不同攻角下端壁射流旋涡控制扩压叶栅分离流动研究

推进技术 ›› 2015, Vol. 36 ›› Issue (1): 54-60.

不同攻角下端壁射流旋涡控制扩压叶栅分离流动研究

冯岩岩,宋彦萍,刘华坪,陈浮

哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:冯岩岩(1989—)，女，博士生，研究领域为叶轮机械气动热力学。
基金资助:
国家自然科学基金(50976026)；国家自然科学基金委创新研究群体基金(51121004)。

Effects of End-Wall Vortex Generator Jet on Flow Separation Control in Compressor Cascade under Different Angles of Attack

School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China and School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究端壁射流旋涡对扩压叶栅分离流动及性能的影响，采用数值模拟的方法，对不同攻角下带有端壁射流的50°折转角扩压叶栅进行了研究。结果表明:具有最优射流结构的旋涡发生器有效减弱了叶栅角区分离，零攻角下出口总压损失降低了8.9%；随着攻角的上升，射流对扩压叶栅气动性能的改善越显著；射流产生的旋涡可阻挡端壁低能流体向吸力面的迁移，并将主流流体卷入角区，角区流体动量增加、流动分离减弱，但旋涡与端壁二次流的掺混使得10%叶高以下的损失略微增大；射流参数决定了射流旋涡与吸力面的相对位置以及旋涡强度，对射流控制栅内流动分离效果有重大影响，需合理选择。

关键词: 扩压叶栅；端壁射流式旋涡发生器；流动分离；攻角

Abstract: The application of end-wall vortex generator jet (VGJ) to a compressor cascade with a 50° camber angle for flow separation control was studied using numerical simulation. The results show that under zero-incidence， the optimum VGJ can weaken the flow separation of the corner region effectively and lead to 8.9% descent of the total pressure loss at outlet. With the angle of attack rising， the jet also improves the aerodynamic performance of compressor cascade obviously. The jet vortex entrains high energy fluid to the corner region， resulting in the increase of corner fluid momentum and the alleviation of flow separation. However， the loss in the region below 10% blade height increases slightly due to the mixing between jet vortex and secondary flow near the end-wall. The distance between jet vortex and suction surface and the intensity of jet vortex decided by the jet parameters are important for the effect of jet on flow separation control in the compressor cascade. It is suggested that the jet parameters be chosen reasonably.

Key words: Compressor cascade；End-wall vortex generator jet；Flow separation；Angle of attack

冯岩岩,宋彦萍,刘华坪,陈浮. 不同攻角下端壁射流旋涡控制扩压叶栅分离流动研究[J]. 推进技术, 2015, 36(1): 54-60.

FENG Yan-yan, SONG Yan-ping, LIU Hua-ping, CHEN Fu. Effects of End-Wall Vortex Generator Jet on Flow Separation Control in Compressor Cascade under Different Angles of Attack[J]. Journal of Propulsion Technology, 2015, 36(1): 54-60.

参考文献

[1] Lee S, Loth E, Babinsky H. Normal Shock Boundary Layer Control with Vortex Generator Geometries[J]. Computers & Fluids, 2011, (49): 233-246.
[2] Qi L, Zou Z P, Wang P, et al. Control of Secondary Flow Loss in Turbine Cascade by Streamwise Vortex [J]. Computers & Fluids, 2012, (54): 45-55.
[3] Khan Z U, Johnston J P. On Vortex Generating Jets [J]. International Journal of Heat and Fluid Flow, 2000, (21): 506-511.
[4] Hansen L Bons J. Flow Measurements of Vortex Generator Jets in Separating Boundary Layer[J]. Journal of Propulsion and Power, 2006, 22(3): 558-566.
[5] 张攀峰, 王晋军. 孔口倾斜角对合成射流控制翼型流动分离的影响[J]. 兵工学报, 2009, 30(12): 1658-1662.
[6] Scholz P, Mahmood S S, Casper M, et al. Experimental and Numerical Investigations on the Control of Airfoil Stall Using Vortex Generator Jets[R]. AIAA 2010-4250.
[7] Sondergaard R, Rivir R B, Bons J P. Control of Low-Pressure Turbine Separation Using Vortex-Generator Jets[J]. Journal of Propulsion and Power, 2002, 18(4):889-895.
[8] 张漫, 乔渭阳. 射流式旋涡发生器对涡轮流动分离控制[J]. 推进技术, 2008, 29(1):67-74. (ZHANG Man, QIAO Wei-yang.Numerical Simulation of the Vortex Generator Jets for Low-Pressure Turbine Separation Control [J]. Journal of Propulsion Technology, 2008, 29(1): 67-74.)
[9] Evans S, Hodson H, Hynes T, et al. Controlling Separation on A Simulated Compressor Blade Using Vortex-Generator Jets[J]. Journal of Propulsion and Power, 2010, 26(4): 819-827.
[10] Evans S, Coull J, Haneef I, et al. Minimizing the Loss Produced by A Turbulent Separation Using Vortex Generator Jets[J]. AIAA Journal, 2012, 50(4): 778-787.
[11] Zhou Y, Liu H X, Zou Z P, et al. Boundary Layer Separation Control on A Highly-Loaded, Low-Solidity Compressor Cascade[J]. Journal of Thermal Science, 2010, 19(2): 97-104.
[12] Hecklau M, Wiederhold O, Zander V, et al. Active Separation Control with Pulsed Jets in A Critically Loaded Compressor Cascade [J]. AIAA Journal, 2011, 49(8): 1729-1739.
[13] 郑新前, 周晓勃, 侯安平, 等. 合成射流速度特性的实验研究[J]. 推进技术,2005, 26(6):504-507.(ZHENG Xin-qian, ZHOU Xiao-bo, HOU An-ping, et al.Experimental Study on Velocity Characteristics of Synthetic Jet Actuator[J]. Journal of Propulsion Technology, 2005, 26(6): 504-507.)
[14] Zheng X Q, Zhou S, Hou A P, et al. Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade[J]. Acta Mechanica Sinica, 2006, (22): 521-527.
[15] 周晓勃, 周盛, 侯安平, 等. 射流对压气机叶栅分离流控制的数值研究[J]. 航空学报, 2007, (28): 7-13.
[16] 陈绍文. 不同折转角压气机叶栅中应用弯曲叶片的实验与数值研究[D]. 哈尔滨:哈尔滨工业大学, 2007.(编辑:朱立影)　　　　　　　　　　　　　*　收稿日期:2014-01-14；修订日期:2014-03-06。基金项目:国家自然科学基金(50976026)；国家自然科学基金委创新研究群体基金(51121004)。作者简介:冯岩岩(1989—),女,博士生,研究领域为叶轮机械气动热力学。E-mail:fengyanyanhit@163.com