Ship Propulsion

Performance comparison between internal waverider inletand typical sidewall compression inlet

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 151-158   

Numerical investigation of a new short isolator with bleed slots

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 159-164   

Combustion , Heat and Mass Transfer

Turbine aerodynamic design criteria of versatile core

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 165-174   

Effects of diffuser blade geometry at leading edge on a highly-loaded centrifugal compressor

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 175-181   

Experimental and numerical study on temperature variation and air flow distribution in trapped votex combustor

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 182-187   

Experimental research on low-frequency instability in ramjet combustor

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 188-190   

Hybrid LES/RANS simulation of supersonic combustionusing flamelet model

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 191-196   

Effect of swirl intensity on combustion characteristic of gas-gas injector

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 197-201   

Numerical analysis of deflection torqueof flexible joint with high pressure

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 202-206   

Effects of lobe penetration ratio on performance of mixer exhaust system

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 207-213   

Two-phase coupled model for DSMC plume simulation

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 214-219   

Control ,Measurement and Fault Diagnosis

Global sliding mode control for aeroenginebased on PSO network

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 220-224   

Material,Propellant and Fuel

Nonlinear interface debonding of viscoelastic composite propellantusing Mori-Tanaka finite element method

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 225-229   

Measurement of heat flux for the composite propellants in theexternal fire test

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 230-234   

Shape optimization of star shape grain considering structureintegrity and loading fraction

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 235-239   

Real-time ablation measurements on erosion of silicone rubber and EPDM material by highly concentrated particles

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 240-244   

Large eddy simulation of the effect of rotation on film cooling

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 245-252   

Numerical investigation on the influence of transverse slotconfigurations on film cooling effect

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 253-260   

Heat transfer characteristics of kerosene in micro-channelunder supercritical pressure

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 261-265   

A new fault diagnosis method for turbopump of liquid rocket engine

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 266-270   

Algorithm and experimental validation for condition monitoring,fault detection for gas turbine engine

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 271-275   

Failure analysis and parameter optimization for fueldistributor for aeroengine

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 276-281   

New Propulsion System

Investigation on common-rail fuel system for rotary valvedpulse detonation engine

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 282-286   

Numerical investigations on detonation induced by diffracted shock waves of double square obstacles

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 287-291   

On the energy balance and efficiency of water-fed pulsed plasma thruster

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 292-295   

Experiment on wall temperature of an air-breathing pulse detonation engine

Abstract ( ) PDF (0KB) ( )

2011, 32 (2)： 296-300