推进技术 ›› 2009, Vol. 30 ›› Issue (2): 219-223.

• • 上一篇    下一篇

引射器轴向位置对PDE的性能影响实验

黄希桥,严传俊,邓君香,范玮,王治武   

  1. 西北工业大学动力与能源学院;西北工业大学动力与能源学院;广州民航职业技术学院机务工程系;西北工业大学动力与能源学院;西北工业大学动力与能源学院
  • 发布日期:2021-08-15
  • 基金资助:
    国家自然科学基金(50336030;50106012);教育部优秀青年教师资助计划和新世纪优秀人才计划基金(NCET-04-0960)

Effect of ejector axial position on performance of pulse detonation engine

  1. School of Power and Energy,Northwestern Polytechnical Univ.,Xi’an 710072,China;School of Power and Energy,Northwestern Polytechnical Univ.,Xi’an 710073,China;Aircraft Maintenance Engineering Dept.,Guangzhou Civil Aviation Coll.,Guangzhou 510403,China;School of Power and Energy,Northwestern Polytechnical Univ.,Xi’an 710075,China;School of Power and Energy,Northwestern Polytechnical Univ.,Xi’an 710076,China
  • Published:2021-08-15

摘要: 根据脉冲爆震发动机(PDE)工作特点为其设计了6组不同结构的圆柱型引射器,并针对各种结构引射器,采用力传感器法对不同轴向位置处引射器的增推性能进行了实验研究,实验采用汽油为燃料,空气为氧化剂。实验结果发现,轴向位置对引射器的增推性能有非常明显的影响,当引射器入口正好位于脉冲爆震发动机出口处(0点)或位于下游1/2倍脉冲爆震发动机直径处时,系统会出现一个至少高于35%的推力增益点,但是当引射器入口从该点继续远离发动机出口位置时,推力将会急剧地下降;当引射器从0点逐渐向上游移动时,引射器的推力增益呈先下降后上升再下降的趋势,最高推力增益可达80.5%。

关键词: 脉冲爆震发动机;引射器轴向位置;推力增益;实验研究

Abstract: Six rounded straight ejectors with distinct inlet contour and different diameter were designed based on the operational principle of pulse detonation engine(PDE).A preliminary experimental investigation of the different construction ejectors on a multi-cycle pulse detonation engine tube was performed using gasoline as fuel and air as oxidizers,and the thrust augmentation was measured by thrust transducer for different ejectors axial position.Performance measurements of the PDE-ejector system show that the thrust augmentation is a strong function of the ejector axial position.Thrust augmentations of more than 35% are obtained when the axial location is 0 or 0.5,but decrease drastically with ejector moving downstream.The thrust augmentations decrease at beginning and increase next,but decrease finally when ejector is moved upstream from 0 position.Peak thrust augmentation level is recorded to be approximately 80.5% at upstream position.

Key words: Pulse detonation engine;Ejector axial position;Thrust augmentation;Experimental study