火焰筒掺混孔边裂纹萌生和扩展机理研究

推进技术 ›› 2006, Vol. 27 ›› Issue (1): 74-78.

火焰筒掺混孔边裂纹萌生和扩展机理研究

耿小亮,张克实,郭运强,秦亮,卫宝华

西北工业大学工程力学系;陕西西安710072;西北工业大学工程力学系;陕西西安710072;西北工业大学工程力学系;陕西西安710072;西北工业大学工程力学系;陕西西安710072;沈阳黎明航空发动机集团公司辽宁沈阳110000

发布日期:2021-08-15
基金资助:
航空基础科学基金(04C53027);西北工业大学青年创新基金(M016202)

Study on initiation and propagation mechanism of crack on dilution hole edge in combustor liner

Dept.of Engineering Mechanics,Northwestern Polytechnical Univ.,Xi’an 710072,China;Dept.of Engineering Mechanics,Northwestern Polytechnical Univ.,Xi’an 710072,China;Dept.of Engineering Mechanics,Northwestern Polytechnical Univ.,Xi’an 710072,China;Dept.of Engineering Mechanics,Northwestern Polytechnical Univ.,Xi’an 710072,China;LiMing Aero-Engine Group Corporation,Shenyang 110000,China

Published:2021-08-15

摘要/Abstract

摘要： 利用有限元法,结合瞬态传热过程研究了火焰筒掺混孔内孔边裂纹形成和扩展机理,应用应变疲劳理论和裂纹扩展分析方法对裂纹萌生时间和扩展能力进行分析。由于火焰筒在热循环载荷作用下各处升温速度不一致,引起结构上的相互约束,使掺混孔边产生循环塑性变形导致疲劳裂纹萌生;裂纹萌生后会继续扩展,但这种扩展能力有限;孔边冷却区域大小会对裂纹扩展能力产生较大影响。

关键词: 火焰筒+;掺混孔+;瞬态传热+;裂纹

Abstract: Using the finite element method(FEM),theory of strain fatigue and stress intensity factor(K),the crack initiation and propagation were analyzed.The rate of temperature rising on liner structure is not uniform under thermal cycling,which leads to mutual restraints inside of the liner and plastic strain cycling near the dilution hole,then the initial crack is generated following thermal cycles.The crack can grow gradually,but the ability of growth is limited and affected obviously by the size of cooling field around the hole.

Key words: Combustor liner~+;Dilution hole~+;Transient heat transfer~+;Crack

耿小亮,张克实,郭运强,秦亮,卫宝华. 火焰筒掺混孔边裂纹萌生和扩展机理研究[J]. 推进技术, 2006, 27(1): 74-78.