高负荷扩压叶栅三维定常旋涡结构建模研究

推进技术 ›› 2015, Vol. 36 ›› Issue (6): 852-863.

高负荷扩压叶栅三维定常旋涡结构建模研究

钟兢军,康　达,陆华伟,张永超

大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026

发布日期:2021-08-15
作者简介:钟兢军(1963—)，男，博士，教授，研究领域为叶轮机械气动热力学。E-mail:zhongjj@dlmu.edu.cn 通讯作者:陆华伟(1980—)，男，博士，副教授，研究领域为叶轮机械气动热力学。
基金资助:
国家自然科学基金(51206013，51436002)；高等学校博士学科点专项科研基金(20112125120009)；

Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade

Marine Engineering College，Dalian Maritime University，Dalian 116026，China Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade,Marine Engineering College，Dalian Maritime University，Dalian 116026，China Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade,Marine Engineering College，Dalian Maritime University，Dalian 116026，China Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade and Marine Engineering College，Dalian Maritime University，Dalian 116026，China Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade

Published:2021-08-15

摘要/Abstract

摘要： 为进一步认识高负荷扩压叶栅内的流动机理和旋涡演变规律，采用经试验校核的数值方法，以具有60°折转角的NACA65-010叶型为研究对象，运用拓扑分析理论，探讨了叶栅流道内马蹄涡、通道涡、集中脱落涡和壁角涡等二次旋涡的生成、演绎与发展。分析认为，在高负荷扩压叶栅中，对流场影响最大的涡系结构为通道涡，通道涡在130%B截面转变为稳定的内旋结构，流道内的壁角涡由通道涡诱导形成，而出口角涡则是在叶片尾缘出口绕流与通道涡的综合作用下形成的，流场出口最终呈现出通道涡与集中脱落涡并存的稳定结构。最后给出了0°冲角下的三维旋涡结构示意图。

关键词: 扩压叶栅；旋涡结构；拓扑分析；二次流

Abstract: For further understanding the flow mechanism and vortex evolution law in a highly loaded compressor cascade，NACA65-010 blade profile with camber angle of 60° was selected. The formation，evolution and development of secondary flow vortices，including horse shoe vortex(HV)，passage vortex(PV)，concentrated shed vortex(CSV)，corner vortex(CV) and so on，were analyzed with the method of topological analysis and numerical simulation. And the numerical method was validated by experimental results. The analysis shows that PV has the most impact on the flow field，and it turns to be stable structure in 130%B section. The CV in the cascade passage are induced by PV，and the CV at outlet is induced by the combined action of PV and reverse flow from pressure surface to suction surface at outlet. Finally，the flow structure in cross section presents a profile of coexistence of PV with CSV. In the end，a vortex structure at incidence of 0° was provided.

Key words: Compressor cascade；Vortex structure；Topological analysis；Secondary flow

钟兢军,康　达,陆华伟,张永超. 高负荷扩压叶栅三维定常旋涡结构建模研究[J]. 推进技术, 2015, 36(6): 852-863.

ZHONG Jing-jun,KANG Da,LU Hua-wei,ZHANG Yong-chao. Study on Three-Dimensional Steady Vortex Structure in a Highly Loaded Compressor Cascade[J]. Journal of Propulsion Technology, 2015, 36(6): 852-863.

