基于LPP的多点喷射低污染燃烧室头部方案优化研究

推进技术 ›› 2015, Vol. 36 ›› Issue (7): 1036-1045.

基于LPP的多点喷射低污染燃烧室头部方案优化研究

王铮钧,索建秦,黎　明,梁红侠,赵聪聪

西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072

发布日期:2021-08-15
作者简介:王铮钧(1987—)，男，硕士生，研究领域为航空发动机燃烧室。

Optimized Study of a Dome for Low Emission Combustor with Multipoint Injection Based on LPP

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China and School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究贫油预混预蒸发(LPP)燃烧室的性能，设计了两个方案的单管燃烧室。两个方案都采用同心圆式主、副模分区燃烧方式，主模燃油为多点喷射，副模为离心式压力雾化喷嘴。其中方案A主模从外向内喷油，方案B主模从内向外喷油。采用ANSYS CFX软件，对慢车工况和起飞工况的燃烧室进行了数值研究。计算结果表明:流量分配与设计值接近；总压损失介于4%～4.8%；燃烧室有较稳定的回流区和主模出口处大于100m/s的气流轴向速度；工况1时副模富油燃烧，火焰温度高；工况2时主、副模火焰相互独立，主模火焰存在因燃油分布不均匀而产生的高温点；两个方案的出口热点指标均小于0.26；燃烧效率大于99%；污染物排放水平与国际先进水平相近。两个方案在各方面性能上基本接近，方案A略微优于B。

关键词: 燃烧室；低污染；贫油预混预蒸发；多点喷射

Abstract: Two different kinds of tubular combustors were designed in order to obtain the performance of lean premixed pre-vaporized (LPP) combustor. Staged combustion was achieved in both cases by co-axial main and pilot module. Multipoint injection was adopted in main module while pressure swirl atomizer was adopted in pilot module. Main fuel was injected from outer wall in case A while main fuel was injected from inner wall in case B. Numerical investigation was conducted by ANSYS CFX from takeoff condition and idle condition. Results show that distribution of mass flow rate was closed to designed values and total pressure loss was between 4% and 4.8%. Stable recirculation zone was found and axial velocity was over 100m/s at the outlet of main module. Pilot fuel was rich burned with high flame temperature，when combustors were operated under condition 1. Hot spot caused by non-uniform fuel distribution were found in main flame under condition 2 while main and pilot flame were separated. Pattern factor was less than 0.26 in both cases and combustion efficiency were above 99%. Pollutant emission was closed to international advanced level. From results，two cases were closed from every aspect of performance，and case A was a little better than case B.

Key words: Combustor；Low emission；Lean premixed pre-vaporized；Multipoint Injection

王铮钧,索建秦,黎　明,梁红侠,赵聪聪. 基于LPP的多点喷射低污染燃烧室头部方案优化研究[J]. 推进技术, 2015, 36(7): 1036-1045.

WANG Zheng-jun,SUO Jian-qin,LI Ming,LIANG Hong-xia,ZHAO Cong-cong. Optimized Study of a Dome for Low Emission Combustor with Multipoint Injection Based on LPP[J]. Journal of Propulsion Technology, 2015, 36(7): 1036-1045.

