Please wait a minute...

Current Issue

  • 2010,Vol 31,No. 4

    15 April 2010

Parameterized design and orthogonal experiment analysis of osculating-cone waverider

2010, 31 (4): 385-389   

Numerical investigation on performance improvement of two-dimensional,fixed-geometry inlet at low Mach numbers

2010, 31 (4): 390-393   

Numerical simulation of shock wave/turbulent boundary-layer interactions in transonic and supersonic flows

2010, 31 (4): 394-400   

Experimental investigation for vitiated air effects on hydrogen-fueled supersonic combustor performance

2010, 31 (4): 401-405   

Numerical investigation of interaction between symmetric crossing shock waves/turbulence boundary layer

2010, 31 (4): 406-411   

An application of parallel in situ adaptive tabulation method in calculation of supersonic combustion

2010, 31 (4): 412-417   

Design of vaporing combustor with double chambers and high temperature rise

2010, 31 (4): 418-422   

Research on the calculation method of infrared signature of rocket motor exhaust plume

2010, 31 (4): 423-427   

Stall inception of low-speed axial-flow compressor with inlet distortion

2010, 31 (4): 428-432   

Effect on corner separation control for high load compressor cascade with different end-wall BLS position

2010, 31 (4): 433-437   

Effect of the secondary flow on the film cooling turbine cascade

2010, 31 (4): 438-443   

Modeling of mechanical properties of NEPE high energetic propellants

2010, 31 (4): 444-447   

Mechanism of boric-acid-ester bonding agent in AP/RDX/Al/HTPB propellant

2010, 31 (4): 448-451   

Analysis of jet propagating process of jets produced by ignition moter

2010, 31 (4): 452-455   

Heat transfer characteristics of a single-element gas-gas injector chamber

2010, 31 (4): 456-461   

Unsteady thermal-structural analysis of heat sink scramjet

2010, 31 (4): 462-467   

Numerical study of convective heat transfer of aviation kerosene flows in pipe at supercritical pressure

2010, 31 (4): 467-472   

Effects of critical geometrical parameters on distribution of contact stress in a tenon jointing

2010, 31 (4): 473-477   

Experimental and numerical study on the leakage characteristics of brush seals at the early stage of operating

2010, 31 (4): 478-482   

Experimental investigation on coaxial jets mixing controlled by diaphragm actuator

2010, 31 (4): 483-489   

Design and simulation of the discharge current wave for pulsed plasma thruster

2010, 31 (4): 490-495   

Numerical study of the process of the evolution of bubble of high-speed jet underwater

2010, 31 (4): 496-502   

Calculation of three-dimensional two-phase detonation in pulse detonation engine

2010, 31 (4): 503-507   

Experimental investigation on multi-pipe synchronous ignition technique using two-phase detonation wave

2010, 31 (4): 508-512