参考文献

[1] 张华良, 王松涛, 王仲奇. 冲角对压气机叶栅内二次涡的影响[J].航空动力学报, 2006, 21(1):15-155.
[2] ZHANG Yong-jun, WANG Hui-she, XU Jian-zhong, et al. Study on Topology and Vortex Structure in a Diffusion Cascade[J].Science in China Series E, 2009, 52(8):2305-2315.
[3] KANG Shun. Investigation on the Three-Dimensional Flow within a Compressor Cascade with and without Tip Clearance[D].Brussels: Vrije University Brussels, 1993.
[4] 王松涛, 吴猛, 王仲奇, 等. 通道涡稳定性及对损失的影响[J].工程热物理学报, 2000, 21(4):425-429.
[5] 陆华伟, 郭爽, 钟兢军, 等. 带根部间隙压气机静叶流道流动结构研究[J].工程热物理学报, 2012, 33(1):51-54.
[6] 于宏军, 刘宝杰, 刘火星, 等. 设计状态下压气机转子叶尖泄漏涡流动研究[J].航空学报, 2004, 25(1):1-8.
[7] ZHAO Xiao-hu, LI Ying-hong, WU Yun, et al. Numerical Investigation of Flow Separation Control on a Highly Loaded Compressor Cascade by Plasma Aerodynamic Actuation[J].Chinese Journal of Aeronautics, 2012, 25(3):349-360.
[8] 周逊, 韩万金. 涡轮矩形叶栅中的旋涡模型的进展回顾[J].航空动力学报, 2001, 16(3):199-204.
[9] 唐燕平, 陈懋章, 陈芳. 扩压叶栅中的旋涡流动[J].航空动力学报, 1990, 5(2):103-186.
[10] Inoue M, Kuroumarou M. Three-Dimensional Structure and Decay of Vortices Behind and Axial Flow Rotation Blade Row[J].Journal of Engineering for Gas Turbines and Power-Transactions of the ASME, 1984, 106(3):561-569.
[11] 郭爽, 陆华伟, 宋彦萍, 等. 端壁附面层抽吸对大转角扩压叶栅旋涡影响的实验研究[J].推进技术, 2013, 34(11):1466-1473.(GUO Shuang, LU Hua-wei, SONG Yan-ping, et al. Experimental Investigation on Effects of Endwall Boundary Layer Suction on Vortexes of High-Turning Compressor Cascades[J].Journal of Propulsion Technology, 2013, 34(11):1466-1473.)
[12] 陈浮, 陈绍文, 郭爽, 等. 高负荷压气机叶栅分离与流场结构研究[J].工程热物理学报, 2008, 29(1):49-51.
[13] GUO Shuang, LU Hua-wei, CHEN Fu, et al. Vortex Control and Aerodynamic Performance Improvement of a Highly Loaded Compressor Cascade via Inlet Boundary Layer Suction[J].Experiments in Fluids, 2013, 54:1570.
[14] GUO Shuang, CHEN Shao-wen, LU Hua-wei, et al. Enhancing Aerodynamic Performance of a High-Turning Compressor Cascade via Boundary Layer Suction[J].Science in China Series E, 2010, 53(10):2748-2755.
[15] 王学德, 赵小虎, 王路成. 高负荷压气机叶栅等离子体流动控制数值仿真与拓扑分析[J].推进技术, 2013, 34(10):1321-1329.(WANG Xue-de, ZHAO Xiao-hu, WANG Lu-cheng. Numerical Investigation and Topological Analysis of Plasma Flow Control on a Highly Loaded Compressor Cascade[J].Journal of Propulsion Technology, 2013, 34(10):1321-1329.)
[16] ZHONG Jing-jun, HAN Shao-bing, LU Hua-wei, et al. Effect of Tip Geometry and Tip Clearance on the Aerodynamic Performance of a Linear Compressor Cascade[J].Chinese Journal of Aeronautics, 2013, 26(3):583-593.
[17] KANG Shun. An Application of Topological Analysis to Studying the Three-Dimensional Flow in Cascades: Part I-Topological Rules for Skin-Friction Lines and Section Streamlines[J].Applied Mathematics and Mechanics, 1990, 11(5):489-495.
[18] 张涵信. 旋涡沿轴线的非线性分叉[J].空气动力学学报, 1994, 12(3):243-251.(编辑:刘萝威)　　　　　　　　　　　　　*　收稿日期:2014-05-08；修订日期:2014-06-25。基金项目:国家自然科学基金(51206013,51436002)；高等学校博士学科点专项科研基金(20112125120009)；中央高校基本科研业务专项资金(3132015026)。作者简介:钟兢军(1963—),男,博士,教授,研究领域为叶轮机械气动热力学。E-mail:zhongjj@dlmu.edu.cn 通讯作者:陆华伟(1980—),男,博士,副教授,研究领域为叶轮机械气动热力学。E-mail:hwlu66@163.com