用于单晶叶片应力分析的滑移本构模型

推进技术 ›› 2012, Vol. 33 ›› Issue (5): 754-759.

用于单晶叶片应力分析的滑移本构模型

孙万超,陆山

西北工业大学动力与能源学院,陕西西安 710072;西北工业大学动力与能源学院,陕西西安 710072

发布日期:2021-08-15
作者简介:孙万超(1985—),男,博士生,研究领域为航空发动机结构强度、寿命及可靠性。E-mail: sdswc521@163.com

Analysis on the Crystallographic Slip Constitutive Models for Single Crystal Turbine Blade

School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China;School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China

Published:2021-08-15

摘要/Abstract

摘要： 为了建立适用于镍基单晶涡轮叶片的有限元分析平台,基于有限变形晶体滑移理论和有限元软件ANSYS接口参数要求,导出了增量型本构方程公式。采用变刚度法,以切线系数法为初值,采用局部牛顿拉弗森迭代解法,编制了晶体弹塑性滑移本构模型程序,并以子程序Usermat的形式植入ANSYS软件。计算模拟了DD3试棒不同取向的单向拉伸和循环应力应变过程,讨论了〈011〉方向上的应变软化行为和该本构模型对DD3镍基单晶涡轮叶片的良好应用性。数值仿真结果与实验数据对比吻合良好,验证了程序的正确性。

关键词: 晶体滑移;切线系数法;牛顿拉弗森迭代;弹塑性本构;正交各向异性;镍基单晶合金

Abstract: Based on the dislocation slip theory and the requirement of finite element software ANSYS interface parameters, the incremental constitutive equation formula was derived. On account of variable stiffness matrix method, the program of the crystallographic slip constitutive models was compiled, using the Newton-Raphson iterative method with the result of tangent modulus method as the initial value. The program was implanted into ANSYS in the form of subroutine-usermat, and the engineering application platform was built. Stretching in different orientations and cyclic stress-strain of the DD3 test specimens were simulated. The strain softening behavior in the 〈011〉 direction and the application of this constitutive model in DD3 nickel-based single crystal turbine blade were discussed. The simulating results match with the experimental data well, which certifies the accuracy of the program.

Key words: Crystal slip; Tangent modulus method; Newton-Raphson iterative method; Constitutive laws for elastic-plastic; Orthotropic; Single crystal nickel base superalloy

孙万超,陆山. 用于单晶叶片应力分析的滑移本构模型[J]. 推进技术, 2012, 33(5): 754-759.

参考文献

[2] 万建松.有限变形晶体塑性滑移理论单晶力学行为的研究 [D].西安:西北工业大学,2003.
[3] Arakere N K, Swanson G.Effect of Crystal Orientation on Fatigue Failure of Single Crystal Nickel Base Turbine Blade Superalloys [J].ASME Journal of Engineering for Gas Turbines and Power, 2,4(1):161-176.
[4] Arakere N K.High-Temperature Fatigue Properties of Single Crystal Superalloys in Air and Hydrogen [J].ASME Journal of Engineering for Gas Turbines and Power, 4,6(3):590-603.
[5] Rajiv A Naik, Daniel P Deluca, Dilip M Shah.Critical Plane Fatigue Modeling and Characterization of Single Crystal Nickel Superalloys [J].ASME Journal of Engineering for Gas Turbines and Power, 4,6(2):391-400.
[6] 丁智平.复杂应力状态下镍基单晶高温合金低周疲劳损伤研究 [D].长沙:中南大学,2005.
[7] Taylor G I, Elam C F.The Distortion of an Aluminum Crystal During a Tensile Test [J].Proceedings of the Royal Society, 3,2(719):643-667.
[8] Taylor G I, Elam C F.The Plastic Extension and Fracture of Aluminum Crystals [J].Proceedings of the Royal Society, 5,8(745):25-51.
[9] Taylor G I.The Mechanism of Plastic Deformation of Crystals Part I Theoretical [J].Proceedings of the Royal Society, 4,5(855):362-387.
[10] Taylor G I.Plastic Strain in Metals [J].Journal Institute of Metals, 8,2(10):307-324.
[11] Hill R.Generalized Constitutive Relations for Incremental Deformation of Metals Crystals by Multislip [J]. Journal of the Mechanics and Physics of Solids, 6,4(2):95-102.
[12] Hill R, Rice J R.Constitutive Analysis of Elastic-Plastic Crystals at Arbitrary Strain [J].Journal of the Mechanics and Physics of Solids, 2,0(6):401-413.
[13] Rice J R.On the Structure of Stress- Strain Relations for Time-Dependent Plastic Deformation in Metals [J].ASME Journal of Applied Mechanics, 0,7(3):728-738.
[14] Rice J R.Inelastic Constitutive Relations for Solids:an Internal- Variable Theory and Its Application to Metal Plasticity [J].Journal of the Mechanics and Physics of Solids, 1,9(6):433-455.
[15] Asaro R J, Rice J R.Strain Localization in Ductile Single Crystals [J].Journal of the Mechanics and Physics of Solids, 7,5(5):309-338.
[16] Hutchinson J W, Wu T Y.Advances in Applied Mechanics V23 [M].New York:Elsevier, 1983.
[17] Asaro R J.Crystal Plasticity [J].ASME Journal of Applied Mechanics, 3,0(4b):921-934.
[18] Peirce D, Asaro R J, Needleman A.An Analysis of Nonuniform and Localized Deformation in Ductile Single Crystals [J].Acta Metallurgica, 2,0(6):1087-1119.
[19] Peirce D, Asaro R I, Needleman A.Material Rate Dependence and Localized Deformation in Crystalline Solids [J]. Acta Metallurgica, 3,1(12):1951-1976.
[20] Peirce D, Shih C F, Needleman A.A Tangent Modulus Method for Rate Dependent Solids[J].Computers & Structures, 4,8(5):875-887.
[21] 欧阳杰,聂玉峰,车刚明,等.数值分析 [M].北京:高等教育出版社,2009.