高超侧压进气道前/后掠的数值分析和比较

推进技术 ›› 2007, Vol. 28 ›› Issue (1): 65-67.

高超侧压进气道前/后掠的数值分析和比较

李桦,贾地,范晓樯,李晓宇

国防科技大学航天与材料工程学院湖南长沙410077;国防科技大学航天与材料工程学院湖南长沙410078;国防科技大学航天与材料工程学院湖南长沙410079;国防科技大学航天与材料工程学院湖南长沙410080

发布日期:2021-08-15
基金资助:
国家“八六三”计划资助项目(2005AA723042)

Calculation and comparison of forward/backward swept sidewall compression scramjet inlets

Inst.of Aerospace and Material Engineering,National Univ.of Defence Technology,Changsha 410077,China;Inst.of Aerospace and Material Engineering,National Univ.of Defence Technology,Changsha 410078,China;Inst.of Aerospace and Material Engineering,National Univ.of Defence Technology,Changsha 410079,China;Inst.of Aerospace and Material Engineering,National Univ.of Defence Technology,Changsha 410080,China

Published:2021-08-15

摘要/Abstract

摘要： 侧板构型和唇口位置是影响侧压式进气道性能的关键参数。选取了5个具有一定代表性的状态点对前/后掠进气道模型进行了计算和分析,重点比较了当侧板前/后掠时进气道的流量系数、压升、出口气流均匀度等性能。通过对比分析,发现侧板前掠时进气道的流量系数、压升大于侧板后掠结果,且进气道出口流场更均匀。当马赫数较低时,前/后掠进气道性能差别比较明显:同为50%溢流窗,来流马赫数4时,侧板前掠的进气道流量系数比侧板后掠的情形高出7.7%;而当来流马赫数为8.09时,侧板前掠的进气道流量系数仅高2.6%。

关键词: 高超声速进气道;侧压+;前/后掠+;数值仿真

Abstract: Configurations of sidewall and location of cowl have significant influence on the performance of sidewall-compression scramjet inlets.A series of numerical simulation are completed with the variation of flight height,Mach number and cowl position for forward and backward swept sidewall compression inlets.Compared with backward swept sidewall compression inlets,inlets with forward leading edges display better performances,demonstrated by higher mass capture ratio and static pressure raise,as well as more uniform out-let flow field.The results indicate that the differences are more obvious at low flight Mach number when the cowl is backward located.Mass capture ratio of forward-swept inlet is 7.7% higher than that of backward-swept inlet at Ma 4;however,the difference decrease to 2.6% when the inflow Mach number increases to Ma 8.

Key words: Hypersonic inlet;Sidewall compression;Forward/backward;Numerical simulation

李桦,贾地,范晓樯,李晓宇. 高超侧压进气道前/后掠的数值分析和比较[J]. 推进技术, 2007, 28(1): 65-67.