推进技术 ›› 2013, Vol. 34 ›› Issue (10): 1316-1320.

• 气动热力学 • 上一篇    下一篇

高超声速进气道前缘钝度效应试验研究

张红军,沈 清   

  1. 中国航天空气动力技术研究院,北京 100074;中国航天空气动力技术研究院,北京 100074
  • 发布日期:2021-08-15
  • 作者简介:张红军(1976—),男,硕士,高级工程师,研究领域为流体力学计算及试验。E-mail:zhhj76529@sina.com
  • 基金资助:
    航天技术自主研发基金;国家自然科学基金(90816026)。

Experimental Studies of Leading Edge Bluntness Effects on Hypersonic Inlet

  1. China Academy of Aerospace Aerodynamics,Beijing 100074,China;China Academy of Aerospace Aerodynamics,Beijing 100074,China
  • Published:2021-08-15

摘要: 基于一种典型高超声速二元进气道,考察前缘钝度效应对进气道边界层转捩的影响,加工了四种半径为R=0.05mm,R=0.1mm ,R=0.2mm,R =0.25mm的前缘,在FD-07风洞中开展了自然转捩及人工转捩的风洞试验。试验中采用压缩拐角压力分布特征及进气道起动相结合的方法来估计边界层转捩位置,得出了进气道压缩面边界层转捩位置随前缘半径变化的规律。试验表明在来流条件下随前缘钝化半径增加,边界层转捩位置明显后移。针对R=0.25mm时进气道不起动的情况,基于 线性稳定性理论(LST)理论设计了人工转捩条带,通过试验成功实现了转捩。 

关键词: 高超声速进气道;钝度效应;边界层转捩 

Abstract: The leading edge bluntness effects on inlet boundary layer transition were studied based on a typical two dimensional hypersonic inlet. Four models of different leading edge radius(R=0.05mm,R=0.1mm,R=0.2mm,R=0.25mm) were studied in FD-07wind tunnel, including natural transition and artificial transition. The location of boundary layer transition was identified through the corner pressure distribution characteristics and inlet starting, the rule of boundary layer transition position with the variation of leading edge radius was obtained. Results show that, under the wind tunnel condition, the boundary layer transition position moves down stream with increasing the leading edge radius. The inlet will not start when the leading edge radius R=0.25mm.By designing artificial transition strips based on linear stability theory (LST) theory, the inlet is started successfully. 

Key words: Hypersonic inlet;Bluntness effect;Boundary layer transition