基于粒子群核极限学习机的涡扇发动机加速过程模型辨识

doi:10.13675/j.cnki.tjjs.190586

推进技术 ›› 2020, Vol. 41 ›› Issue (10): 2358-2366.DOI: 10.13675/j.cnki.tjjs.190586

基于粒子群核极限学习机的涡扇发动机加速过程模型辨识

赵姝帆，李本威，钱仁军，朱飞翔

海军航空大学航空基础学院，山东烟台 264001

发布日期:2021-08-15
基金资助:
国家自然科学基金（51505492）；山东省自然科学基金（ZR2016FQ19）；泰山学者建设工程专项经费。

Turbofan Engine Model Identification of Acceleration Process Based on Particle Swarm Optimization Kernel Extreme Learning Machine

Aviation Foundation College，Naval Aeronautical University，Yantai 264001，China

Published:2021-08-15

摘要/Abstract

摘要： 针对解析法建立涡扇发动机加速过程模型精度和实时性不高的问题，提出了一种基于粒子群核极值学习机（PSO-KELM）的涡扇发动机加速过程模型数据驱动辨识方法，构建涡扇发动机加速过程模型，结合加速过程试车数据，利用PSO-KELM方法对该加速模型进行辨识。试验结果表明：低压转子转速、高压转子转速和低压涡轮出口燃气总温都较好地逼近了试车数据，最大相对误差均值分别为1.013%，0.355%和1.055%，平均计算时间为0.04ms。精度和实时性均优于反向传播神经网络和粒子群支持向量回归方法，可用于发动机状态监控和性能优化控制。

关键词: 涡扇发动机;加速过程;核极限学习机;数据驱动;模型辨识

Abstract: In order to solve the problem of low accuracy and real-time in establishing the model of turbofan engine acceleration process by analytic method， a data-driven method on identifying the turbofan engine acceleration process model based on kernel extreme learning machine （KELM） optimized by particle swarm optimization （PSO） was proposed. Firstly， a turbofan engine acceleration process model was constructed. Then， PSO-KELM was adopted to identify the model using engine acceleration process test data. The results show that identification results of the low-pressure rotor speed， the high-pressure rotor speed and the low-pressure turbine outlet gas temperature are all close to measured data， the mean maximum relative errors are 1.013%， 0.355% and 1.055%， respectively， and the mean computing time is 0.04ms. The precision and real-time are better than back propagation （BP） neural network method and PSO-support vector regression （SVR）. This method can be used for engine condition monitoring and performance optimization control.

Key words: Turbofan engine;Acceleration process;Kernel extreme learning machine;Data-driven;Model identification

赵姝帆，李本威，钱仁军，朱飞翔. 基于粒子群核极限学习机的涡扇发动机加速过程模型辨识[J]. 推进技术, 2020, 41(10): 2358-2366.

ZHAO Shu-fan, LI Ben-wei, QIAN Ren-jun, ZHU Fei-xiang. Turbofan Engine Model Identification of Acceleration Process Based on Particle Swarm Optimization Kernel Extreme Learning Machine[J]. Journal of Propulsion Technology, 2020, 41(10): 2358-2366.

