雷诺数对带蜗壳的离心压气机内部流场影响研究

推进技术 ›› 2013, Vol. 34 ›› Issue (7): 911-917.

雷诺数对带蜗壳的离心压气机内部流场影响研究

陈浮,王云飞,陈焕龙,李国占

哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150001;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150001;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150001;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:陈浮(1970—),男,博士,教授,研究领域为叶轮机械内部的复杂流动。E-mail:chenfu@hit.edu.cn
基金资助:
中央高校基本科研业务费专项资金资助(HIT.NSRIF.201173)。

Effects of Reynolds Number on Internal Flow Field of Centrifugal Compressor with the Volute

School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China

Published:2021-08-15

摘要/Abstract

摘要： 为了探讨离心压气机性能随雷诺数的变化规律,对带蜗壳的全周流道流场进行数值模拟,分析雷诺数对内部流场结构的影响。结果表明:压气机工作于Re=5.7×10⁴和Re=1.3×10⁴下的最高效率比Re=1.4×10⁵分别下降了4.5%和8.5%,所有工况在10%叶高附近效率最高。受到蜗壳的影响,全周流道计算所得压气机的效率值和工作范围均小于单流道计算结果。低雷诺数时,气流抗逆压梯度能力迅速减弱,叶顶泄漏流向下游发展过程中,会绕过相邻叶片前缘或顶部间隙进入其他流道；叶片表面约化静压沿径向的梯度增加,从而造成更严重的二次流动；前缘激波强度、附面层厚度和尾迹宽度均增加,流道内出现激波,压气机性能严重恶化。 

关键词: 离心压气机;蜗壳;雷诺数;泄漏流 

Abstract: The flow field of a whole flow passage centrifugal compressor with its volute was simulated numerically to investigate the changing trends of the performance at different Re. Effects of Re on the internal flow were analyzed in detail. The results show that, compared with Re=1.4×10⁵, the peak efficiencies of the compressor are down 4.5% with Re=5.7×10^4and 8.5% with Re=1.3×10⁴, respectively. The highest efficiency point is near 10% blade span in all working conditions. Due to the influence of the volute, efficiency and working range of the compressor are lower than the calculation results of single passage. In the case of low Re, the air flow ability to resist the adverse pressure gradient decreases rapidly. The leakage flow at one blade tip clearance would bypass the leading edge or blade tip of its adjacent blade with the flow developing downstream. More serious secondary flow is caused by increasing the reduced static pressure gradient on the blade surface along radial direction. The performance of the compressor significantly deteriorates owing to increasing shock intensity, boundary layer thickness and wake width. 

Key words: Centrifugal compressor; Volute; Reynolds number; Leakage flow

陈浮,王云飞,陈焕龙,李国占. 雷诺数对带蜗壳的离心压气机内部流场影响研究[J]. 推进技术, 2013, 34(7): 911-917.

CHEN Fu, WANG Yun-fei, CHEN Huan-long, LI Guo-zhan. Effects of Reynolds Number on Internal Flow Field of Centrifugal Compressor with the Volute[J]. Journal of Propulsion Technology, 2013, 34(7): 911-917.

参考文献

[1] 黄国平, 梁德旺, 温泉.微型涡喷发动机顶层设计研究[J].航空动力学报, 2003,8(6):832-838.
[2] Rouser K P, King P I, Schauer F R.Parametric Study of Unsteady Turbine Performance Driven by a Pulse Detonation Combustor[R].AIAA 2010-6536.
[3] Epstein A H.Millimeter-Scale, MEMS Gas Turbine Engines[R].Proceedings of ASME Turbo Expo, 2003-GT-38866.
[4] Epstein A H.Millimeter-Scale, Micro-Electro-Mechanical Systems Gas Turbine Engines[J].Journal of Engineering for Gas Turbines and Power, 2004,6:205-226.
[5] Bradbrool S J.Common Solutions to Commercial and Military Propulsion Requirements[C].Yokohama:24th International Congress of the Aeronautical Sciennces, 2004.
[6] Ehrlich H, Kurz K H, Rued K P, et al.Trends in Military Aeroengine-Design from EJ200to Future Manned and Unmanned Vehicle Propulsion[R].AIAA 2003-2612.
[7] 郭琦, 李兆庆.无人机和巡航导弹用涡扇/涡喷发动机的设计特点[J].燃气涡轮试验与研究, 2007,0(2):58-62.
[8] 赵峰, 桂幸民.低雷诺数效应对某可控扩散叶型性能的影响[J].航空动力学报, 2006,1(6):285-289.
[9] 夏钦斌, 王如根, 李勇, 等.低雷诺数下跨声速转子流动失稳及周向槽处理机匣扩稳[J].推进技术, 2010,1(3):340-344.(XIA Qin-bin, WANG Ru-gen, LI Yong, et al.Investigation on Flow Instability of Transonic Compressor Rotor and the Effects of CGCT on Stallmargin at Low Reynolds Number[J].Journal of Propulsion Technology, 2010,1(3):340-344.)
[10] Johnson M W, Moore J.Secondary Flow Mixing Losses in A Centrifugal Impeller[J].ASME Journal of Engineering Power, 1983,5(1):24-32.
[11] Hirsch C, Kang S, Pointet G.A Numerically Supported Investigation on the 3D Flow in Centrifugal Impellers.Part Ⅰ:The Validation Base[R].ASME 96-GT-151.
[12] Hirsch C, Kang S, Pointet G.A Numerically Supported Investigation on the 3D Flow in Centrifugal Impellers.Part Ⅱ:Secondary Flow Structure[R].ASME 96-GT-152.
[13] 郭强, 竺晓程, 杜朝晖, 等.高速离心压缩机旋转失速的三维数值模拟[J].推进技术, 2007,8(4):373-377.(GUO Qiang, ZHU Xiao-cheng, DU Zhao-hui, et al.Three-Dimensional Numerical Simulation for Rotating Stall Inside High-Speed Centrifugal Compressor[J].Journal of Propulsion Technology, 2007,8(4):373-377.)
[14] 石建成, 高星, 刘宝杰.跨声速离心叶轮负荷分布的影响分析[J].推进技术, 2008,9(4):458-464.(SHI Jian-cheng, GAO Xing, LIU Bao-jie.Effects of Loading Distribution on a Transonic Centrifugal Impeller[J].Journal of Propulsion Technology, 2008,9(4):458-464.)
[15] 屠秋野, 陈玉春, 苏三买, 等.雷诺数对高空长航时无人机发动机调节计划和性能影响[J].推进技术, 2005,6(2):125-128.(TU Qiu-ye, CHEN Yu-chun, SU San-mai, et al.Effects of Reynolds Number on Control Schedule and Performance of HALE Engine[J].Journal of Propulsion Technology, 2005,6(2):125-128.)
[16] Schleer M, Abhari R.Influence of Geometric Scaling on the Stability and Range of a Turbocharge Centrifugal Compressore[R].ASME GT2005-68713.