高压比离心叶轮自循环机匣处理扩稳研究

推进技术 ›› 2013, Vol. 34 ›› Issue (2): 194-201.

高压比离心叶轮自循环机匣处理扩稳研究

卜远远,楚武利,张皓光,董兴杰

西北工业大学动力与能源学院,陕西西安 710072;西北工业大学动力与能源学院,陕西西安 710072;西北工业大学动力与能源学院,陕西西安 710072;西北工业大学动力与能源学院,陕西西安 710072

发布日期:2021-08-15
作者简介:卜远远(1986—),男,硕士生,研究领域为叶轮机械气动热力学。E-mail:buyuanyuan@mail.nwpu.edu.cn
基金资助:
国家自然科学基金(51006084)；2010年度高等学校博士学科点(博导类)专项科研基金(20106102110023)；陕西省自然科学基金(2011JQ7018)。

Stability Improvement in High Pressure-Ratio Centrifugal Impeller with Self Recirculation Casing Treatment

School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China;School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China;School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China;School of Power and Energy, Northwestern Polytechnical University, Xi’an 710072, China

Published:2021-08-15

摘要/Abstract

摘要： 为了探索自循环机匣处理扩稳机理,利用全三维数值模拟方法对应用自循环上游槽封闭机匣和自循环机匣处理结构两种情况下的Krain高压比离心叶轮进行了详细研究。对比结果表明:自循环机匣处理能有效的延迟失速的发生并在近失速区域略微提高压气机的效率以及总压比。通过详细的流场分析表明:该机匣处理能有效地减小叶顶载荷,从而降低泄漏流相对速度,抑制间隙泄漏涡在叶顶通道内的发展以减小低速气流在流道内的阻塞,提高转子通道的通流能力,从而达到扩大稳定工作范围的目的。

关键词: 离心叶轮;高压比;自循环;机匣处理;数值分析;失速裕度

Abstract: In order to explore the mechanism of stability improvement, numerical investigations are performed to examine the role of the self recirculation casing treatment and a recirculation device in which upstream slot is sealed in the enhancement of operational range of a centrifugal impeller with high pressure-ratio. The numerical results approve that self recirculation casing treatment not only can suspend the stall effectively but also can improve the impeller efficiency and total pressure ratio appreciably in the near of stall region. The detailed analysis of the flow field at the blade tip shows that it reduces the blade loading in the impeller tip region. And hence the velocity of tip leakage flow exiting the bleed slot becomes lower compared with that without the self recirculation device. All these effects induced by the recirculation device are considered to lead to the suppression of the extension of blockage and to contribute to the enhancement of the impeller operating range.

Key words: Centrifugal impeller; High pressure-ratio; Self recirculation; Casing treatment; Numerical analysis; Stall margin

卜远远,楚武利,张皓光,董兴杰. 高压比离心叶轮自循环机匣处理扩稳研究[J]. 推进技术, 2013, 34(2): 194-201.

BU Yuan-yuan, CHU Wu-li, ZHANG Hao-guang, DONG Xing-jie. Stability Improvement in High Pressure-Ratio Centrifugal Impeller with Self Recirculation Casing Treatment[J]. Journal of Propulsion Technology, 2013, 34(2): 194-201.

参考文献

[1] Krain H, Karpinski G, Beversdorff M.Flow Analysis in a Transonic Centrifugal Compress Rotor Using 3-Component Laser Velocimetry [R].ASME 2001-GT-0315.
[2] Jansen W, Carter A F, Swarden M C.Improvements in Surge Margin for Centrifugal Compressor [R].AGARD Conference Proceedings,CP-2,0.
[3] Elder R L, Gill M E.A Discussion of the Factors Affecting Surge in Centrifugal Compressor [R].ASME 84-GT-194.
[4] Elder R L.Enhancement of Turbo Compressor Stability[R].IMechE 1994-2.
[5] 高鹏, 楚武利, 吴艳辉,等.带周向槽机匣处理的离心压气机扩稳机理分析 [J].推进技术, 7,5(4):383-387.(GAO Peng, CHU Wu-li, WU Yan-hui,et al.Mechanism of Stall Margin Improvement in a Centrifugal Compressor with Circumferential Grooves Casing Treatment [J].Journal of Propulsion Technology, 7,5(4):383-387.)
[6] Fisher F B.Application of Map Width Enhancement Devices to Turbocharger Compressor Stages [R].SAE 4,9.
[7] Masahiro Ishida, Taufan Surana, Hironobu Ueki, et al.Suppression of Unstable Flow at Small Flow Rates in a Centrifugal Blower by Controlling Tip Leakage Flow and Reverse Flow [R].ASME 2004-GT-53400.
[8] Masahiro Ishida, Taufan Surana, Hironobu Ueki, et al.Optimization of Inlet Ring Groove Arrangement for Suppression of Unstable Flow in a Centrifugal Impeller [R].ASME 2005-GT-68675.
[9] Masahiro Ishida, Taufan Surana, Hironobu Ueki, et al.Effect of Pre-Whirl on Unstable Flow Suppression in a Centrifugal Impeller with Ring Groove Arrangement [R].ASME 2006-GT-90400.
[10] 卜远远, 楚武利.分流叶片周向位置对离心叶轮性能及内部流动的影响 [J].流体机械, 1,9(9):16-20.
[11] 卜远远, 楚武利, 张皓光.跨音速离心叶轮自循环机匣处理扩稳研究 [J/OL].中国科技论文在线, http://www.paper.edu.cn/index.php/default/releasepaper/content/201109-319,2011-09-23.
[12] Mileshin V, Brailko I, Startsev A.Application of Casing Ci-Rcumferential Grooves to Counteract the Influence of Tip Clearance [R].ASME 2008-GT-51147.
[13] Hazby R, Xu L.Role of Tip Leakage in Stall of a Transonic Centrifugal Impeller [R].ASME 2009-GT-59372.
[14] 高鹏.径流式叶轮内部流动失稳及机匣处理扩稳研究 [D].西安:西北工业大学, 2008.