背压对撞击式喷嘴雾化特性影响研究

doi:10.13675/j.cnki.tjjs.190196

推进技术 ›› 2020, Vol. 41 ›› Issue (4): 847-859.DOI: 10.13675/j.cnki.tjjs.190196

背压对撞击式喷嘴雾化特性影响研究

李佳楠¹，雷凡培²，周立新¹

1.西安航天动力研究所液体火箭发动机技术重点实验室，陕西西安 710100;2.中国船舶工业集团有限公司，北京 100044

发布日期:2021-08-15
基金资助:
国家重大基础研究项目（613193）。

Effects of Backpressure on Atomization Characteristics of Impinging Jet Injector

1.Science and Technology on Liquid Rocket Engine Laboratory,Xi’an Aerospace Propulsion Institute,Xi’an 710100,China;2.China State Shipbuilding Corporation Limited,Beijing 100044,China

Published:2021-08-15

摘要/Abstract

摘要： 为研究背压对撞击式喷嘴雾化特性的影响，将压力的变化等效为气体密度的变化，基于一种树形自适应加密算法，通过直接数值求解不可压Navier-Stokes方程组实现了不同背压条件下射流撞击雾化的数值模拟。首先将数值模拟结果与试验数据进行对比，验证数值模拟的有效性，在此基础上开展了高背压条件下雾化过程的数值模拟。结果表明，随着背压的提高，气动力相应增强，液膜的破碎更加剧烈，一次雾化区域的液滴数密度增大，雾场由稀疏向稠密发展；液膜在向下游运动过程中波动速度的幅值逐渐增大，并且随着背压的提高，液膜的波动由线性向非线性转变；背压增大导致破碎长度减小，经过参数修正得到了液膜破碎长度的经验公式，并与试验数据进行了对比；背压对液滴尺寸分布规律没有显著影响，但随着背压的提高，同一时刻大液滴所占的比例提高，整个雾场的Sauter平均直径有增加的趋势，当背压从0.1MPa增大到1MPa时，雾场的Sauter平均直径由155.5μm增大到166.9μm；背压增大，液滴粒径分布的均匀度指数减小，液滴尺寸分布更加不均匀。

关键词: 撞击式喷嘴;射流;雾化特性;液膜;液滴;数值模拟

Abstract: To investigate the effects of backpressure on the atomization characteristics of impinging jet injector, variation of pressure was equivalent to the change of gas density. Based on tree-shaped adaptive mesh refinement algorithm, incompressible Navier-Stokes equations were directly solved to realize numerical simulation of impinging jet atomization. First, numerical results were validated by comparing with experimental data. On the basis of that, simulations of impinging jet atomization under high backpressures were carried out. The results revealed that with the increase of backpressure, aerodynamic force is enhanced accordingly. The breakup of liquid sheet becomes more severely, and the droplet density of primary atomization region increases at the same time. As a result, the atomization field develops from dilute to dense. The amplitude of fluctuating velocity component increases gradually when liquid sheet moves downstream. In addition, with the increase of backpressure the fluctuation develops from linear to nonlinear. The increase of backpressure leads to the decrease of breakup length of liquid sheet. Empirical correlation of breakup length of liquid sheet was obtained by parameter correction, and results from correlation were compared with experimental data. Backpressure has no significant effect on the droplet diameter distribution. However, with the increase of backpressure, the proportion of large droplets increase at the same time and Sauter mean diameter of the whole atomization field has the trend to increase. When the backpressure increases from 0.1MPa to 1MPa, Sauter mean diameter of the whole atomization field increases from 155.5μm to 166.9μm. In addition, with the increase of backpressure the homogeneous index of droplet diameter distribution decreases which implies that the distribution of droplet diameter becomes more uneven.

Key words: Impinging jet injector;Jet;Atomization characteristics;Liquid film;Droplet;Numerical simulation

李佳楠，雷凡培，周立新. 背压对撞击式喷嘴雾化特性影响研究[J]. 推进技术, 2020, 41(4): 847-859.

LI Jia-nan¹, LEI Fan-pei², ZHOU Li-xin¹. Effects of Backpressure on Atomization Characteristics of Impinging Jet Injector[J]. Journal of Propulsion Technology, 2020, 41(4): 847-859.

