中心分级燃烧室预燃级的喷雾特性研究

doi:10.13675/j.cnki.tjjs.190372

推进技术 ›› 2020, Vol. 41 ›› Issue (6): 1305-1313.DOI: 10.13675/j.cnki.tjjs.190372

中心分级燃烧室预燃级的喷雾特性研究

傅江坤¹，周建华¹，郭志辉²

1.北京航空航天大学能源与动力工程学院，北京 100191;2.北京航空航天大学能源与动力工程学院航空发动机气动热力国家重点实验室，北京 100191

发布日期:2021-08-15

Experimental Investigation on Pilot Spray Characteristic of Internally-Staged Combustor

1.School of Energy and Power Engineering,Beihang University,Beijing 100191,China;2.National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics,School of Energy and Power Engineering，Beihang University，Beijing 100191，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究典型中心分级燃烧室预燃级的冷态喷雾特性，进行了实验研究。应用相位多普勒粒子分析仪（PDA）测量液滴的直径和速度，应用片光照相得到喷雾照片。实验结果表明：由于受到套筒结构的限制，预燃级喷雾锥角较小，一般在50°～70°，随着燃油流量和空气压降的增加，喷雾锥角增大，燃油分布范围更广，液滴数量增加，直径随之变小。预燃级的中心回流区宽度仅为20mm左右，一直延伸进套筒内，最大回流速度约为10m/s。燃油流量的改变对流场的影响十分微弱，而空气压降的增加能够明显增加流场速度和回流强度，但是工况参数的改变并不会改变回流区位置和流场结构。燃油流量的减小和空气压降的增加都会使雾化索太尔平均直径（SMD）减小，但相比之下，空气压降对雾化水平的影响更大。在各头部空气压降下，雾化SMD随着气液比（ALR）的增加而减小，但随着ALR的继续增加，平均SMD变化曲线变平缓。

关键词: 航空发动机;燃烧室;预燃级;流场;回流区;雾化

Abstract: In order to investigate the pilot spray characteristic, a series of experiment was taken. Phase doppler particle analyzer (PDA) was used to measure size and velocity of droplets. The photos of spray were captured with a light sheet. The results are asconclusion spray corn angle ranged from 50° to 70°, it seemed quite small due to the restriction of sleeve. With increasing fuel mass flow rate or air pressure drop, spray corn angle became larger, and the spray ranged broader. The quantity of droplet increased and drop diameter decreased. The width of the center recirculation zone was merely 20mm, and the maximal recirculate velocity was about 10m/s. Changes of fuel mass flow rate hardly influenced the air flow field while increasing air pressure drop lead to obvious enhance of flow velocity and circulation. However, the position of circulation zone and the structure of flow field did not charge with the variation of the operating conditions. The increase of air pressure drop as well as the decrease of fuel mass flow contributed to the decrease of Sauter mean diameter (SMD), but the changes of air pressure drop mattered more. At a certain air pressure drop, the average SMD decreased with the rising of air-liquid ratio (ALR), however the curve flattened out as the increase of ALR.

Key words: Aero-engine;Combustor;Pilot stage;Flow field;Recirculation zone;Atomization

傅江坤，周建华，郭志辉. 中心分级燃烧室预燃级的喷雾特性研究[J]. 推进技术, 2020, 41(6): 1305-1313.

FU Jiang-kun¹, ZHOU Jian-hua¹, GUO Zhi-hui². Experimental Investigation on Pilot Spray Characteristic of Internally-Staged Combustor[J]. Journal of Propulsion Technology, 2020, 41(6): 1305-1313.

参考文献

[1] Lieuwen T C， Yang V. Gas Turbine Emissions[M]. UK:Cambridge University Press， 2013.
[2] 张弛，林宇震，徐华胜，等. 民用航空发动机低排放燃烧室技术发展现状及水平[J]. 航空学报， 2014， 35(2).
[3] Mongia H C. TAPS-A 4th Generation Propulsion Combustor Technology for Low Emissions[R]. AIAA 2003-2657.
[4] Sulabh K， Hanuka D. Unsteady Aspects of Lean Premixed-Prevaporized (LPP) Gas Turbine Combustors:Flame-Flame Interactions[R]. AIAA 2010-1148.
[5] 张珊珊. 双选预混环流燃烧室优化设计[D]. 北京：北京航空航天大学， 2010.
[6] 李海涛，许全宏，付镇柏，等. 中心分级燃烧室预燃级贫油熄火性能试验[J]. 航空动力学报， 2014， 29(9): 2188-2194.
[7] 付镇柏，林宇震，张弛，等. 中心分级燃烧室预燃级燃烧性能实验[J]. 航空动力学报， 2015， 30(1):46-52.
[8] 肖荣洪，林宇震，张弛. 预燃级旋流数对TeLESSⅡ燃烧室贫油熄火性能影响[J]. 北京航空航天大学学报， 2018， 44(6): 1265-1272.
[9] Wang H Y， McDonell V G， Samuelsen G S. Influence of Hardware Design on the Flow Field Structures and the Pat2 Terns of Droplet Dispersion， Part I:Mean Quantities[J]. Journal of Engineering for Gas Turbines and Power， 1995， 117: 282-289.
[10] 林宇震，刘高恩，王华芳. 反向与同向双旋流器流场的试验研究[J]. 航空动力学报， 1995， 10(4): 423-425.
[11] Im Kyoung-Su， Hoisan Kim， Ming-Chia Lai. Parametric Study of the Swirler/Venturi Spray Injectors[J]. Journal of Propulsion and Power， 2001， 17(3): 717-727.
[12] Park Jong-Hoon， Yoon Youngbin， Jeung In-Seuck. Effect of Swirl Cup on Characteristics of Fuel Spray in Gas Turbine Combustors[R]. AIAA 2000-3352.
[13] Shanmugadas K P， Chakravarthy S R. A Canonical Geometry to Study Wall Filming and Atomization in Pre-Filming Coaxial Swirl Injectors[J]. Proceedings of the Combustion Institution， 2017， 36（2）: 2467-2474.
[14] Han Y M， Seol W S， Lee D S. Effects of Fuel Nozzle Displacement on Pre-Filming Airblast Atomization[J]. Journal of Engineering for Gas Turbines and Power， 2001， 123: 33-40
[15] 彭云晖，林宇震，许全宏，等. 双旋流空气雾化喷嘴喷雾、流动和燃烧性能[J]. 航空学报， 2008， 29（1）：1-14.
[16] Wang H Y， McDonell V G， Samuelsen G S. The Influence of Spray Angle on the Continuous and Discrete-Phase Flow Field Downstream of an Engine Combustor Swirl Cup[C]. Nashville： 28th Joint Propulsion Conference and Exhibit， 1992.
[17] Lefebvre A H. Gas Turbine Combustion [M]. Washington D C: Hemisphere Pub Corp， 1983.
[18] Rizkalla A A， Lefebvre A H. The Influence of Air and Liquid Properties on Airblast Atomization[J]. Journal of Fluids Engineering， 1975， 97(3).

中心分级燃烧室预燃级的喷雾特性研究

Experimental Investigation on Pilot Spray Characteristic of Internally-Staged Combustor

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价