参考文献

[1] 赵坚行. 民用发动机污染排放及低污染燃烧技术发展趋势[J]. 航空动力学报, 2008, 23(6): 986-996.
[2] 彭云晖, 许全宏, 张弛, 等. 我国大飞机发动机低污染燃烧室发展考虑 [C].深圳: 大型飞机关键技术高层论坛暨中国航空学会2007年年会, 2007.
[3] 林宇震, 许全宏, 刘高恩. 燃气轮机燃烧室[M]. 北京: 国防工业出版社, 2008.
[4] Foust M J, Thomsen D, Stickles R C C, et al. Development of the GE Aviation Low Emissions TAPS Combustor for Next Generation Aircraft Engines [R].AIAA 2012-0936.
[5] Lee C M, Chang C, Kramer S, et al. NASA Project Develops Next Generation Low-emissions Combustor Technologies[R]. AIAA 2013-0540.
[6] Prociw A, Ryon J, Goeke J. Low NO_x Combustion Concepts in Support of the NASA Environmentally Responsible Aircraft Program[R]. ASME GT 2012-68426.
[7] 彭云晖, 许全宏, 张弛, 等. 我国大飞机发动机低污染燃烧室发展考虑[C].?深圳: 大型飞机关键技术高层论坛暨中国航空学会2007年年会, 2007.
[8] Dodds W. Engine and Aircraft Technologies to Reduce Emissions[C]. San Diego: ICCAIA Noise and Emissions Committee, 2002.
[9] Mongia H C. TAPS-A 4th Generation Propulsion Combustor Technology for Low Emissions[R]. AIAA 2003-2657.
[10] 林宇震, 林阳, 张弛, 等. 先进燃烧室分级燃烧空气流量分配的探讨[J]. 航空动力学报, 2010, 25(9): 1923-1930.
[11] 刘强, 索建秦, 梁红侠, 等. 直混燃烧与LPP组合燃烧室数值研究[J]. 航空动力学报, 2012, 27(11): 2448-2454.
[12] 王铮钧, 索建秦, 黎明, 等. 基于LPP的多点喷射低污染燃烧室头部方案研究[J]. 科学技术与工程, 2013, 13(34): 10409-10416.
[13] 谢龙汉, 赵新宇, 张炯明. ANSYS CF-X流体分析及仿真[M]. 北京: 电子工业出版社, 2012.
[14] Nicol D G, Steele R C, Marinov N M, et al. The Importance of the Nitrous Oxide Pathway to NO_x in Lean-Premixed Combustion[J]. Journal of Engineering for Gas Turbines and Power, 1995, 117(1): 100-111.
[15] Magnussen B F, Hjertager B H. On Mathematical Modeling of Turbulent Combustion with Special Emphasis on Soot Formation and Combustion[C]. Pittsburgh: Sixteenth Symposium (International) on Combustion, 1976.
[16] Tesner P A, Smegiriova T D, KnorreV G. Kinetics of Dispersed Carbon Formation[J].Combustion and Flame, 1971, 17(2): 253-260.
[17] 金如山. 航空燃气轮机燃烧室[M]. 北京: 宇航出版社, 1988.
[18] 常峰, 索建秦, 梁红侠, 等. 同心圆式主副模分区燃烧组织燃烧室数值研究[J]. 推进技术, 2012, 33(5): 760-764.(CHANG Feng, SUO Jian-qin, LIANG Hong-xia, et al. Numerical Study of Co-Axial Pilot and Main Module Combustor[J]. Journal of Propulsion Technology, 2012, 33(5): 760-764.)
[19] 严传俊, 范玮. 燃烧学[M]. 西安:西北工业大学出版社, 2008.
[20] 田颖. 贫燃料预混燃烧回火特性研究[D]. 北京: 中国科学院研究生院(工程热物理研究所), 2005.
[21] Dhanuka S K, Temme J E, Driscoll J. Unsteady Aspects of Lean Premixed Prevaporized (LPP) Gas Turbine Combustors: Flame-Flame Interactions[J]. Journal of Propulsion and Power, 2011, 27(3): 631-641.
[22] 颜应文, 徐榕, 邓远灏, 等. 贫油预混预蒸发低污染燃烧室头部流场研究[J].航空学报, 2012, 33(6): 965-976.
[23] 张斌全编著. 现代航空发动机燃烧室[M]. 北京: 北京航空学院出版社, 1986.
[24] Han Z Y, Parrish S, Farrell P V, et al. Modeling Atomization Processes of Pressure-Swirl Hollow-Cone Fuel Sprays[J]. Atomization and Sprays, 1997, 7(6): 663-684.
[25] Senecal P K, Schmidt D P, Nouar I, et al. Modeling High-Speed Viscous Liquid Sheet Atomization[J]. International Journal of Multiphase Flow, 1999, 25(6): 1073-1097.
[26] Heywood J B, Mikus T. Parameters Controlling Nitric Oxide Emissions from Gas Turbine Combustors[C]. London: Meeting on Atmospheric Pollution by Aircraft Engines, 1973.
[27] Lefebvre A H. Gas Turbine Combustion [M]. UK: Taylor & Francis, 1999.
[28] 尚守堂, 程明, 李锋, 等. 低排放长寿命燃烧室关键技术分析[J]. 航空制造技术, 2009, 2: 32-37.
[29] Bank R, Schilling T. Development of an Ultra-Low NO_x LP (P) Burner[R]. ASME GT 2004-53341.(编辑:朱立影)　　　　　　　　　　　　　*　收稿日期:2014-04-29；修订日期:2014-06-13。作者简介:王铮钧(1987—),男,硕士生,研究领域为航空发动机燃烧室。E-mail:duanyiaxiu@163.comFig.7　Radial distribution of axial velocity at different axial location of condition 2