参考文献

[1] 庄逢辰. 液体火箭发动机喷雾燃烧的理论、模型及应用[M]. 长沙: 国防科技大学出版社, 1995.
[2] Heidmann M F， Priem R J， Humphrey J C. A Study of Sprays Formed by Two Impinging Jets[R]. NACA-TN-3835， 1957.
[3] Heidmann M F， Humphrey J C. Fluctuations in a Spray Formed by Two Impinging Jets[R]. NACA-TN-2349， 1952.
[4] Anderson W E， Ryan H M， Santoro R J. Impact Wave-based Model of Impinging Jet Atomization[J]. Atomization and Sprays， 2006， 16: 791-805.
[5] Ryan H M， Anderson W E， Pal S， et al. Atomization Characteristics of Impinging Liquid Jets[J]. Journal of Propulsion and Power， 1995， 11(1): 135-145.
[6] Li R， Ashgriz N. Characteristics of Liquid Sheets Formed by Two Impinging Jets[J]. Physics of Fluids， 2006， 18(8).
[7] 李佳楠，雷凡培，周立新，等. 液体火箭发动机背压振荡环境下的雾化特性研究进展[J]. 推进技术， 2019, 40(10)
[8] Strakey P A， Talley D G. Spray Characteristics of Impinging Jet Injectors at High Back-Pressure[C]. Pasadena: 8th International Conference on Liquid Atomization and Spray Systems， 2000.
[9] Dombrowski N， Hooper P C. The Performance Characteristics of an Impinging Jet Atomizer in Atmospheres of High Ambient Density[J]. Fuel， 1962， 41(4): 323-334.
[10] Santoro R J， Anderson W E. Combustion Instability Phenomena of Importance to Liquid Rocket Engines[R]. AD-A284 780， 1994.
[11] 杨立军，富庆飞. 液体火箭发动机推力室设计[M]. 北京: 北京航空航天大学出版社， 2013.
[12] 屈元元. 反压环境下喷注器雾化特性实验研究[D]. 北京:北京航空航天大学， 2011.
[13] Inoue C， Watanabe T， Himeno T. Study on Atomization Process of Liquid Sheet Formed by Impinging Jets[R]. AIAA 2008-4847.
[14] Arienti M， Li X， Soteriou M C， et al. Coupled Level-Set/Volume-of-Fluid Method for the Simulation of Liquid Atomization in Propulsion Device Injectors[R]. AIAA 2010-7136.
[15] Chen X D， Ma D J， Yang V. Mechanism Study of Impact Wave in Impinging Jets Atomization[R]. AIAA 2012-1089.
[16] Chen X D， Ma D J， Yang V. High-Fidelity Numerical Simulations of Impinging Jet Atomization[R]. AIAA 2012-4328.
[17] Chen X D， Yang V. Thickness-Based Adaptive Mesh Refinement Methods for Multi-Phase Flow Simulations with Thin Regions[J]. Journal of Computational Physics， 2014， 269: 22-39.
[18] 郑刚，聂万胜，何博，等. 撞击角对撞击式喷嘴雾化特性影响研究[J]. 推进技术， 2015， 36(4): 608-613.
[19] 郑刚，冯伟，聂万胜，等. 动量比对两股互击式喷嘴雾化特征的影响[J]. 航空动力学报， 2016， 31(9): 2283-2289.
[20] Zheng G， Nie W S， Feng S J， et al. Numerical Simulation of the Atomization Process of a Like-Doublet Impinging Rocket Injector[J]. Procedia Engineering， 2015， 99: 930-938.
[21] 刘昌波，雷凡培，周立新. 两股湍流射流撞击雾化过程的数值研究[J]. 推进技术， 2014， 35(12): 1669-1678.
[22] 强洪夫，刘虎，陈福振，等. 基于SPH方法的射流撞击仿真[J]. 推进技术， 2012， 33(3): 424-429.
[23] 强洪夫，韩亚伟，王广，等. 幂律型流体雾化SPH方法数值分析[J]. 推进技术， 2013， 34(2): 240-247.
[24] 韩亚伟，强洪夫，刘虎. 双股液体射流撞击雾化的SPH方法数值模拟[J]. 工程力学， 2013， 30(3): 17-23.
[25] Wei Q， Liang G Z. Coupled Lagrangian Impingement Spray Model for Doublet Impinging Injectors Under Liquid Rocket Engine Operating Conditions[J]. Chinese Journal of Aeronautics， 2017， 30(4): 1391-1406.
[26] Popinet S. Gerris: A Tree-Based Adaptive Solver for the Incompressible Euler Equations in Complex Geometries[J]. Journal of Computational Physics， 2002， 190(2): 572-600.
[27] Popinet S. An Accurate Adaptive Solver for Surface-Tension-Driven Interfacial Flows[J]. Journal of Computational Physics， 2009， 228(16).
[28] Brackbill J U， Kothe D B， Zemach C A. A Continuum Method for Modeling Surface Tension[J]. Journal of Computational Physics， 1992， 100(2): 335-354.
[29] 阎超，于剑，徐晶磊，等. CFD模拟方法的发展成就与展望[J]. 力学进展， 2011， 41(5): 563-589.
[30] Boris J P， Grinstein E F， Oran E S， et al. New Insights into Large-Eddy Simulation[R]. AD-A 249424, 1992.
[31] Zhang P Y， Wang B. Effects of Elevated Ambient Pressure on the Disintegration of Impinged Sheets[J]. Physics of Fluids， 2017， 29（4）.
[32] Hirt C W， Nichols B D. Volume of Fluid (VOF) Method for the Dynamics of Free Boundaries[J]. Journal of Computational Physics， 1981， 39(1): 201-225.
[33] 张磊. 界面不稳定性的数值模拟[D]. 合肥: 中国科学技术大学， 2003.
[34] Anderson W E， Ryan H M， Santoro R J， et al. Combustion Instability Mechanisms in Liquid Rocket Engines Using Impinging Jet Injectors[R]. AIAA 95-2357.
[35] Jung K， Khil T， Yoon Y. The Breakup Characteristics of Liquid Sheets Formed by Like-Doulbet Injectors[R]. AIAA 2002-4177.
[36] 李佳楠，费俊，杨伟东，等. 直流互击式喷注单元雾化特性准直接数值模拟[J]. 推进技术， 2016， 37(4): 713-725.

背压对撞击式喷嘴雾化特性影响研究

Effects of Backpressure on Atomization Characteristics of Impinging Jet Injector

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价