端壁附面层抽吸对大转角扩压叶栅旋涡影响的实验研究

推进技术 ›› 2013, Vol. 34 ›› Issue (11): 1466-1473.

端壁附面层抽吸对大转角扩压叶栅旋涡影响的实验研究

郭爽¹,陆华伟²,宋彦萍³,吴锤结¹

大连理工大学航空航天学院/工业装备结构分析国家重点实验室,辽宁大连 116024;大连海事大学轮机学院,辽宁大连 116026;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150001;大连理工大学航空航天学院/工业装备结构分析国家重点实验室,辽宁大连 116024

发布日期:2021-08-15
作者简介:郭爽 (1982—),女,博士,讲师,研究领域为叶轮机械气动力学。E-mail:sguo@dlut.edu.cn
基金资助:
国家自然科学基金(51206013); 辽宁省博士启动基金(20131020)；中国博士后科学基金(2013M540223)。

Experimental Investigation on Effects of Endwall Boundary Layer Suction on Vortexes of High-Turning Compressor Cascades

State Key Laboratory of Structural Analysis for Industrial Equipment, School of Aeronautics and Astronautics, Dalian University of Technology, Dalian 116024, China;Marine Engineering College, Dalian Maritime University, Dalian 116024, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;State Key Laboratory of Structural Analysis for Industrial Equipment, School of Aeronautics and Astronautics, Dalian University of Technology, Dalian 116024, China

Published:2021-08-15

摘要/Abstract

摘要： 为探明附面层抽吸技术对压气机叶栅气动性能的影响及其与栅内旋涡结构的关联,通过十个横截面的实验测量结果研究了高负荷压气机叶栅抽吸端壁附面层前后的主要旋涡结构以其对应损失的演变过程。研究对象为矩形低速扩压叶栅,来流马赫数约为0.23。研究结果表明,端壁附面层的变化对叶栅端区的主要旋涡发展过程影响显著。在原型方案中,壁面涡、尾缘脱落涡的演变过程对应着较高的流动损失,通道涡自身产生的损失较小,主要起到向远离端壁的方向输运低能流体的作用；在流向槽吸气方案中,壁面涡和尾缘脱落涡因端壁附面层径向迁移及角区分离受到抑制而被明显削弱；而来流附面层抽吸方案则最为有效地控制了通道涡的演变过程。 

关键词: 大转角扩压叶栅;附面层抽吸;二次流动;旋涡结构;流动损失;抽吸位置 

Abstract: This paper presents results of experimental investigations carried out to explore the effects of endwall boundary layer suction on principal vortices and the performance of high-turning compressor cascades. Section measurements were conducted at ten different axial positions distributed from upstream to downstream of the rectangular cascade. The inlet Mach number is about 0.23. Experimental results demonstrate that the evolution of majority vortices in the endwall region is sensitive to the variation of endwall boundary layer. The wall vortex and the trailing edge vortex contribute much in cascade losses, while the passage vortex which transfers low energy fluid away from the endwall only produces a small amount of loss in the original scheme. The shedding vortex is obviously suppressed in the streamwise suction slot schemes as both the secondary transition of endwall boundary layer and corner region separation are under control. The development of passage vortex is most effectively controlled in the suction scheme which transfers part of inlet boundary layer away from the cascade. 

Key words: High-turning compressor cascade; Boundary layer suction; Secondary flow; Vortex structure; Flow loss; Suction position

郭爽,陆华伟,宋彦萍,吴锤结. 端壁附面层抽吸对大转角扩压叶栅旋涡影响的实验研究[J]. 推进技术, 2013, 34(11): 1466-1473.

GUO Shuang¹, LU Hua-wei², SONG Yan-ping³, WU Chui-jie¹. Experimental Investigation on Effects of Endwall Boundary Layer Suction on Vortexes of High-Turning Compressor Cascades[J]. Journal of Propulsion Technology, 2013, 34(11): 1466-1473.

参考文献

[1] Kerrebrock J L, Reijnen D P, Ziminsky W S, et al.Aspirated Compressors[R].ASME 97-GT-525.
[2] Schuler B J, Kerrebrock J L, Merchant A A, et al.Design, Analysis, Fabrication and Test of an Aspirated Fan Stage[R].ASME 2000-GT-618.
[3] Schuler B J.Experimental Investigation of an Aspirated fan Stage[D].UK:MIT, Cambridge, MA., 2001.
[4] Merchant A A, Drela M, Kerrebrock J L, et al.Aerodynamic Design and Analysis of a High Pressure Ratio Aspirated Compressor Stage[R].ASME 2000-GT-619.
[5] Merchant A A..Aerodynamic Design and Performance of Aspirated Airfoils[R].ASME 2002-GT-30369.
[6] 周杨, 邹正平, 刘火星, 等.边界层吹吸气对高负荷扩压叶栅性能的影响[J].推进技术,2007,8(6):647-652.(ZHOU Yang, ZOU Zheng-ping, LIU Huo-xing, et al.Effects of Co-Flow Jets in Boundary Layer on Highly-Loaded Compressor Cascade Performance[J].Journal of Propulsion Technology, 2007,8(6):647-652.)
[7] 刘波, 项效镕, 南向谊, 等.附面层抽吸对叶栅表面分离流动控制的实验研究[J].推进技术,2009,0(6):703-708.(LIU Bo, XIANG Xiao-rong, NAN Xiang-yi, et al.Experimental Investigation for Suppression Boundary Layer Separation on Cascade Surface by BLS[J].Journal of Propulsion Technology, 2009,0(6):703-708.)
[8] 王掩刚, 牛楠, 赵龙波, 等.端壁抽吸位置对压气机叶栅角区分离控制的影响[J].推进技术,2010,1(4):433-437.(WANG Yan-gang, NIU Nan, ZHAO Long-bo, et al.Effect on Corner Separation Control for High Load Compressor Cascade with Different End-Wall BLS Position[J].Journal of Propulsion Technology, 2010,1(4):433-437.)
[9] Zhang H, Wang S, Wang Z.Variation of Vortex Structure in Compressor Cascade at Different Incidences[J].Journal of Propulsion and Power 2007,3(1):221-226.
[10] Kang S.Investigation of the Three Dimensional Flow within a Compressor Cascade with and without Tip Clearance[D].Brussel:Vrije Universiteit Brussel, 1993.
[11] 韩万今, 吕红卫, 芦文才, 等.高负荷叶片弯曲对壁面流动的影响[J].航空动力学报,1995,0(2):175-179.
[12] 韩万今, 吕红卫, 芦文才, 等.进口附面层厚度对大转角弯叶片损失的影响[J].工程热物理学报,1994,5(4):391-394.
[13] 郭爽, 陈浮, 陆华伟, 等.端壁吸气位置对大转角扩压叶栅流场及负荷的影响[J].推进技术,2011,2(3):323-328.(GUO Shuang, CHEN Fu, LU Hua-wei, et al.Effects of Endwall Boundary Layer Suction Position on the Flow Field and Load in a High-Turning Compressor Cascade[J].Journal of Propulsion Technology, 2011,2(3):323-328.)
[14] 郭爽, 宋彦萍, 陆华伟, 等.来流附面层影响大转角扩压叶栅气动性能的实验研究[J].工程热物理学报,2011,2(10):1661-1664.
[15] Karsten L, Robert M, Sebastian S.Non-Symmetrical Boundary Layer Suction in a Compressor Cascade[J].Journal of theoretical and applied mechanics,2012,50(2):455-472.