高负荷低展弦比氦涡轮端壁损失机理研究

doi:10.13675/j.cnki.tjjs.190772

推进技术 ›› 2021, Vol. 42 ›› Issue (3): 540-549.DOI: 10.13675/j.cnki.tjjs.190772

高负荷低展弦比氦涡轮端壁损失机理研究

隋秀明¹，董甜甜^1,2，周庆晖^1,2，赵巍^1,2，赵庆军^1,2,3

1.中国科学院工程热物理研究所，北京 100190;2.中国科学院大学航空宇航学院，北京 100049;3.中国科学院轻型动力重点实验室，北京 100190

出版日期:2021-03-15 发布日期:2021-08-15
作者简介:隋秀明，博士，助理研究员，研究领域为叶轮机械气动热力学。E-mail：suixiuming@iet.cn
基金资助:
国家重点研发计划项目（2016YFB0901402）；国家自然科学基金（51806214）。

Investigation on Endwall Loss Mechanism of a Highly Loaded Helium Turbine with Low Aspect Ratio

1.Institute of Engineering Thermophysics， Chinese Academy of Sciences，Beijing 100190，China;2.School of Aeronautics and Astronautics，University of Chinese Academy of Sciences，Beijing 100049，China;3.Key Laboratory of Light-Duty Gas-Turbine，Chinese Academy of Sciences，Beijing 100190，China

Online:2021-03-15 Published:2021-08-15

摘要/Abstract

摘要： 为指导高负荷低展弦比氦涡轮设计，以多级氦涡轮第一级为研究对象，借助数值模拟技术对低展弦比涡轮动静叶通道涡迁移机制进行研究，并考察了叶片弯曲对涡轮气动性能的影响。结果表明：受轮毂道涡影响，导叶出口近叶根处气流过偏转，导致转子前缘近轮毂区正攻角变大；叶片根部负荷增大，致使马蹄涡压力面分支与吸力面分支交点前移；轮毂通道涡径向迁移至近叶顶区，其与叶尖泄漏涡相互影响致使叶顶区粘性损失显著增大。弯叶片对低展弦比大折转涡轮叶片的作用效果与传统涡轮具有明显差别：叶片正弯时叶顶负荷减小，导致叶顶间隙泄漏涡与通道涡强度及损失显著下降，涡轮性能得到改善；叶片反弯时叶顶负荷增大，致使叶尖泄漏损失增大，且强径向压力梯度作用下下端壁低能流体向叶顶汇聚，损失显著增大。

关键词: 氦涡轮;高负荷;低展弦比;通道涡;叶片弯曲

Abstract: In order to guide the design of helium turbines with high load and low aspect ratio， the passage vortex migration mechanism of the first stage of a multi-stage helium turbine was numerically analyzed. The effects of bow blades on the aerodynamic performance of the turbine were also studied. The results show that the airflow deflection close to stator root increases， which is due to the influence of the hub passage vortex. It results in the increasing of incidence angles at rotor leading edge close to hub region. The blade load at that region is raised， and then the meeting point of the passage vortex moves close to the rotor leading edge. The hub passage vortex migrates to the blade tip region. The interaction between passage vortex and tip leakage vortex increases flow losses of the tip region. The effects of bow blades on performance of turbine blades with low aspect ratio and large turning angle are significantly different from those of traditional turbines. The positive bow blade reduces the rotor tip loading. The intensity and loss of the tip leakage vortex and passage vortex are decreased， and the turbine performance is improved. The negative bow blade enlarges the rotor tip loading， which increase the loss of the tip leakage flow. The low momentum fluid from the hub region also moves to the blade tip， which caused by larger radial pressure gradient compared with the one of the positive bow blade. The flow losses thus significantly increase and the turbine efficiency deteriorates.

Key words: Helium turbine;High load;Low aspect ratio;Passage vortex;Bow blade

隋秀明，董甜甜，周庆晖，赵巍，赵庆军. 高负荷低展弦比氦涡轮端壁损失机理研究[J]. 推进技术, 2021, 42(3): 540-549.

SUI Xiu-ming¹, DONG Tian-tian^1,2, ZHOU Qing-hui^1,2, ZHAO Wei^1,2, ZHAO Qing-jun^1,2,3. Investigation on Endwall Loss Mechanism of a Highly Loaded Helium Turbine with Low Aspect Ratio[J]. Journal of Propulsion Technology, 2021, 42(3): 540-549.

