单板环形分配器式扩压器性能的进一步研究

推进技术 ›› 2014, Vol. 35 ›› Issue (9): 1241-1246.

单板环形分配器式扩压器性能的进一步研究

赵聪聪,索建秦,梁红侠,王铮钧

西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072;西北工业大学动力与能源学院，陕西西安 710072

发布日期:2021-08-15
作者简介:赵聪聪(1989—)，女，硕士生，研究领域为航空发动机燃烧室。

Further Research for Single-Plate Annular Distributor Type Diffuser Performance

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China;School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 研究了随着燃烧室进口马赫数不断提高时单板环形分配器式扩压器的总压损失、静压恢复和扩压器流态问题。采用计算流体力学(CFD)方法，对矩形分配器式扩压器进行数值模拟，将其结果与矩形分配器式扩压器试验结果对比，得出边界条件设置方法，对单板环形分配器式扩压器进行了数值模拟。燃烧室进口马赫数从0.291增加到0.420。结果表明:矩形分配器式扩压器的数值模拟结果与试验结果较为吻合，误差在±5%之内；随着燃烧室进口马赫数的不断提高，单板环形分配器式扩压器的性能下降。在马赫数高达0.420时，单板环形分配器式扩压器内流动没有分离，静压恢复为0.870，总压损失为1.346%，表明其性能比短突扩扩压器的性能好，在一定程度上能够满足下一代先进燃气轮机燃烧室对扩压器的要求。

关键词: 燃烧室；单板环形分配器式扩压器；数值模拟；总压损失；静压恢复；流场分布

Abstract: Total pressure loss，static pressure recovery and flow state of annular distributor type diffuser performance as increasing inlet Mach number are researched. At first using computational fluid dynamics method，the rectangle distributor type diffuser is simulated. The simulation result is compared with experiments. Then the boundary settings are derived，and the annular distributor type diffuser is simulated. The inlet Mach number of combustor increases from 0.290 to 0.420. The results demonstrate that，simulation results coincide with experiments of rectangle distributor type diffuser. The deviation is within ±5%. As the inlet Mach number of combustor increases，the performance of annular distributor type diffuser suffers. When the inlet Mach number is 0.420，there is no separation in the annular distributor type diffuser. The pressure recovery coefficient is 0.870 and the total pressure loss coefficient is 1.346% which means the performance is better than that of dump diffuser.

Key words: Combustor；Single-plate annular distributor type diffuser；Numerical simulation；Total pressure loss；Static pressure recovery；Flow profile

赵聪聪,索建秦,梁红侠,王铮钧. 单板环形分配器式扩压器性能的进一步研究[J]. 推进技术, 2014, 35(9): 1241-1246.

ZHAO Cong-cong,SUO Jian-qin,LIANG Hong-xia,WANG Zheng-jun. Further Research for Single-Plate Annular Distributor Type Diffuser Performance[J]. Journal of Propulsion Technology, 2014, 35(9): 1241-1246.

参考文献

[1] Arthur H Lefebvre.Gas Turbine Combustion[M].New York: CRC press Taylor & Francis,2010.
[2] 严传俊,范玮.燃烧学[M].西安: 西北工业大学出版社,2008.
[3] 刘长福,邓明.航空发动机结构分析[M].西安: 西北工业大学出版社,2006.
[4] M Sasaki M.Low NO_x Combustor for Automotive Ceramic Gas Turbine Conc-Eptual Design[R].ASME 91-GT-369.
[5] 金如山.航空燃气轮机燃烧室[M].北京: 宇航出版社,1988.
[6] Mehta R D.Turbulent Boundary Layer Perturbed by a Screen[J].AIAA Journal,1985,23(9): 1335-1342.
[7] Schubauer G B,Spangenberg W G.Effect of Screens in Wide-Angle Diffuser[R].NACA TP-949,1947: 545-584
[8] Charles H McLellan,Mark R Nichols.An Investigation of Diffuser-Resistance Combinations in Duct Systems[R].NACA tpl-329,1942.
[9] 黄熙君,董金钟.扩压器流场分离的涡控技术研究[J].航空学报,1991,12(10): 464-469.
[10] Noui-Mehidi M N,Wu J,Sutalo I D,et al.Velocity Distribution Downstream of an Asymmetric Wide-Angle Diffuser[J].Experimental Thermal and Fluid Science,2009,(25):649-657.
[11] Fishenden C R,Stevens S J.The Performance of Annular Combustor-Dump Diffuser[J].Journal of Aircraft,1977,14(1): 60-67.
[12] Ward-Smith A J,Lane D,Reynolds A J,et al.Flow Regimes in Wide-Angle Screened Diffusers[J].International Journal of Mechanical Sciences,1991,33(1): 41-54.
[13] B Sahin,A J Ward-Smith.The Pressure Distribution in and Flow Characteristics of Wide-Angle Diffusers using Perforated Plates for Flow Control with Application to Electrostatic Precipitators[J].International Journal of Mechanical Sciences,1993,35(2):117-127.
[14] 徐行,黄勇.燃烧室流动的计算[R].北京航空航天大学科技报告,96～037: 199~204.
[15] 王蓉隽,索建秦,梁红侠,等.燃烧室分配器式扩压器性能数值研究[J].推进技术.2011,32(3): 343-347.(WANG Rong-juan,SUO Jian-qin,LIANG Hong-xia,et al.Numerical Study of Distributor Type Diffuser Performance for Combustor[J].Journal of Propulsion Technology,2011,32(3): 343-347.)
[16] 赵聪聪,索建秦,梁红侠,等.环形分配器式扩压器性能数值模拟[J].推进技术,2013,34(2):209-214.(ZHAO Cong-cong,SUO Jian-qin,LIANG Hong-xia,et al.Numerical Simulation for Annular Distribrtor Type Diffuser Performance[J].Journal of Propulsion Technology,2013,34(2):209-214.)
[17] 李瀚.燃烧室分配器式扩压器性能试验研究[D].西安: 西北工业大学,2012.
[18] 韩占忠,王敬,兰小平.Fluent 流体工程仿真计算实例与应用[M].北京: 北京理工大学出版社,2004.(编辑:朱立影)收稿日期:2013-07-05；修订日期:2013-10-26。作者简介:赵聪聪(1989—),女,硕士生,研究领域为航空发动机燃烧室。E-mail:997402417@qq.com