique

1.Laboratory of Aeronautical Acoustics and Vibration,Aircraft Strength Research Institute of China,Xi’an 710065,China;2.AVIC Aerodynamic Research Institute,Harbin 150001,China

Published:2021-08-15

摘要/Abstract

摘要： 针对某涵道尾桨风扇叶片在风洞试验中发生的断裂故障，基于叶片破坏模式和载荷形式，初步分析为离心载荷/低循环疲劳（LCF）和气动载荷/高循环疲劳（HCF）耦合作用导致的疲劳破坏。基于此，通过正交载荷解耦和协调加载控制等关键技术开展联合载荷作用下的叶片复合疲劳(CCF)试验技术研究和试验考核验证。试验结果表明，离心载荷控制精度优于±1%，气动载荷控制精度优于±8‰。试验应变响应频率与试验加载频率一致性较好，满足试验加载和控制的同步性要求。最终，通过对叶片故障复现验证失效原因分析的正确性，为叶片结构优化设计、寿命评估和复合疲劳试验奠定技术基础。

关键词: 叶片;复合疲劳;试验技术;正交载荷解耦;故障复现

Abstract: Considering on the failure mode and load type of blade, it can be preliminarily inferred that the fracture failure of a certain type of ducted tail rotor fan blade which occurred in wind tunnel experiment resulted from the coupling effect of centrifugal load/Low Cycle Fatigue (LCF) and aerodynamic load/High Cycle Fatigue (HCF). Based on this, the Combined Cycle Fatigue (CCF) experimental technique on combined loads of blade was investigated and verified by means of the critical technologies of orthogonal loads decoupling and coordinated loading control. The results show that the control precision of centrifugal load is superior than ±1%, and the control precision of aerodynamic load is superior than ±8‰. The frequency of the strain response is consistent with the frequency of load, which satisfies the requirements of the synchronization of loading control. Finally, the validity of failure analysis is verified by blade failure recurrence, which lays the technical foundation for structural optimization design, fatigue life evaluation and CCF experiment of blade.

Key words: Blade;Combined Cycle Fatigue(CCF);Experimental technique;Orthogonal loads decoupling;Failure recurrence

由于，张伟，燕群，徐健，王春生，李忠义，孙贺. 基于高低周复合疲劳试验技术的叶片失效故障复现[J]. 推进技术, 2020, 41(5): 1130-1137.

YOU Yu¹, ZHANG Wei¹, YAN Qun¹, XU Jian¹, WANG Chun-sheng², LI Zhong-yi², SUN He². Blade Failure Recurrence Based on High-Low Cycle Complex Fatigue Experimental Technique[J]. Journal of Propulsion Technology, 2020, 41(5): 1130-1137.

参考文献

[1] Schweizer C, Seifert T， Nieweg B， et al. Mechanisms and Modeling of Fatigue Crack Growth under Combined Low and High Cycle Fatigue Loading[J]. International Journal of Fatigue， 2011， 33(2): 194-202.
[2] 陶春虎，钟培道，王仁智，等. 航空发动机转动部件的失效与预防[M]. 北京:国防工业出版社， 2008.
[3] 张博，侯学勤. 冷却风扇叶片断裂分析[J]. 失效分析与预防， 2016， 11(2): 100-104.
[4] 王红，左华付，何训，等. 某航空发动机第三级涡轮叶片失效分析[J]. 失效分析与预防， 2007， 2(1): 24-28.
[5] 任军. 激光强化涡轮叶片高低周复合疲劳寿命研究[D]. 北京:北京航空航天大学， 2013.
[6] Dungey C， Bowen P. The Effect of Combined Cycle Fatigue upon the Fatigue Performance of TI-6AL-4V Fan Blade Material[J]. Journal of Materials Processing Technology， 2004， 153（1）: 374-379.
[7] 闫晓军，孙瑞杰，邓瑛，等. 涡轮叶片复合疲劳特性曲线及其规律的试验[J]. 航空动力学报， 2011， 26(8): 1824-1829.
[8] 赵振华，陈伟. 高低周复合载荷对TC11钛合金疲劳性能的影响[J]. 航空动力学报， 2011， 26(11): 2468-2474.
[9] Hou N X， Wen Z X， Yu Q M， et al. Application of a Combined High and Low Cycle Fatigue Life Model on Life Prediction of SC Blade[J]. International Journal of Fatigue， 2009， 31(4): 616-619.
[10] Zheng X， Engler-Pinto C C， Su X， et al. Modeling of Fatigue Damage under Superimposed High-Cycle and Low-Cycle Fatigue Loading for a Cast Aluminum Alloy[J]. Materials Science & Engineering A， 2013， 560: 792-801.
[11] Shun-Peng Zhu， Peng Yue， Zheng-Yong Yu. A Combined High and Low Cycle Fatigue Model for Life Prediction of Turbine Blades[J]. Materials， 2017， 10(7):698-712.
[12] 幸杰，韩永典，徐连勇，等. 基于连续损伤力学的高低周复合疲劳损伤[J]. 焊接学报， 2017， 38(7): 63-66.
[13] 侯贵仓，王荣桥，闫晓军，等. 轮盘榫齿高低周复合疲劳寿命试验研究[J]. 北京航空大学学报， 1999， 25(2): 167-170.
[14] 唐铃，尚柏林，高星伟，等. 某型发动机风扇叶片复合疲劳试验加载系统的分析与测试[J]. 机械强度， 2018， 40(1): 61-67.
[15] 张亚騤，周瑞祥，郭书祥. 压气机叶片复合疲劳试验系统的设计及疲劳寿命分析[J]. 航空动力学报， 2017， 32(12): 2880-2887.
[16] Weser Swen， Gampe Uwe， Raddatz Mario， et al. Advanced Experimental and Analytical Investigations on Combined Cycle Fatigue (CCF) of Conventional Cast and Single-Crystal Gas Turbine Blades[R]. ASME GT 2011-45171.
[17] Cross C J. Multi-Axial Testing of Gas Turbine Engine Blades[R]. AIAA 2000-3641.

基于高低周复合疲劳试验技术的叶片失效故障复现

Blade Failure Recurrence Based on High-Low Cycle Complex Fatigue Experimental Technique

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价