激光功率密度对纳秒激光烧蚀冲量耦合影响的数值模拟

推进技术 ›› 2013, Vol. 34 ›› Issue (10): 1426-1431.

激光功率密度对纳秒激光烧蚀冲量耦合影响的数值模拟

常浩¹,金星²,叶继飞²,周伟静²

装备学院研究生院, 北京怀柔 101416;装备学院激光推进及其应用国家重点实验室,北京怀柔 101416;装备学院激光推进及其应用国家重点实验室,北京怀柔 101416;装备学院激光推进及其应用国家重点实验室,北京怀柔 101416

发布日期:2021-08-15
作者简介:常浩(1987—),男,博士生,研究领域为激光推进应用基础。E-mail:changhao5976911@163.com
基金资助:
国家自然科学基金(11102234)。

Numerical Simulation of Laser Power Density Effect on Nanosecond Laser Ablation Impulse Coupling

Postgraduate School, Academy of Equipment, Beijing 101416,China;State key Laboratory of Laser Propulsion & Application, Academy of Equipment, Beijing 101416,China;State key Laboratory of Laser Propulsion & Application, Academy of Equipment, Beijing 101416,China;State key Laboratory of Laser Propulsion & Application, Academy of Equipment, Beijing 101416,China

Published:2021-08-15

摘要/Abstract

摘要： 为研究激光功率密度对纳秒激光烧蚀冲量耦合影响,建立了一个复杂的一维热传导和流体动力学模型。以空间碎片常见材料Al为例,用建立的物理模型数值计算了纳秒脉宽激光烧蚀产生的冲量随时间变化情况,数值结果和已有的实验数据符合较好。数值计算表明:辐照的激光功率密度越高,发生等离子体屏蔽时间越早,等离子体屏蔽越明显,能量利用率越低；随着激光功率密度的逐渐增大,获得的冲量逐渐趋于稳定,冲量耦合系数降低,数值计算结果与Phipps的最优能量耦合规律一致。 

关键词: 激光烧蚀;冲量耦合;激光功率密度;数值模拟;空间碎片 

Abstract: To investigate the effects of different laser power density on impulse generation of laser ablation target, a comprehensive model including one-dimensional heat conduct and fluid dynamics was developed. The target Al, the most common space debris material, was used based on the built numerical model in the calculation of nanosecond laser ablation impulse as a function of time. The numerical results agree well with experimental data available. Numerical simulations show that, the higher the laser power density is, the earlier the plasma shielding will turn up and the more obvious the plasma shielding effect will be. This may lead to a lower energy utilization. With the increase of laser power density, the gained impulse tends to be stabe and the impulse coupling coefficient decreases. The results are consistent with the optimum energy coupling theory derived by Phipps. 

Key words: Laser ablation; Impulse coupling; Laser power density; Numerical simulation; Space debris

常浩,金星,叶继飞,周伟静. 激光功率密度对纳秒激光烧蚀冲量耦合影响的数值模拟[J]. 推进技术, 2013, 34(10): 1426-1431.

CHANG Hao¹, JIN Xing², YE Ji-fei², ZHOU Wei-jing². Numerical Simulation of Laser Power Density Effect on Nanosecond Laser Ablation Impulse Coupling[J]. Journal of Propulsion Technology, 2013, 34(10): 1426-1431.

参考文献

[1] Campbell J W.Project Orion:Orbital Debris Removal Using Ground-Based Sensors and Lasers[R].NASA Technical Memorandum 1996-108522.
[2] Phipps C, Albrecht G, Friedman H, et al.Orion:Clearing Near-Earth Space Debris Using a 20-kW, 530-nm, Earth-Based,Repetitively Pulse Laser[J].Laser and particle beams, 1996,(1):1-44.
[3] Rubenchik A, Barty C, Beach R, et al.Laser Systems for Space Orbital Debris removal[R].LLNL 2010-423323.
[4] Early J, Bibeau C, Phipps C, et al.Space Debris De-Orbiting by Vaporization Impulse Using Short Pulse Laser[C].Taos, NM, United States:SPIE, 2004:441-449.
[5] Bruno Esmiller, Christophe Jacquelardb.Cleanspace ‘Small Debris Removal By Laser Illumination and Complementary Technologies’[C].Sendai:Beamed Energy Propulsion, AIP Conference, 2011:347-353.
[6] 金星, 洪延姬, 李修乾.cm级空间碎片的激光清除过程分析[J].强激光与粒子束, 2012,4(2):281-284.
[7] 金星, 常浩, 洪延姬, 等.激光辐照不规则空间碎片冲量矢量计算[J].强激光与粒子束, 2012,4(8):1956-1960.
[8] 常浩,金星, 洪延姬, 等.地基激光清除空间碎片过程建模与仿真[J].航空学报, 2012,3(6):984-993.
[9] Phipps C R, Luke J R, Lippert T, et al.Micropropulsion using Laser Ablation[J].Applied Physics A, 2004,(79):1385-1389.
[10] Takeharu Sakai.Impuluse Generation on Aluminum Target Irradiated with Nd:YAG Laser Pulse in Ambient Gas[J].Journal of Propulsion and Power, 2009,5(2):406-414.
[11] Zhaoyang Chen, Annemie Bogaerts.Laser Ablation of Cu and Plume Expansion into 1atm Ambient Gas[J].Journal of Applied Physics, 2005,7:97-109.
[12] 童惠峰,唐志平,张凌.烧蚀模式激光推进的数值模拟[J].爆炸与冲击,2007,7(2):165-170.
[13] 张凌,童惠峰,唐志平.激光推进中激光波长对推进效应的影响[J].推进技术,2007,8(5):581-585.(ZHANG Ling, TONG Hui-feng, TANG Zhi-ping.Effects of Laser Wavelength on Laser Propulsion Characteristics for Laser Propulsion[J].Journal of Propulsion Technology,2007,8(5).)
[14] 吴东江, 许媛, 尹波, 等.激光功率密度对Ge烧蚀蒸气动力学特性的影响[J].中国激光, 2008,5(3):462-465.
[15] 许媛, 吴东江, 刘悦.脉冲激光烧蚀Ge产生等离子体特性的数值模拟[J].强激光与粒子束,2007,9(9):1561-1566.
[16] Kohei Anju, Keisuke Sawada, Akihiro Sasoh, et al.Time-Resolved Measurements of Impulse Generation in Pulsed Laser-Ablative Propulsion[J].Journal of Propulsion and Power, 2008,4(2):322-329.
[17] Madhusudhan Kundrapu, Michael Keidar.Laser Ablation of Metallic Targets with High Fluences:Self-Consistent Approach[J].Journal of Applied Physics, 2009,5:105-113.
[18] Gusarov A V, Gnedovets A G, Smurov I.Gas Dynamics of Laser Ablation:Influence of Ambient Atmosphere[J].Journal of Applied Physics, 2000,8(7):43-47.
[19] Bogaerts A, Zhaoyang Chen, Renaat G,et al.Laser Ablation for Analytical Sampling:What Can We Learn from Modeling[J].Spectro Chimica Acta, 2003,8:1867-1893.
[20] Saravanakanthan Rajendran, Michael Keidar, Iain D Boyd.Ablation and Plasma Formation Due to Laser Irradiance[C].Miami, FL, United States:38th AIAA Plasmadynamics and Lasers Conference, 2007.
[21] Phipps C, Birkan M, Eckel H A, et al.Review:Laser-Ablation Propulsion[J].Journal of Propulsion and Power, 2010,6(4):609-637.