基于微观结构分析的CMDB推进剂动态断裂韧性加载率敏感性研究

推进技术 ›› 2015, Vol. 36 ›› Issue (6): 940-946.

基于微观结构分析的CMDB推进剂动态断裂韧性加载率敏感性研究

郑　健¹,汪文强^1,2,陈　雄¹,许进升¹,周长省¹

南京理工大学机械工程学院，江苏南京 210094,南京理工大学机械工程学院，江苏南京 210094; 武汉滨湖电子有限责任公司，湖北武汉 430077,南京理工大学机械工程学院，江苏南京 210094,南京理工大学机械工程学院，江苏南京 210094,南京理工大学机械工程学院，江苏南京 210094

发布日期:2021-08-15
作者简介:郑　健(1978—)，男，博士，讲师，研究领域为固体火箭发动机总体技术及固体力学。
基金资助:
总装重点预研项目(20101019)。

Effects of Loading Rate and Microstructure on Dynamic Fracture Toughness of CMDB Propellant

School of Mechanical Engineering，Nanjing University of Science and Technology，Nanjing 210094，China,School of Mechanical Engineering，Nanjing University of Science and Technology，Nanjing 210094，China; Wuhan Binhu Electronic Limited Liability Company，Wuhan 430077，China,School of Mechanical Engineering，Nanjing University of Science and Technology，Nanjing 210094，China,School of Mechanical Engineering，Nanjing University of Science and Technology，Nanjing 210094，China and School of Mechanical Engineering，Nanjing University of Science and Technology，Nanjing 210094，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究改性双基推进剂(CMDB)的动态断裂特性，利用霍普金森实验技术(SHPB)对CMDB推进剂进行了冲击实验，并对实验数据的可靠性进行了校验；通过数值仿真的方法进一步验证了实验数据的有效性，获得了CMDB推进剂的动态断裂韧性；利用电镜扫描技术对试件断面进行了微观表征和分析。结果表明:CMDB推进剂在加载率58906～ 100056MPa·m1/2·s-1范围内，表现出明显的加载率敏感性；加载率达到105000 MPa·m1/2·s-1左右时，断裂韧性不再继续增大，反而出现下降趋势；电镜分析结果表明，CMDB推进剂加载率敏感性与其内部高氯酸铵(AP)颗粒的微观破坏机理直接相关。

关键词: 改性双基推进剂; 霍普金森实验；加载率敏感性；电镜扫描

Abstract: In order to investigate the dynamic fracture characteristics of the composite modified double-base propellant (CMDB) under impact loading，impact fracture experiments were performed on the split Hopkinson pressure bar (SHPB) device，and the reliability of the experimental data was verified. Moreover，a numerical analysis was conducted to verify the experimental data，and the dynamic fracture toughness of CMDB propellant was obtained. The fractured CMDB specimens were investigated by using Scanning Electron Microscope (SEM). It is found that the CMDB propellant is a significant loading rate sensitivity material within the range of normalized loading rates from 58906MPa·m1/2·s-1 to 100056 MPa·m1/2·s-1. However，as the loading rate increase to 105000 MPa·m1/2·s-1，the dynamic fracture toughness of CMDB propellant does not continue to increase，but decrease. SEM?analysis?shows that the loading rate sensitivity of CMDB propellant is directly related to the microstructure failure mechanism of ammonium perchlorate (AP) particles.

Key words: Composite modified double-base propellant；SHPB；Loading rate sensitivity；SEM

郑　健,汪文强,陈　雄,许进升,周长省. 基于微观结构分析的CMDB推进剂动态断裂韧性加载率敏感性研究[J]. 推进技术, 2015, 36(6): 940-946.

ZHENG-Jian¹,WANG Wen-qiang^1,2,CHENG-Xiong¹,XU Jin-sheng¹,ZHOU Chang-sheng¹. Effects of Loading Rate and Microstructure on Dynamic Fracture Toughness of CMDB Propellant[J]. Journal of Propulsion Technology, 2015, 36(6): 940-946.