参考文献

[1] Longstaff R， Bond A. The SKYLON Project［R］. AIAA 2011-2244.
[2] 张志刚，陈静敏，李志永，等. SABRE发动机吸气模式下氦气闭式循环特性分析［J］. 战术导弹技术， 2016，（2）： 57-62.
[3] Paniagua G， Szokol S. Contrarotating Turbine Aerodesign for an Advanced Hypersonic Propulsion System［J］. Journal of Propulsion and Power， 2008， 24（6）： 1269-1277.
[4] Sozio E， Verstraete T， Paniagua G. Design-Optimization Approach to Multistage Axial Contra-Rotating Turbines［R］. ASME GT-2013-94762.
[5] Varvill R， Paniagua G， Kato H， et al. Design and Testing of the Contra-Rotating Turbine for the Scimitar Precooled Mach 5 Cruise Engine［J］. Journal of the British Interplanetary Society， 2009， 62： 225-234.
[6] Hee C N， Ji H K， Hyeun M K. A Review of Helium Gas Turbien Technology for High-Temperature Gas-Cooled Reactors［J］. Nuclear Engineering and Technology， 2007， 39（1）： 21-30.
[7] 李东，马云翔，梁晨，等. 高温气冷堆氦气涡轮三维气动性能分析［J］. 哈尔滨工程大学学报， 2011， 32（5）： 683-689.
[8] 周佳慧. 高温气冷堆氦气轮机基本特性的研究［D］. 哈尔滨：哈尔滨工程大学， 2006.
[9] 王仲奇，韩万金，徐文远. 在低展弦比透平静叶栅中叶盘的弯曲作用［J］. 工程热物理学报， 1990， 11（3）： 255-262.
[10] 谭青春，张华良，韩万金，等. 采用弯叶片控制高负荷涡轮叶栅内附面层迁移的机理分析［J］. 热能动力工程， 2009， 24（6）： 700-704.
[11] Havakechian S， Denton J. Stacking Strategies and Understanding of Flow Physics in Low-Pressure Steam Turbine， Part I： Three-Dimensional Stacking Mechanisms［J］. Journal of Engineering for Gas Turbines and Power， 2016， 138（5）.
[12] Shi J， Han J Y， Zhou S Y， et al. An Investigation of a Highly Loaded Transonic Turbine Stage with Compound Leaned Vanes［J］. Journal of Engineering for Gas Turbines and Power， 1986， 108（2）： 265-269.
[13] Schobeiri M T， Suryanarayanan A， Jermann C. A Comparative Aerodynamic and Performance Study of a Three Stage High Pressure Turbine with 3-D Bowed Blades and Cylindrical Blades［R］. ASME GT-2004-95365.
[14] 袁宁，郑严，于守志. 提高航空发动机性能的弯扭导向器技术［J］. 推进技术， 2001， 22（6）： 458-463.
[15] 石靖，韩鉴元. 小发动机涡轮的气动设计问题［J］. 航空动力学报， 1991， 6（1）： 29-32.
[16] 韩俊，温风波，赵广播. 小展弦比涡轮叶片的弯曲优化设计［J］. 清华大学学报， 2014， 54（1）： 16-21.
[17] 谢婕，夏晨，张远森，等. 低展弦比微型轴流涡轮弯叶片设计［J］. 南京航空航天大学学报， 2015， 47（1）： 160-166.
[18] Tan C Q， Yamamoto A. Influences of Blade Bowing on Flowfields of Turbine Stator Cascades［J］. AIAA Journal， 2003， 41（10）： 1697-1972.
[19] Bohn D E， Ren J， Tummers C. Unsteady 3D-Numerical Investigation of the Influence of the Blading Design on the Stator-Rotor Interaction in a 2-Stage Turbine［R］. ASME GT 2005-68115.
[20] Wingehofer F， Haselbacher H. New Optimization Criteria for the Design of Three-Dimensional Bladings Applied to Compound Lean Nozzles of an Axial Turbines［R］. ASME GT 2004-53830.
[21] Rosic B， Xu L P. Blade Lean and Shroud Leakage Flows in Low Aspect Ratio Turbines［J］. Journal of Turbomachinery， 2012， 134（3）.

高负荷低展弦比氦涡轮端壁损失机理研究

Investigation on Endwall Loss Mechanism of a Highly Loaded Helium Turbine with Low Aspect Ratio

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价