碳氢燃料超燃冲压发动机支板凹腔一体化稳焰性能研究

推进技术 ›› 2013, Vol. 34 ›› Issue (11): 1499-1506.

碳氢燃料超燃冲压发动机支板凹腔一体化稳焰性能研究

宋冈霖^1,2,冮强³,王辽³,张岩¹,徐旭¹

北京航空航天大学宇航学院,北京 100191;北京动力机械研究所高超声速冲压发动机技术重点实验室,北京 100074;北京动力机械研究所高超声速冲压发动机技术重点实验室,北京 100074;北京航空航天大学宇航学院,北京 100191;北京航空航天大学宇航学院,北京 100191

发布日期:2021-08-15
作者简介:宋冈霖(1985—),男,硕士生,研究领域为超燃冲压发动机实验及数值仿真。 E-mail:songganglin@163.com

Studies of Strut-Cavity Flameholder Performance in Scramjet Combustor with Hydrocarbon Fuel

School of Astronautics, Beijing University of Aeronautics and Astronautics, Beijing 100191,China;Sicence and Technology on Scramjet Laboratory, Beijing Power Machinery Institute,Beijing 100074, China;Sicence and Technology on Scramjet Laboratory, Beijing Power Machinery Institute,Beijing 100074, China;School of Astronautics, Beijing University of Aeronautics and Astronautics, Beijing 100191,China;School of Astronautics, Beijing University of Aeronautics and Astronautics, Beijing 100191,China

Published:2021-08-15

摘要/Abstract

摘要： 为了提高超燃冲压发动机中支板/凹腔组合构型燃烧效率,通过数值仿真对采用支板/凹腔四种组合构型的燃烧室流场进行了研究,重点分析了不同组合构型对煤油燃烧性能以及凹腔质量交换特性的影响。结果表明:带后缘支板不仅能够提高主流与凹腔的质量交换律,并且能够扩大支板后部低速回流区及燃烧区域面积,从而使煤油燃烧效率提高2.8%~5.8%；采用双凹腔构型与采用单凹腔构型相比虽然不能提高单个凹腔与主流的质量交换律,但是增大了燃烧室低速回流区及燃烧区域面积,从而使煤油燃烧效率提高了4.5%~8.8%；在相同来流工况下,不同支板/凹腔组合构型燃烧室的总压恢复系数相近,随着来流马赫数增大总压恢复系数随之下降。 

关键词: 超燃冲压发动机;支板;凹腔;质量交换率 

Abstract: In order to improve the combustion efficiency of strut/cavity configurations in scramjet, numerical simulation was performed to study the reacting flow field of four different strut/cavity configurations, especially the effects of the combustor configurations on the kerosene combustion performance and the mass exchange rate of cavity. The numerical results show that the strut with rear wedge not only improves the mass exchange rate between the mainstream and cavity, but also creates a larger low-speed recirculation zone and combustion area downstream the strut. These factors increase the combustion efficiency of kerosene by 2.8%~5.8%. Although the application of dual-cavity cannot improve the mass exchange rate between the mainstream and cavity, it increases the low speed recirculation zone and combustion area, and increases the combustion efficiency by 4.5%~8.8%. Under the same inflow conditions, the total pressure recovery is similar in different strut/cavity configurations, and decreases with the stream Mach number increasing.

Key words: Scramjet； Strut；Cavity；Mass exchange rate

宋冈霖,冮强,王辽,张岩,徐旭. 碳氢燃料超燃冲压发动机支板凹腔一体化稳焰性能研究[J]. 推进技术, 2013, 34(11): 1499-1506.

SONG Gang-lin^1,2, GANG Qiang³, WANG Liao³, ZHANG Yan¹, XU Xu¹. Studies of Strut-Cavity Flameholder Performance in Scramjet Combustor with Hydrocarbon Fuel[J]. Journal of Propulsion Technology, 2013, 34(11): 1499-1506.

参考文献

[1] 赵延辉.基于凹腔-支板火焰稳定器的超声速燃烧室实验与数值模拟研究[D].长沙:国防科技大学研究生院, 2011.
[2] 冮强, 周乐仪, 覃正,等.液体碳氢燃料超燃冲压发动机支板凹槽稳焰技术试验[J].推进技术, 2011,2(5):680-683.(GANG Qiang, ZHOU Le-yi, QIN Zheng, et al.Experimental Investigation of Strut-Cavity Flameholder Technology in Liquid Hydrocarbon Fueled Scramjet Combustor[J].Journal of Propulsion Technology, 2011,2(5):680-683.)
[3] 陈立红, 顾洪斌, 张新宇.支板凹腔一体化超燃冲压发动机实验研究[J].工程热物理学报, 2007,8(4):717-719.
[4] Gruber M R.Mixing and Combustion Studies Using Cavity-Based Flameholders in a Supersonic Flow[J].Journal of Propulsion and Power, 2004,0(5):769-778.
[5] Hsu K Y,Carter C D, Gruber M R,et al.Experimental Study of Cavity-Strut Combustion in Supersonic Flow[R].AIAA 2007-5394.
[6] Hsu K Y,Carter C D, Gruber M R,et al.Experimental Study of Cavity-Strut Combustion in Supersonic Flow[J].Journal of Propulsion and Power, 2010,1(6):1237-1246.
[7] 潘科玮,何国强,秦飞,等.用小支板及凹腔组合提高火箭冲压组合发动机的燃烧性能[J].推进技术, 2012,3(2):216-220.(PAN Ke-wei, HE Guo-qiang, QIN fei, et al.Combustion Performance of RBCC Engine with Pylon and Cavity at Ramjet Mode[J].Journal of Propulsion Technology, 2012,3(2):216-220.)
[8] 张新宇, 陈立红, 顾洪斌.超燃冲压发动机中支板/凹腔一体化稳焰机构[C].西安:全国流体力学青年研讨会论文集, 2003.
[9] 宋冈霖, 田亮, 冮强, 等.超燃冲压发动机支板热性能研究[J].推进技术,2013,34(6).(SONG Gang-lin, TIAN Liang, GANG Qiang, et al.Research of Scramjet Strut Thermal Performance[J].Journal of Propulsion Technology, 2013,4(6).)
[10] 孙明波, 梁剑寒, 王振国.超声速燃烧火焰稳定凹腔质量交换特性的数值研究[J].力学学报, 2007,9(2):188-194.
[11] 汪洪波, 孙明波, 吴海燕, 等.超声速燃烧凹腔质量交换特性的混合RANS/LES模拟[J].航空动力学报, 2010,5(1):41-46.
[12] Davis D L, Bowersox R D W.Stirred Reactor Analysis of Cavity Flame Holders for Scramjets [R].AIAA 97-3274.
[13] Baurle R A, Gruber M R A.Study of Recessed Cavity Flowfields for Supersonic Combustion Applications[R].AIAA 98-0938.
[14] Gruber M R, Baurle R A, Mathur T, et al.Fundamenta Studies of Cavity-Based Flameholder Concepts for Supersonic Combustors[J].Journal of Propulsion and Power, 2001,7(1):146-153.
[15] Baurle R A, Tam C J, Dasgupta S.Analysis of Unstead Cavity Flows for Scramjet Applications[R].AIAA 2000-3617.
[16] Baurle R A, Tam C J, Edwards J R, et al.Hybrid Simulation Approach for Cavity Flows:Blending,Algorithm, an Boundary Treatment Issues[J].AIAA Journal, 2003,4(8):1463-1480.