参考文献

[1] 武晓松, 陈军, 王栋. 固体火箭发动机原理[M]. 北京:兵器工业出版社, 2011.
[2] 黄风雷, 王泽平. 复合固体推进剂动态断裂研究[J]. 兵工学报, 1995, (2): 47-50.
[3] 黄风雷.固体推进剂冲击特性研究[D]. 北京:北京理工大学, 1992.
[4] Abdelaziz M N, Neviere R, Pluvinage G. Experimental Method for JIC Computation on Fracture of Solid Propellants under Dynamic Loading Conditions [J]. Engineering Fracture Mechanics, 1987, 28 (4): 425-434.
[5] Abdelaziz M N, Neviere R, Pluvinage G. Experimental Investigation of Fracture Surface Energy of a Solid Propellant under Different Loading Rates [J]. Engineering Fracture Mechanics, 1988, 31(6): 1009-1026.
[6] Ho S Y, Fong C W. Correlation Between Fracture Properties and Dynamic Mechanical Relaxations in Composite Propellants [J]. Polymer, 1987, 28(5): 739-744.
[7] Fong C W, Warren R C. The Effect of Filler Particle size and Orientation on the Impact Fracture Toughness of a Highly Filled Plasticized Polymeric Material [J]. Journal of Materials Science, 1985, 20(9): 3101-3110.
[8] Chyuan S W. Dynamic Analysis of Solid Propellant grains Subjected to Ignition Pressurization Loading [J]. Journal of Sound and Vibration, 2003, 268(3): 465-483.
[9] Ninan L, Tsai J, Sun C T. Use of Split Hopkinson Pressure Bar for Testing Off-Axis Composites [J]. International Journal of Impact Engineering, 2001, 25(3): 291-313.
[10] 范天佑. 断裂动力学: 原理与应用[M]. 北京:北京理工大学出版社, 2006.
[11] Wang Q Z, Li W, Xie H P. Dynamic Split Tensile Test of Flattened Brazilian Disc of Rock with SHPB Setup [J]. Mechanics of Materials, 2009, 41(3): 252-260.
[12] 王蓬勃, 王政时, 鞠玉涛, 等. 双基推进剂高应变率型本构模型的实验研究[J]. 固体火箭技术, 2012, 35(1): 69-72.
[13] 石亦平, 周玉蓉. ABAQUS 有限元分析实例详解[M]. 北京:机械工业出版社, 2007.
[14] Lindholm U S. Some Experiments with the Split Hopkinson Pressure Bar [J]. Journal of the Mechanics and Physics of Solids, 1964, 12(5): 317-335.
[15] Wang Q Z, Jia X M, Kou S Q, et al. The Flattened Brazilian Disc Specimen Used for Testing Elastic Modulus, Tensile Strength and Fracture Toughness of Brittle rocks: Analytical and Numerical Results [J]. International Journal of Rock Mechanics and Mining Sciences, 2004, 41(2): 245-253.
[16] 刘著卿, 李高春, 邢耀国, 等. 复合固体推进剂细观损伤扫描电镜实验及数值模拟[J]. 推进技术, 2011, 32(3): 412-416. (LIU Zhu-qing, LI Gao-chun, XING Yao-guo, et al. Numerical Simulation and SEM Study on the Micro-Structural Damage of Composite Solid Propellants[J]. Journal of Propulsion Technology, 2011, 32(3): 412-416.)
[17] Zhang Q B, Zhao J. Effect of Loading Rate on Fracture Toughness and Failure Mico-Mechanisms in Marble [J].Engineering Fracture Mechanics, 2013, 102: 288-309.
[18] Delhaye V, Clausen A H, Moussy F, et al. Influence of Stress State and Strain Rate on the Behaviour of a Rubber-Particle Reinforced Polypropylene [J]. International Journal of Impact Engineering, 2011, 38(4): 208-218.(编辑:朱立影)　　　　　　　　　　　　　*　收稿日期:2014-06-24；修订日期:2014-08-29。基金项目:总装重点预研项目(20101019)。作者简介:郑健(1978—),男,博士,讲师,研究领域为固体火箭发动机总体技术及固体力学。 E-mail:zhengjian@njust.edu.cn