涡轮叶栅叶冠泄漏流动数值研究

推进技术 ›› 2013, Vol. 34 ›› Issue (3): 316-325.

涡轮叶栅叶冠泄漏流动数值研究

贾惟,刘火星

北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室,北京 100191;北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室,北京 100191

发布日期:2021-08-15
作者简介:贾惟(1986—),男,博士生,研究领域为叶轮机械气动热力学。E-mail:jiawei@sjp.buaa.edu.cn
基金资助:
国家自然科学基金(51106004)。

Numerical Investigation on Shroud Leakage Flow in Turbine Cascade

National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics, School of Energy and Power Engineering, Beihang University, Beijing 100191, China.;National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics, School of Energy and Power Engineering, Beihang University, Beijing 100191, China.

Published:2021-08-15

摘要/Abstract

摘要： 以小展弦比涡轮叶栅为研究对象,利用三维数值计算的方法研究了篦齿数、篦齿排列型式、上下游压力以及径向间隙对叶冠泄漏流量的影响,并分析了泄漏流动与主流的相互作用。研究表明,叶片排上下游压比和径向间隙是影响叶冠泄漏流动的主要因素,篦齿数和篦齿排列型式对泄漏流量的大小和出口气流角均有重要影响。考虑了主流的影响之后,叶冠出口流动呈现出高度的三维性和周向不均匀性。在周向压力梯度的作用下,径向速度以正负交替的形式出现,而且周向速度和轴向速度则出现了明显的分层结构。 

关键词: 叶冠泄漏流动;小展弦比;平面叶栅;篦齿数;篦齿排列方式 

Abstract: In gas turbine,tip endwall secondary flows and related losses are significantly influenced by shroud leakage flow. Based on low aspect ratio turbine cascade, three-dimensional numerical simulation was taken to investigate the effects of seal number, seal arrangement, pressure ratio and radial tip clearance on shroud leakage flow and the interaction between shroud leakage flow and main flow. Results show that,pressure ratio across the blade row and radial tip clearance are the main factors while the seal number and seal arrangement have primary effects on the leakage mass flow rate and exit flow angle. When the interaction between main flow and shroud leakage flow is taken into account, the flow inside the shroud exit cavity presents highly complex three-dimensional and circumferential non-uniformity. Under the effects of circumferential pressure gradient, the radial component of velocity shows positive and negative alternative distribution. At the same time the circumferential and axial components of velocity appear to have the obviously layered distribution. 

Key words: Shroud leakage flow；Low aspect ratio；Cascade；Seal number；Seal arrangement

贾惟,刘火星. 涡轮叶栅叶冠泄漏流动数值研究[J]. 推进技术, 2013, 34(3): 316-325.

JIA Wei, LIU Huo-xing. Numerical Investigation on Shroud Leakage Flow in Turbine Cascade[J]. Journal of Propulsion Technology, 2013, 34(3): 316-325.

参考文献

[1] Denton J D.Loss Mechanisms in Turbomachines [J].Journal of Turbomachinery,1993,5(4):621-656.
[2] Denton J D.Some Limitations of Turbomachinery CFD [R].ASME 2010-GT-22540.
[3] Vermes G A.Fluid Mechanics Approach to the Labyrinth Seal Leakage Problem [J].Journal of Engineering Power, 1961,3(2):161-169.
[4] Zimmermann H, Wolff K H.Air System Correlations, part 1:Labyrinth Seals [R].ASME 98-GT-206.
[5] Cherry D, Wadia A, Beacock R, et al.Analytical Investigation of a Low Pressure Turbine with and Without Flowpath Endwall Gaps, Seals and Clearance Features [R].ASME 2005-GT-68492.
[6] Wellborn S R, Okiishi T H.The Influence of Shrouded Stator Cavity Flows on Multistage Compressor Performance [J].Journal of Turbomachinery, 1999,1(3):486-497.
[7] Denton J D, Johnson C G.The Experimental Study of the Tip Leakage Flow Around Shrouded Turbine Blades [R].CEGB Report No.R/M/N848, Marchwood Engineering Laboratories, UK, 1976.
[8] Bohn D E, Balkowski I, Ma H, et al.Influence of Open and Closed Shroud Cavities on the Flow Field in a 2-Stage Turbine with Shrouded Blades [R].ASME 2003-GT-38436.
[9] Bohn D E, Krewinkel R, Tummers C, et al.Influence of the Radial and Axial Gap of the Shroud Cavities on the Flow Field in a 2-Stage Turbine [R].ASME 2006-GT-90857.
[10] Peters P, Breisig V, Giboni A, et al.The Influence of the Clearance of Shrouded Rotor Blades on the Development of the Flow Field and Losses in the Subsequent Stator [R].ASME 2000-GT-0478.
[11] Rosic B, Denton J D, Curtis E M, The Influence of Shroud and Cavity Geometry on Turbine Performance-an Experimental and Computational Study, Part 1:Shroud Geometry [R].ASME 2007-GT-27769.
[12] Nirmalan N V, Bailey J C.Experimental Investigation of Aerodynamic Losses of Different Shapes of a Shrouded Blade Tip Section [R].ASME 2005-GT-68903.
[13] Porreca L, Behr T, Schlienger J, et al.Fluid Dynamics and Performance of Partially and Fully Shrouded Axial Turbines [J].Journal of Turbomachinery, 2005,7(4):668-678.
[14] Porreca L, Kalfas A I, Abhari R S, Optimized Shroud Design for Axial Turbine Aerodynamic Performance [R].ASME 2007-GT-27915.
[15] 吴丁毅.直通式蓖齿封严特性的实验研究[J].推进技术, 1997,8(3).(WU Ding-yi.An Experimental Investigation on Seal Characteristic of Straight-Through Labyrinth [J].Journal of Propulsion Technology, 1997,8(3).)
[16] Xiao Y,Amano R S.Leakage Flow over Shrouded Turbine Blades [R].ASME 2000-GT-0193.
[17] 崔孝相, 杨凤森.四种典型篦齿封严性能的实验研究[J].沈阳航空工业学院学报, 1991,5(6):38-45.
[18] Zimmermann H, Wolff H.Comparison Between Empirical and Numerical Labyrinth Flow Correlations[R].ASME 87-GT-86.