固体火箭发动机多层粘接结构超声图像诊断

推进技术 ›› 2008, Vol. 29 ›› Issue (1): 13-17.

固体火箭发动机多层粘接结构超声图像诊断

张吉堂,路宏年,曹付齐

中北大学机械工程与自动化学院山西太原030051;北京航空航天大学机械工程及自动化学院北京100083;中国空空导弹研究院河南洛阳471039

发布日期:2021-08-15

Ultrasonic image diagnoses for multi-layered adhesive structure in solid rocket motor

School of Mechanical Engineering and Automation,North Univ.of China,Taiyuan 030051,China;School of Mechanical Engineering and Automation,Beijing Univ.of Aeronautics and Astronautics,Beijing 100083,China;Air-to-Air Missiles Academy of China,Luoyang 471039,China

Published:2021-08-15

摘要/Abstract

摘要： 针对固体火箭发动机的钢壳、绝热层、衬层、推进剂多层粘接结构的粘接质量检测问题,利用聚焦探头采用斜声束液浸反射回波法,选用往返透射率高的板波模式,特别是采用了双模式检测技术以提高检测信号能量,获得有效检测信号,并开发出了检测系统。通过一次C扫描获得了双层包覆三个界面粘接质量诊断图像,其脱粘检测分辨率≤Φ5 mm。采用聚集探头双模式检测技术实现了固体火箭发动机多层粘接结构超声图像诊断。

关键词: 固体推进剂火箭发动机;超声波分析;多层结构+;粘接缺陷;超声成像;无损检验

Abstract: Oblique ultrasonic pulse echo method with focused probe in immersion was used to inspect the adhesive quality in multi-layered structure,which consists of steel shell,insulation layer,liner and propellant for the solid rocket motor.The mode of Lamb wave with the largest out and home transmission coefficient was selected.Double mode testing technique was introduced to increase testing signal energy and obtain effective signals.The test system has been developed.Three interfaces diagnoses images on adhesive quality and thickness image were achieved by a C-scan and the resolution for inspecting debending area is less than 5 mm.Ultrasonic image diagnoses for multi-layered adhesive structure in solid rocket motor is achieved with double mode testing technique with focused probe.

Key words: Solid propellant rocket engine;Ultrasonic analysis;Multi-layer structure+;Bonding defect;Ultrasonic imaging;Nondestructive testing

张吉堂,路宏年,曹付齐. 固体火箭发动机多层粘接结构超声图像诊断[J]. 推进技术, 2008, 29(1): 13-17.