波瓣尾缘切角对涡扇发动机混合排气系统气动热力性能影响

推进技术 ›› 2013, Vol. 34 ›› Issue (6): 734-740.

波瓣尾缘切角对涡扇发动机混合排气系统气动热力性能影响

刘友宏¹,张少鹏¹,杨旭¹,谢翌¹,邵万仁²,吴飞²

北京航空航天大学能源与动力工程学院,北京 100191;北京航空航天大学能源与动力工程学院,北京 100191;北京航空航天大学能源与动力工程学院,北京 100191;北京航空航天大学能源与动力工程学院,北京 100191;沈阳发动机设计研究所,辽宁沈阳 110015;沈阳发动机设计研究所,辽宁沈阳 110015

发布日期:2021-08-15
作者简介:刘友宏(1963—),男,教授,博士,研究领域为传热传质、红外等领域。E-mail:liuyh@buaa.edu.cn

Effects of Cut Angles at Trailing Edge of Lobe on Aerothermodynamic Performance of Forced Mixing Exhaust System in Turbofan Engine

School of Jet Propulsion, Beijing University of Aeronautics and Astronautics, Beijing 100191, China;School of Jet Propulsion, Beijing University of Aeronautics and Astronautics, Beijing 100191, China;School of Jet Propulsion, Beijing University of Aeronautics and Astronautics, Beijing 100191, China;School of Jet Propulsion, Beijing University of Aeronautics and Astronautics, Beijing 100191, China;Shenyang Aero-engine Design and Research Institute, Shenyang 110015, China;Shenyang Aero-engine Design and Research Institute, Shenyang 110015, China

Published:2021-08-15

摘要/Abstract

摘要： 为了获得尾缘切角对涡扇发动机波瓣强迫混合排气系统的流场、热混合效率、总压恢复系数以及推力系数的影响,以涡扇发动机波瓣强迫混合排气系统为研究对象,采用基于Navier-Stokes方程的三维数值模拟方法对不同波瓣尾缘切角模型进行了计算并得到了气动热力性能的影响规律。结果表明:较大的尾缘切角造成在尾缘截面前主次流更早的提前混合,使流向涡的产生和发展在位置上向上游提前,以至于在尾缘截面之后的一定范围内混合效率更高。但大尾缘切角同时也造成较大的能量损失,以至于总压恢复系数较小,总的混合效率偏低:相比0°切角,25°切角的总压恢复系数减小了0.34%,热混合效率减小了11%。适当的尾缘切角修形可以增大推力系数。 

关键词: 涡扇发动机;波瓣;尾缘切角;混合排气系统;热混合效率;总压恢复系数;推力系数 

Abstract: To obtain the effects of cut angles at trailing edge of lobed mixer in turbofan engine on flow field, thermal efficiency, total-pressure recovery coefficient and thrust coefficient, a series of 3D numerical simulation based on Navier-Stokes equations were conducted based on a lobed mixer in the forced mixing exhaust system of a turbofan engine and the principle of effects on aerothermodynamic performance was obtained. Larger cut angle causes earlier mix of primary and secondary flow and earlier development of streamwise vortices in the direction of flow, so that mixing efficiency is higher within a certain distance after trailing edge. But it also causes more energy loss, so that total-pressure recovery coefficient and overall mixing efficiency are low. Total pressure recovery coefficient is decreased by 0.34% and mixing efficiency is decreased by 11% when cut angle is increased from 0° to 25°. Thrust coefficient could be increased with an appropriate cut angle at trailing edge. 

Key words: Turbofan engine；Lobe；Cut angle at trailing edge； Mixer exhaust system；Thermal mixing efficiency；Total-pressure recovery coefficient；Thrust coefficient

刘友宏,张少鹏,杨旭,谢翌,邵万仁,吴飞. 波瓣尾缘切角对涡扇发动机混合排气系统气动热力性能影响[J]. 推进技术, 2013, 34(6): 734-740.

LIU You-hong¹,ZHANG Shao-peng¹,YANG Xu¹, XIE Yi¹, SHAO Wan-ren², WU Fei². Effects of Cut Angles at Trailing Edge of Lobe on Aerothermodynamic Performance of Forced Mixing Exhaust System in Turbofan Engine[J]. Journal of Propulsion Technology, 2013, 34(6): 734-740.

参考文献

[1] Presz W M.Mixer/Ejector Noise Suppressors[R].AIAA 91-2243.
[2] Presz W M, Reynolds G, Mccormick D C.Thrust Augment Using Mixer-Ejector-Diffuser Systems[R].AIAA 94-0020.
[3] 刘友宏,陈锵,李立国．圆排波瓣圆柱混合管的气动特性实验研究[J]．南京航空航天大学学报,2000,32(4):375-380.
[4] Paterson R W.Turbofan Mixer Nozzle Flow Field-A Benchmark Experimental Study [J].Journal of Engineering for Gas Turbines and Power, 1984,6:692-698.
[5] LIU Youhong.Experimental and Numerical Research on High Pumping Performance Mechanism of Lobed Exhauster Ejector [J] .International Communication of Heat and Mass Transfer, 2007,4(2):197-209.
[6] LIU Youhong.Experimental and Numerical Investigation of Circularly Lobed Eject or with Bend Mixer [J].Heat Transfer- Asian Research, 2007,6(7):387-397．
[7] 刘友宏,李立国．有中心锥圆排波瓣喷管引射器内流场模拟[J].推进技术,2002,3(2):150-153.(LIU You-hong, LI Liguo.Numerical Simulation of Flow Field in Circularly Lobed Exhaust Ejector Mixer with a Central Plug [J].Journal of Propulsion Technology, 2002,3(2):150-153.)
[8] 刘友宏, 谢翌.菊花形混合器混合效率理论计算[J] .航空动力学报, 2009,4(4) :740-745.
[9] 谢翌, 刘友宏.波瓣高宽比对波瓣强迫混合排气系统性能影响[J].航空动力学报, 2010,5(12):2787-2794.
[10] 刘友宏, 樊超, 谢翌, 等.波瓣数对波瓣强迫混合排气系统性能影响[J].航空动力学报,2010,5(8):1683-1689.
[11] 刘友宏, 谢翌, 郭楠.尾缘凹扇及综合修形对波瓣混合器性能影响[J].航空动力学报,2010,5(2):243-250.
[12] 刘友宏, 郭楠．后缘切角对波瓣混合器性能影响[J]．航空动力学报,2009,24(9):1917-1922.
[13] Cooper N J, Merati P,Hu Hui.Numerical Simulation of the Vortical Structures in a Lobed Jet Mixing Flow[R].AIAA 2005-635.
[14] Frost T H．Practical Bypass Mixing Systems for Fan Jet Aero-Engines[J]．Royal Aeronautical Society, 1966,7:141-160.
[15] XIE Yi, LIU Youhong.A Modified Thermal Mixing Efficiency and its Application to Lobed Mixer Nozzle for Aero-Engines[J].Heat Transfer Research,2011,2(4):317-335.