翼梢小翼对涡轮间隙泄漏流动影响的数值研究

推进技术 ›› 2014, Vol. 35 ›› Issue (3): 341-346.

翼梢小翼对涡轮间隙泄漏流动影响的数值研究

王大磊,邵伏永,郭昊雁,王维明

中国航天科工集团三十一研究所,北京 100084;中国航天科工集团三十一研究所,北京 100084;中国航天科工集团三十一研究所,北京 100084;中国航天科工集团三十一研究所,北京 100084

发布日期:2021-08-15
作者简介:王大磊(1986—),男,博士,工程师,研究领域为航空发动机气动热力学。E-mail:wangdl03@139.com

Study of Tip Winglets on Leakage Flow in a Transonic Turbine Stage

The 31st Research Institute of CASIC, Beijing 100074, China;The 31st Research Institute of CASIC, Beijing 100074, China;The 31st Research Institute of CASIC, Beijing 100074, China;The 31st Research Institute of CASIC, Beijing 100074, China

Published:2021-08-15

摘要/Abstract

摘要： 转子叶片叶尖增加翼梢小翼是控制涡轮间隙泄漏流减小泄漏损失的有效手段之一,为研究翼梢小翼位置对高压涡轮间隙泄漏流动的影响,利用数值模拟方法求解雷诺平均纳维-斯托克斯方程获得涡轮通道内的三维流场,并详细分析叶片压力边和吸力边增加翼梢小翼对间隙泄漏流及涡轮气动损失的影响。研究发现:压力边翼梢小翼可以降低间隙泄漏流量,但基本不改变间隙泄漏涡结构,对涡轮效率影响较小；吸力边翼梢小翼虽然对降低间隙泄漏流量作用不明显,但可以有效地抑制泄漏涡的生成和发展并削弱叶片吸力面壁面潜流,降低泄漏流动损失。结果表明:在控制间隙泄漏流动减小泄漏损失方面,吸力边翼梢小翼明显优于压力边翼梢小翼。 

关键词: 航空发动机;涡轮;翼梢小翼;间隙泄漏流;数值模拟 

Abstract: The tip winglet is one of most effective methods for tip desensitization of an axial turbine. In order to investigate the effects of the winglet’s location on the tip clearance leakage flow, Reynolds-averaged Navier-Stokes equation was solved by numerical simulation to obtain three-dimensional flowfield of turbine. And the effects of pressure-side and suction-side tip winglets on the tip clearance leakage flow and aerodynamic performance were studied. Results show that the pressure-side tip winglet could reduce the leakage flow mass, but the structure of the leakage vortex is unaltered, which leads to the tiny change of losses. The suction-side winglet is less helpful to reduce leakage flow mass. However the suction-side winglet weakens the strength of the leakage vortex as well as the underflow on the suction side of the rotor blade, as a result the losses decrease markedly and the efficiency of the turbine stage increases. It is clear that suction-side winglets are more effective on tip desensitization than pressure-side winglets. 

Key words: Aero engine; Turbine; Tip winglet; Tip clearance leakage flow; Numerical simulation

王大磊,邵伏永,郭昊雁,王维明. 翼梢小翼对涡轮间隙泄漏流动影响的数值研究[J]. 推进技术, 2014, 35(3): 341-346.

WANG Da-lei, SHAO Fu-yong, GUO Hao-yan, WANG Wei-ming. Study of Tip Winglets on Leakage Flow in a Transonic Turbine Stage[J]. Journal of Propulsion Technology, 2014, 35(3): 341-346.

参考文献

[1] Gümmer V, Goller M, Swoboda M.Numerical Investigation of Endwall Boundary Layer Removal on Highly-Loaded Axial Compressor Blade Rows[R].ASME 2005- GT-68699.
[2] Rao N M, Camci C.Axial Turbine Tip Desensitization by Injection from a Tip Trench.Part1:Effect of Injection Mass Flow Rat[R].ASME 2004-GT-53256.
[3] Rao N M, Camci C.Axial Turbine Tip Desensitization by Injection from a Tip Trench.Part 2:Leakage Flow Sensitivity to Injection Location[R].ASME 2004-GT-53258.
[4] James A Tallman.A Computational Study of Tip Desensitization in Axial Flow Turbines[D].Pennsylvania:The Pennsylvania State University, 2002.
[5] Daniel K V,Thomas C C, Scott C M.Tip Clearance Flow Control in a Linear Turbine Cascade using Plasma Actuation [R].AIAA 2006-0021.
[6] 李伟, 乔渭阳, 许开富, 等.涡轮叶尖泄漏流被动控制数值模拟[J].推进技术, 2008,9(5):591-597.( LI Wei,QIAO Wei-yang,XU Kai-fu,et al.Numerical Simulation of Passive Control on Tip Leakage Flow in Axial Turbine[J].Journal of Propulsion Technology,2008,9(5):591-597.)
[7] 牛茂升.涡轮间隙流动主动控制的试验研究及数值模拟[D].上海:上海交通大学,2010.
[8] 牛茂升, 臧述升.机匣喷气位置对涡轮间隙流动控制的影响[J].推进技术, 2009,0(5):594-598.( NIU Mao-sheng,ZHANG Shu-sheng.Effects of Casing Air Injection Position on Controlling Tip Clearance Flow in Axial Turbines[J].Journal of Propulsion Technology,2009,0(5):594-598.)
[9] Pate K V.Research on a High Work Axial Gas Generator Turbine[R].SAE Paper 800618,0.
[10] Neil W Harvey, Ken Ramsden.A Computational Study of Tip Desensitization in Axial Flow Turbines[J].Journal of Turbomachinery, 2001,3(5):534-543.
[11] Debashis Dey, Cengiz Camci.Aerodynamic Tip Desensitization of an Axial Turbine Rotor using Tip Platform Extensions[R].ASME 2001-GT-0484.
[12] Akamol Shavalikul, Cengiz Camci.A Comparative Anslysis of Pressure Side Extensions for Tip Leakage Control in Axial Turbines.[R].ASME 2008-GT-50782.
[13] Kusterer K, Moritz N,Bohn D, et al.Reduction of Tip Clearance Losses in an Axial Turbine by Shaped Design of the Blade Tip Region[R].ASME 2007-GT-27303.
[14] 蔡晋, 陈波, 闫雪,等.带小翼肋条的涡轮叶尖泄漏流场的数值模拟[J].动力工程学报, 2010,0(12):919-925.
[15] 王生武, 石秀华.涡轮叶尖压力边小翼肋条对泄漏流场的数值模拟[J].计算机测量与控制, 2009,7(8):1527-1534.