高超声速内外流解耦试验系统设计与验证

推进技术 ›› 2015, Vol. 36 ›› Issue (6): 920-926.

高超声速内外流解耦试验系统设计与验证

王泽江^1,2,李绪国²,孙　鹏²,唐小伟²

西北工业大学航空学院，陕西西安 710072;中国空气动力研究与发展中心，四川绵阳 621000,中国空气动力研究与发展中心，四川绵阳 621000,中国空气动力研究与发展中心，四川绵阳 621000,中国空气动力研究与发展中心，四川绵阳 621000

发布日期:2021-08-15
作者简介:王泽江(1972—)，男，博士生，副研究员，研究领域为高超声速空气动力学。

Design and Verification for Hypersonic External and Internal Decoupling Test System

School of Aeronautics，Northwestern Polytechnical University，Xi’an 710072，China; China Aerodynamic Research and Development Center，Mianyang 621000，China,China Aerodynamic Research and Development Center，Mianyang 621000，China,China Aerodynamic Research and Development Center，Mianyang 621000，China and China Aerodynamic Research and Development Center，Mianyang 621000，China

Published:2021-08-15

摘要/Abstract

摘要： 在模型上将高度耦合的内外流气动力载荷分开，是吸气式高超声速飞行器直接测力试验的关键。为探索相关设计技术，以圆截面通气模型为研究对象，通过相互独立的内/外流部件实现内外流分离；通过计算机辅助内/外流部件间隙与天平设计，特别是内/外流部件间隙开口位置与尺寸确定，来解决内/外流部件接触问题；通过软填料密封解决内外流窜流问题，并对试验干扰因素进行了分析，在Ma=6条件下开展了验证试验。典型试验对比结果表明，部件间隙开口位置和尺寸适当、天平刚度较大时，内/外流部件无接触、不传力；间隙开口采用软填料密封，内外流不窜流、干扰小。试验证明，该系统设计是成功的，能从物理上将内/外流气动力载荷分开，测量误差可分别控制在3%、4%左右。

关键词: 高超声速；风洞试验；模型设计；天平；内外流解耦；计算机辅助设计；软密封

Abstract: It is the key for the air-breathing hypersonic vehicle direct force tests to separate the external and internal aerodynamic loads highly coupled on the model. In order to explore the related design technologies，a circular cross section venting model is taken as?research?object. The external and the internal separation by the independent external and internal parts is realized，and the conduct problem between the external and internal parts is solved by CAD-aided designing the parts clearances and the balances，especially the open positions and sizes of the parts clearances sizing. The cross-flow problem between the external and internal flow is solved by the soft packing seal，the error factors which may affect the test result precision are discussed and a wind tunnel test at Mach 6 is conducted. The contrastive analysis of the typical tests results show that，while the open positions and sizes of the parts clearance are proper and the balance stiffness is large，the external and internal parts have non-contact and non-force transfer. Adopting soft packing seal，the external and internal have not cross-flow and the interference is little. The results of the test indicate that，the test system design is successful，the external and internal aerodynamic loads can be separated from each other in physics，and the measurement error can be kept in about 4% and 3%，respectively.

Key words: Hypersonic；Wind tunnel tests；Model design；Balance；External and internal decoupling；CAD-aided design；Soft seal

王泽江,李绪国,孙　鹏,唐小伟. 高超声速内外流解耦试验系统设计与验证[J]. 推进技术, 2015, 36(6): 920-926.

WANG Ze-jiang^1,2,LI Xu-guO²,SUN Peng²,TANG Xiao-wei². Design and Verification for Hypersonic External and Internal Decoupling Test System[J]. Journal of Propulsion Technology, 2015, 36(6): 920-926.

参考文献

[1] Holland Scott D, Woods William C, Engelund Walter C. Hyper-X Research Vehicle Experimental Aerodynamics Test Program Overview [J]. Journal of Spacecraft and Rockets, 2001, 38(6): 11-12.
[2] 乐嘉陵.吸气式高超声速技术研究进展[J].推进技术, 2010, 31(6): 641-649. (LE Jia-ling. Progress in Air-Breathing Hypersonic Technology [J]. Journal of Propulsion Technology, 2010, 31(6): 641-649.)
[3] 罗金玲, 徐敏, 刘杰. 一体化外形的高超声速飞行器升阻特性研究[J]. 宇航学报, 2007, 28( 6 ): 1478-1481.
[4] 白菡尘, 王泽江. 高超声速冲压发动机─飞行器计力体系讨论[J]. 推进技术, 2012, 33(1): 1-6. (BAI Han-chen, WANG Ze-jiang. Discussion on Force-Accounting System for Air-Breathing Hypersonic Vehicle [J]. Journal of Propulsion Technology, 2012, 33(1): 1-6.)
[5] 张红英, 程克明, 伍贻兆.某高超飞行器流道冷流特征及气动力特性研究 [J].空气动力学学报, 2009, 27(1): 119-123.
[6] Shibin Luo, Wei Huang, Jing Lei, et al. Drag Force Characteristic of a Typical Dual-Mode Scramjet Combustor [C]. 2010 2nd International Conference on Computer Engineering and Technology,2010.
[7] Tohru Mitani, Kan Kobayashi, Tetsuo Hiraiwa, et al. Evaluation of Internal Aerodynamic Performance in Scramjet Engines [R]. AIAA 2001-1885.
[8] 王永寿. 超燃冲压发动机的三分力测量(一)—Ma=4～8飞行条件下的发动机阻力[J]. 飞航导弹, 2004, 7: 42-49.
[9] Engelund Walter C, Holland Scott D, Charles E. Aerodynamic Database Development for the Hyper-X Airframe Integrated Scramjet Propulsion Experiments [R]. AIAA 2000-4006.
[10] 贺元元, 乐嘉陵, 倪鸿礼. 吸气式高超声速机体/推进一体化飞行器数值和试验研究[J]. 实验流体力学, 2007, 21(2): 29-31.
[11] 贺元元, 倪鸿礼, 乐嘉陵.一体化高超声速飞行器气动-推进性能评估[J]. 实验流体力学, 2007, 21(2): 63-67.
[12] 许晓斌, 舒海峰, 谢飞, 等. 通气模型内流道阻力直接测量技术[J]. 推进技术, 2013, 34(3): 311-315. (XU Xiao-bin, SHU Hai-feng, XIE Fei, et al. Technique Investigation on Flow through Model Inner Flow Drag Straightway Measured by Strain-Gauge Balance [J]. Journal of Propulsion Technology, 2013, 34(3): 311-315.)
[13] 唐志共. 高超声速气动力试验 [M]. 北京: 国防工业出版社, 2004.
[14] 恽起麟. 实验空气动力学[M]. 北京: 国防工业出版社, 1991.
[15] 王发祥. 高速风洞试验[M]. 北京: 国防工业出版社, 2001.
[16] 王泽江, 孙鹏, 李绪国, 等. 吸气式高超声速内外流同时测力试验[M]. 航空学报, 2015, 36(3):797-803.
[17] 贺伟, 于时恩, 李宏斌. 高超声速一体化飞行器推阻特性测量研究[J]. 实验流体力学, 2010, 24(2):65-68.(编辑:史亚红)　　　　　　　　　　　　　*　收稿日期:2014-04-18；修订日期:2014-07-24。作者简介:王泽江(1972—),男,博士生,副研究员,研究领域为高超声速空气动力学。E-mail:wangpeiyi1209@163.com