参考文献

[1] Liu Y， Litt J S， Guo T H. Design and Demonstration of Emergency Control Modes for Enhanced Engine Performance［C］. San Jose： AIAA/ASME/SAE/ASEE Joint Propulsion Conference， 2013.
[2] 陈玉春，刘振德，袁宁，等. 一种涡轮发动机加速控制规律设计的新方法［J］. 航空学报， 2008， 29（2）.
[3] Litt J S， Frederick D K， Guo T H. The Case for Intelligent Propulsion Control for Fast Engine Response［R］. NASA/TM 2009-215668.
[4] Zheng Q， Zhang H. A Global Optimization Control for Turbo-Fan Engine Acceleration Schedule Design［J］. Proceedings of the Institution of Mechanical Engineers， Part G： Journal of Aerospace Engineering， 2018， 232（2）： 308-316.
[5] Garg S. Propulsion Controls and Diagnostics Research in Support of NASA Aeronautics Research Mission Programs［C］. Nashville： AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit， 2011.
[6] Csank J， Litt J S， Guo T H. Control Design for a Generic Commercial Aircraft Engine［C］. Nashville： AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit， 2010.
[7] Garg S. Propulsion Controls and Health Management Research at NASA Glenn Research Center［R］. NASA/TM 2002-211590.
[8] Zheng Q， Miao L， Zhang H， et al. On-Board Real-Time Optimization Control for Turbofan Engine Thrust under Flight Emergency Condition［J］. Proceedings of the Institution of Mechanical Engineers， Part I： Journal of Systems and Control Engineering， 2017， 231（11）： 554-566.
[9] Mcglynn G E， Litt J S， Lemon K A， et al. A Risk Management Architecture for Emergency Integrated Aircraft Control［R］. NASA/TM， 2011-217143.
[10] Sun F， Miao L， Zhang H. A Study on the Installed Performance Seeking Control for Aero-Propulsion under Supersonic State［J］. International Journal of Turbo & Jet-Engines， 2016， 33（4）： 341-351.
[11] Hussain S， Mokhtar M， Howe J M. Sensor Failure Detection， Identification， and Accommodation using Fully Connected Cascade Neural Network［J］. IEEE Transactions on Industrial Electronics， 2015， 62（3）： 1683-1692.
[12] Vloponi A， Simon D L. Enhanced Self Tuning On-Board Realtime Model （Estorm） for Aircraft Engine Performance Health Tracking［R］. NASA/CR 2008-215272.
[13] Asgari H， Venturini M， Chen X Q， et al. Modeling and Simulation of the Transient Behavior of an Industrial Power Plant Gas Turbine［J］. Journal of Engineering for Gas Turbines and Power， 2014， 136（6）.
[14] Asgari H， Jegarkandi M F， Chen X Q， et al. Design of Conventional and Neural Network Based Controllers for a Single-Shaft Gas Turbine［J］. Aircraft Engineering and Aerospace Technology， 2015， 89（1）： 52-65.
[15] Asgari H， Chen X Q， Menhaj M B， et al. Artificial Neural Network-Based System Identification for a Single-Shaft Gas Turbine［J］. Journal of Engineering for Gas Turbines and Power， 2013， 135（9）.
[16] 尉询楷，李应红，王剑影，等. 基于支持向量机的航空发动机辨识模型［J］. 航空动力学报， 2004， 19（5）： 684-688.
[17] 王海涛，谢寿生，武卫，等. 基于稀疏最小二乘支持向量机的航空发动机动态过程辨识［J］. 航空动力学报， 2010， 25（9）.
[18] 潘鹏飞，马明明，许艳芝. 飞行试验数据驱动的涡扇发动机模型辨识［J］. 燃气涡轮试验与研究， 2016， 29（6）： 21-25.
[19] Zheng Q， Zhang H， Li Y， et al. Aero-Engine On-Board Dynamic Adaptive MGD Neural Network Model Within a Large Flight Envelope［J］. IEEE Access， 2018， 6： 45755 -45761.
[20] 赵姝帆，李本威，宋汉强，等. 基于K-均值聚类与粒子群核极限学习机的推力估计器设计［J］. 推进技术， 2019， 40（2）： 259-266.
[21] Gu B， Sheng V S， Wang Z， et al. Incremental Learning for v-Support Vector Regression［J］. Neural Networks， 2015， 67： 140-150.
[22] Huang G B， Zhu Q Y， Siew C K. Extreme Learning Machine： Theory and Applications［J］. Neurocomputing， 2006， 70（3）： 489-501.
[23] Deng C W， Huang G B， Xu J， et al. Extreme Learning Machines： New Trends and Applications［J］. Science China Information Sciences， 2015， 58（2）： 1-16.
[24] Pei F， Chen X Z， Zhu Y L， et al. Transformer Fault Diagnosis Based on Particle Swarm Optimization and Kernel-Based Extreme Learning Machine［J］. Computer Engineering and Design， 2015， 36（5）： 1327-1331.
[25] Huang G B， Bai Z， Kasun L L C， et al. Local Receptive Fields Based Extreme Learning Machine［J］. IEEE Computational Intelligence Magazine， 2015， 10（2）： 18-29.
[26] Huang G B， Wang D H， Lan Y. Extreme Learning Machines： A Survey［J］. International Journal of Machine Learning and Cybernetics， 2011， 2（2）： 107-122.
[27] Li K， Lei S， Wu J J， et al. A Rolling Bearing Fault Diagnosis Method Based on Variational Mode Decomposition and an Improved Kernel Extreme Learning Machine［J］. Applied Science， 2017， 7（10）.
[28] Chao P， Jia Y， Shukai D， et al. Enhancing Electronic Nose Performance Based on a Novel QPSO-KELM Model［J］. Sensors， 2016， 16（4）： 520-535.
[29] Sun H， Yang J， Wang L. Resistance Spot Welding Quality Identification with Particle Swarm Optimization and a Kernel Extreme Learning Machine Model［J］. International Journal of Advanced Manufacturing Technology， 2016， 91（5）： 1-9.
[30] Lu H， Du B， Liu J， et al. A Kernel Extreme Learning Machine Algorithm Based on Improved Particle Swam Optimization［J］. Memetic Computing， 2016， 9（2）： 1-8.
[31] Zangmolk B R， Khaledi H. Development of an Interactive Code for Design and Off-Design Performance Evaluation of Gas Turbines［C］. Orlando： ASME Turbo Expo 2009： Power for Land， Sea， and Air， 2009.
[32] Asgari H， Chen X Q， Morini M， et al. NARX Models for Simulation of the Start-Up Operation of a Single-Shaft Gas Turbine［J］. Applied Thermal Engineering， 2015， 93： 368-376.

基于粒子群核极限学习机的涡扇发动机加速过程模型辨识

Turbofan Engine Model Identification of Acceleration Process Based on Particle Swarm Optimization Kernel Extreme Learning Machine

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价