矩形冷却槽道内煤油热裂解过程数值研究

推进技术 ›› 2014, Vol. 35 ›› Issue (1): 128-132.

矩形冷却槽道内煤油热裂解过程数值研究

侯凌云,董宁,孙大鹏

清华大学航天航空学院,北京 100084;清华大学航天航空学院,北京 100084;清华大学航天航空学院,北京 100084

发布日期:2021-08-15
作者简介:侯凌云(1972—),女,博士,副教授,博士生导师,研究领域为先进推进燃烧和热防护。E-mail:lyhou@tsinghua.edu.cn
基金资助:
国家自然科学基金资助(51176093)。

Numerical Study on Thermal Cracking Process of Kerosene in a Rectangular Cooling Channel

School of Aerospace, Tsinghua University, Beijing 100084, China;School of Aerospace, Tsinghua University, Beijing 100084, China;School of Aerospace, Tsinghua University, Beijing 100084, China

Published:2021-08-15

摘要/Abstract

摘要： 高马赫数下超燃冲压发动机煤油再生冷却过程中易发生热裂解反应导致结焦,因此有必要在冷却通道中开展热裂解过程研究。基于热裂解反应产物试验结果建立了一步热裂解总包反应,对煤油在冷却槽道中超临界流动换热以及热裂解过程展开了三维数值模拟研究,将固壁的传热和槽道内流动反应进行耦合计算,与三种不同热流密度的实验工况对比。结果表明,在热裂解反应发生以前,两相流模型的温度分布和实验数据吻合得很好,但随着燃油温度升高到450℃,燃料开始发生复杂的化学反应,两者开始出现偏离,温度越高,偏离越大。在引入热裂解反应模型之后,高温区域的温度显著降低,和实验结果吻合。热流密度越大,裂解反应率加剧,煤油反应转化率增大。煤油在弯折冷却通道中温度分布不对称。 

关键词: 煤油;热裂解反应;超临界相变;矩形冷却槽道 

Abstract: Thermal cracking is easy to cause the coking during the regenerative cooling process in the high Mach number scramjet. It is necessary to study the thermal cracking behavior in the cooling channel. A one-step thermal cracking global reaction was established based on the experimental results of reaction products. Using the global reaction kinetics a 3D numerical simulation of thermal cracking coupled with two-phase flow and heat transfer was carried out in a cooling rectangular channel. Three cases of different heat fluxes were compared between the simulation and experiments. The results show that wall temperature distribution of the simulation only using two-phase model are in good agreement with the experiment data before the thermal cracking reaction. There is an obvious difference between the simulation and experiment when fuel temperature increases above 450℃. The higher the fuel temperature is, the bigger the difference is. The wall temperature of the simulation after introducing thermal cracking model decreases and agrees well with the experimental results. When heat flux increases, the cracking reaction rate and conversion rate of kerosene grow. The temperature distribution of kerosene in a curved channel is asymmetric. 

Key words: Kerosene; Thermal cracking; Supercritical phase-change; Rectangular cooling channel

侯凌云,董宁,孙大鹏. 矩形冷却槽道内煤油热裂解过程数值研究[J]. 推进技术, 2014, 35(1): 128-132.

HOU Ling-yun, DONG Ning, SUN Da-peng. Numerical Study on Thermal Cracking Process of Kerosene in a Rectangular Cooling Channel[J]. Journal of Propulsion Technology, 2014, 35(1): 128-132.

参考文献

[1] 朱锟,邓宏武,王英杰,等.超临界压力下航空煤油结焦换热综述及实验[J].航空动力学报, 2010,5(11).
[2] Yu J, Eser S.Supercritical-phase Thermal Decomposition of Binary Mixtures of Jet Fuel Model Compounds[J].Fuel,2000,9(7):759-768.
[3] 郝伟华, 张香文, 王占卫,等.超临界状态下吸热碳氢燃料正十二烷的催化裂解研究 [J].石油与天然气化工, 2006,5(3):175-178.
[4] 邢燕, 方文军, 谢文杰,等.吸热型碳氢燃料模型化合物在超临界条件下的裂解及热沉测定 [J].化学学报, 2008,6(20):2243-2247.
[5] 贾真,侯凌云,龚景松,等.煤油热沉与热裂解反应特性的试验研究[J].工程热物理学报, 2011,2(10):1789-1792.
[6] Dahm K D, Virk P S, Bounaceur R, et al.Experimental and Modelling Investigation of the Thermal Decomposition of n-Dodecane[J].Journal of Analytical and Applied Pyrolysis,2004,1(2):865-881.
[7] Zhou N, Krishnan A.Calibration of a Global Mechanism for Jet Fuel Deposition[R].AIAA 96-3238.
[8] Zhou N, Krishnan A.Numerical Simulation of Jet Fuel Heat Transfer and Deposition at Supercritical Pressure[R].AIAA 97-3042.
[9] Ward T A, Ervin J S, Striebich R C,et al.Simulations of Flowing Mildly-cracked Normal Alkanes Incorporating Proportional Product Distributions[J].Journal of Propulsion and Power,2004,0(3):394-402.
[10] Ward T A, Ervin J S, Zabarnick S.Pressure Effects on Flowing Mildly-cracked n-Decane[J].Journal of Propulsion and Power, 2005,1(2):344-355.
[11] Zhong F Q, Fan X J, Yu G,et al.Thermal Cracking of Aviation Kerosene for Scramjet Applications[J].Science in China Series E:Technological Sciences, 2009,2(9):2644-2652.
[12] Xing Y, Xie W J, Fang W J, et al.Kinetics and Product Distributions for Thermal Cracking of Kerosene-based Aviation Fuel[J].Energy & Fuels, 2009,3(8).
[13] Edwards T.Cracking and Deposition Behavior of Supercritical Hydrocarbon Aviation Fuels[J].Combustion Science and Technology, 2006,8(1-3):307-334.
[14] 胡志宏,陈听宽,罗毓珊,等.超临界压力下煤油传热特性试验研究[J].西安交通大学学报,1999,3.
[15] 范学军,俞刚.大庆RP-3航空煤油热物性分析[J].推进技术,2006,7(2):187-192.(FAN Xue-jun, YU Gang.Analysis of Thermophysical Properties of Daqing RP-3Aviation Kerosene[J].Journal of Propulsion Technology, 2006,7(2):187-192.)
[16] Zhong F Q, Fan X J, Wang J, et al.Thermal Cracking and Heat Sink Capacity of Aviation Kerosene under Supercritical Conditions[R].AIAA 2009-52.