高负荷轴流压气机叶栅二次流动与损失关联性探讨

推进技术 ›› 2014, Vol. 35 ›› Issue (7): 914-925.

高负荷轴流压气机叶栅二次流动与损失关联性探讨

李相君¹,楚武利^1,2,张皓光¹

西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072; 先进航空发动机协同创新中心，北京 100191;西北工业大学动力与能源学院，陕西西安 710072

发布日期:2021-08-15
作者简介:李相君(1989—)，男，博士生，研究领域为叶轮机械气动热力学。
基金资助:
国家自然科学基金重点项目(51236006)。

Investigation on Relation Between Secondary Flow and Loss on a High Loaded Axial-Flow Compressor Cascade

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China; Collaborative Innovation Center of Advanced Aero-Engine，Beijing 100191，China;School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 为探讨压气机中二次流与损失生成的关联性，对一高负荷轴流压气机叶栅开展数值模拟研究。首先对叶栅流动进行定性分析，在此基础上推导定量模型估算流场中的损失源，并由此获得二次流动诱发损失的机理与影响。研究结果显示，在大部分攻角范围内，二次流诱发的损失未超过50%。相对于二次流间接作用于低速流而诱发的损失而言，其直接耗散产生的损失仅为小量；在角区失速时的详细观测也显示，通道横流的流向变化，也即二次流对低速流间接影响的变化是导致通道内损失随攻角激增的主要原因。

关键词: 压气机；叶栅；二次流；损失

Abstract: Numerical investigation was carried out to study the relation between secondary flow and loss generation in a high-loaded compressor cascade. Based on a series of qualitative analysis，a new quantitative analysis model has been derived further to attain the loss contribution of various sources，and the mechanism and effects of secondary flow on loss generation were finally conformed. The results show that loss due to secondary flow does not exceed 50% under a wide range of inlet attack angles. The indirect effect of secondary flow on low speed region is identified to dominate its contribution to loss with its direct dissipating remaining small magnitude order. A detailed research about the mechanism of the steep loss increase near corner stall also indicates that change in direction of cross flow，which is the change of indirect effect of secondary flow on low speed region， is mainly responsible as the incidence increases.

Key words: Compressor；Cascade；Secondary flow；Loss

李相君,楚武利,张皓光. 高负荷轴流压气机叶栅二次流动与损失关联性探讨[J]. 推进技术, 2014, 35(7): 914-925.

LI Xiang-jun¹,CHU Wu-li^1,2,ZHANG Hao-guang¹. Investigation on Relation Between Secondary Flow and Loss on a High Loaded Axial-Flow Compressor Cascade[J]. Journal of Propulsion Technology, 2014, 35(7): 914-925.

参考文献

[1] Lei V M, Spakovszky Z S, Greitzer E M. A Criterion for Axial Compressor Hub-Corner Stall[J]. Journal of Turbomachinery, 2008, 130(7).
[2] Dorfner C, Hergt A, Nicke E, et al. Advanced Nonaxisymmetric Endwall Contouring for Axial Compressors by Generating an Aerodynamic Separator—Part I: Principal Cascade Design and Compressor Application[J]. Journal of Turbomachinery, 2011, 133(4).
[3] Reising S, Schiffer H-P. Non-Axisymmetric End Wall Profiling in Transonic Compressors. Part I: Improving the Static Pressure Recovery at Off-Design Conditions by Sequential Hub and Shroud End Wall Profiling[R]. ASME 2011-GT-59133.
[4] Harvry N W. Some Effects of Non-Axisymmetric End Wall Profiling on Axial Flow Compressor Aerodynamics. Part I: Linear Cascade Investigation[R]. ASME 2008-GT-50990.
[5] Hergt A, Dorfner C, Steinert W, et al. Advanced Nonaxisymmetric Endwall Contouring for Axial Compressors by Generating an Aerodynamic Separator—Part II: Experimental and Numerical Cascade Investigation[J]. Journal of Turbomachinery, 2011, 133(4).
[6] Harvry N W, Offord T P. Some Effects of Non-Axisymmetric End Wall Profiling on Axial Flow Compressor Aerodynamics. Part II: Multi-Stage HPC CFD Study[R]. ASME 2008-GT-50991.
[7] Ortmanns J, Pixberg C, Gümmer V. Numerical Investigation of Vortex Generators to Reduce Cross-Passage Flow Phenomena in Compressor Stator End-Walls[J].Journal of Power and Energy, 2011, 225(Part A):877-885.
[8] Hergt A, Meyer R, Engel K. Effects of Vortex Generator Application on the Performance of a Compressor Cascade[J]. Journal of Turbomachinery, 2013, 135(3).
[9] Hergt A, Meyer R, Liesner K, et al. A New Approach for Compressor Endwall Contouring[R].ASME 2011-GT-45858.
[10] 张燕峰. 高载荷压气机端壁流动及其控制策略研究 [D].西安:西北工业大学, 2010.
[11] 刘华坪, 陈焕龙, 杨晓光, 等. 基于耗散函数的低速扩压叶栅损失机理探讨 [J].航空动力学报, 2011, 26(2):289-296.
[12] 陈懋章.粘性流体力学 [M]. 北京: 高等教育出版社, 2002: 38-42.
[13] Reising S, Schiffer H-P. Non-Axisymmetric End Wall Profiling in Transonic Compressors.Part II: Design Study of a Transonic Compressor Rotor Using Non-Axisymmetric End Walls-Optimization Strategies and Performance[R]. ASME 2011-GT-59134.
[14] Müller R, Sauer H, Vogeler K, et al. Influencing the Secondary Losses in Compressor Cascades by a Leading Edge Bulb Modification at the Endwall[R].ASME 2002-GT-30442.
[15] 童秉纲, 尹协远, 朱克勤. 涡运动理论 [M].合肥: 中国科学技术大学出版社, 2009: 16-17.
[16] Gaddebo S A, Cumpsty N A, Hynes T P. Three Dimensional Separations in Axial Compressor[J]. Journal of Turbomachinery, 2005, 127(4).(编辑:梅瑛)收稿日期:2013-07-10；修订日期:2013-09-06。基金项目:国家自然科学基金重点项目(51236006)。作者简介:李相君(1989—),男,博士生,研究领域为叶轮机械气动热力学。E-mail:932053832@qq.com