采用脉冲爆震外涵加力燃烧室的涡扇发动机性能研究

推进技术 ›› 2014, Vol. 35 ›› Issue (6): 858-864.

• 电推进和其它推进 • 上一篇

采用脉冲爆震外涵加力燃烧室的涡扇发动机性能研究

卢杰,郑龙席,王治武,彭畅新

西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072

发布日期:2021-08-15
作者简介:卢杰(1988—)，男，博士生，研究领域为爆震推进技术、发动机燃烧与流动。E-mail:lujie2012@mail.nwpu.edu.cn
基金资助:
国家自然科学基金(51306153)；陕西省自然科学基金(2010JQ7005)；高等学校博士学科点专项科研基金新教师类资助课题(20116102120027)；西北工业大学基础研究基金(NPU-FFR-JXY20130129)。

Investigation on Performance of Pulse Detonation Turbine Engine with PDC as a Duct Heater

School of Power and Energy，Northwestern Polytechnical University，Xi ’ an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi ’ an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi ’ an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi ’ an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究带外涵加力脉冲爆震燃烧室(Pulse detonation combustor，PDC)的分开排气涡扇发动机性能，建立了其性能模型。利用该模型对带PDC外涵加力原理性试验模型的性能进行了评估，同时选取涡扇发动机对该发动机采用PDC外涵加力后的部件特性及整机性能进行研究，并比较了等燃油流量下外涵道装有PDC和传统等压燃烧室的发动机性能。理论计算结果和实验值对比表明，加装合适的喷管结构能够大大提高该原理性试验模型的推力性能。算例的计算结果显示:随着PDC工作频率的提高，发动机总推力增加，耗油率增大；在同一工作频率下，PDC平均增压比、平均出口温度和发动机总推力在当量比1.1左右达到最大值，发动机总耗油率随着当量比的增大而增加；当PDC工作频率超过50Hz时，外涵道装有PDC的发动机总推力大于外涵道装有传统等压燃烧室的发动机推力，且耗油率要小。

关键词: 脉冲爆震涡轮发动机；性能；部件特性；当量比

Abstract: A new model was developed to investigate the performance of turbofan engine with PDCs (pulse detonation combustors) in the bypass duct. The model was used to predict the thrust performance of an experimental system designed as a pulse detonation turbine engine with PDCs in the bypass duct. Further more，the component characteristics of a specific turbofan engine with PDCs in the bypass duct were investigated and the performance was compared with the same turbofan engine in which a traditional constant pressure combustor was installed in the bypass duct under the same mass flow rate of fuel. The results show that the predicted performance is higher than the experimental data，indicating that the experimental performance can be improved when suitable nozzle is placed downstream of the PDC exit. Additionally，while increasing operating frequency，the total thrust and specific fuel consumption of the engine increase. When the operating frequency holds constant，the pressure ratio，the averaged exit temperature of the PDC and the total thrust of the engine reach maximum at the equivalence ratio about 1.1，but the specific fuel consumption rate increases with increasing of equivalence ratio. Contrasted with the traditional constant pressure combustor in the bypass duct，the total thrust and specific fuel consumption are better when the PDC in the bypass duct operates with a frequency higher than 50Hz.

Key words: Pulse detonation turbine engine；Performance；Component characteristics；Equivalence ratio

卢杰,郑龙席,王治武,彭畅新. 采用脉冲爆震外涵加力燃烧室的涡扇发动机性能研究[J]. 推进技术, 2014, 35(6): 858-864.

LU Jie,ZHENG Long-xi,WANG Zhi-wu,PENG Chang-xin. Investigation on Performance of Pulse Detonation Turbine Engine with PDC as a Duct Heater[J]. Journal of Propulsion Technology, 2014, 35(6): 858-864.

参考文献

[1] 严传俊，范玮，郑龙席，等. 脉冲爆震发动机原理及关键技术 [M]. 西安: 西北工业大学出版社， 2005.
[2] Wintenberger E. Application of Steady and Unsteady Detonation aves to Propulsion [D]. Pasadena: California Institute of Technology ， 2004: 34-41.
[3] 严传俊，范玮，黄希桥，等. 脉冲爆震发动机性能分析[J]. 工程热物理学报， 2004， 25(1): 217-220.
[4] Ma F， Choi J Y， Yang V. Propulsive Performance of Airbreathing Pulse Detonation Engines [J]. Journal of Propulsion and Power ， 2006， 22(6): 1188-1203.
[5] Mawid M A， Park T W， Sekar B. Performance Analysis of a Pulse Detonation Device as an Afterburner[R]. AIAA 2000-3474.
[6] Rasheed A， Furman A H， Dean A J. Experimental Investigations of an Axial Turbine Driven By a Multi-tube Pulsed Detonation Combustor System[R]. AIAA 2005-4209.
[7] Andrus I Q， King P I. Evaluation of a High Bypass Turbofan Hybrid Utilizing a Pulsed Detonation Combustor[R]. AIAA 2007-5074.
[8] 邓君香，严传俊，郑龙席，等. 装有脉冲爆震主燃烧室的燃气涡轮发动机热力性能计算 [J]. 西北工业大学学报， 2008， 26(3): 362-367.
[9] Chen Wenjuan， Fan Wei， Qiu Hua， et al. Thermodynamic Performance Analysis of Turbofan Engine with a Pulse Detonation Duct Heater [J]. Aerospace Science and Technology ， 2012， 23(1)， 206-212.
[10] 何龙，郑龙席，邱华，等. 脉冲爆震涡轮发动机性能计算[J]. 推进技术， 2012， 33(005): 665-670. (HE Long， ZHENG Long-xi， QIU Hua， et al. Calculating Performance of Pulse Detonation Turbo Engine [J]. Journal of Propulsion Technology ， 2012， 33(5): 665-670. )
[11] Endo T， Fujiwara T. A Simplified Analysis on a Pulse Detonation Engine Model [J]. Transactions of the Japan Society for Aeronautical and Space Sciences， 2002， 44(146):217-222.
[12] Endo T， Fujiwara T. Analytical Estimation of Performance Parameters of an Ideal Pulse Detonation Engine [J]. Transactions of the Japan Society for Aeronautical and Space Sciences ， 2003， 45(150): 249-254.
[13] Endo T， Kasahara J， Matsuo A， et al. Pressure History at The Thrust Wall of a Simplified Pulse Detonation Engine [J]. AIAA Journal， 2004， 42(9): 1921-1930.
[14] 廉筱纯，吴虎. 航空燃气轮机原理 [M]. 西安: 西北工业大学出版社， 2005.

采用脉冲爆震外涵加力燃烧室的涡扇发动机性能研究

Investigation on Performance of Pulse Detonation Turbine Engine with PDC as a Duct Heater

PDF

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价