气膜孔倾角对层板隔热屏冷却性能影响

推进技术 ›› 2016, Vol. 37 ›› Issue (2): 281-288.

气膜孔倾角对层板隔热屏冷却性能影响

刘友宏,任浩亮

北京航空航天大学能源与动力工程学院，航空发动机气动热力国家重点实验室，北京 100191,北京航空航天大学能源与动力工程学院，航空发动机气动热力国家重点实验室，北京 100191

发布日期:2021-08-15
作者简介:刘友宏，男，博士，教授，研究领域为气动热力、热防护等领域。

Effects of Film Cooling Hole Angles of Inclination on Cooling Performance of Lamilloy Heat Shield

National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，School of Energy and Power Engineering，Beihang University，Beijing 100191, China and National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，School of Energy and Power Engineering，Beihang University，Beijing 100191, China

Published:2021-08-15

摘要/Abstract

摘要： 为了获得气膜孔倾角对层板隔热屏(冲击/发散复合冷却隔热屏)冷却性能的影响规律，基于加力燃烧室真实工况，对0°到90°范围内的十种不同气膜孔倾角的层板隔热屏进行了三维流热耦合数值模拟研究，得到了层板隔热屏冲击壁面Nu数、层板隔热屏气膜冷却表面的冷却效果、层板隔热屏冷流体热负荷及气膜孔流量系数的变化规律。结果表明，气膜孔倾角的变化对冲击壁面Nu数的影响较小；气膜冷却表面的综合冷却效果随气膜孔倾角的增大而减小，15°倾角模型比10°倾角模型的平均综合冷却效果降低2.8%；单位面积冷流体热负荷随气膜孔倾角的增大而增大，最小值比最大值低30.7%；气膜孔倾角对层板隔热屏平均流量系数的影响不大，但上游气膜孔的出流会对下游气膜孔的流量系数产生影响。

关键词: 层板隔热屏；气膜冷却；气膜孔；倾角；加力燃烧室

Abstract: In order to obtain the effects of film cooling holes angle of inclination on cooling performance of lamilloy cooled heat shield(impingement/effusion cooled heat shield)，a series of three-dimensional numerical simulations with fluid/heat conjugated computational method were conducted under a real working condition of an afterburner by ten configurations of lamilloy with film cooling holes of varying angles of inclination(α=0°～90°). Change laws of Nusselt number of impinged surface，cooling effect of film cooled surface，coolant heat load and discharge coefficient of the lamilloy have been obtained. Results show that the effect of changing the inclination angle of film cooling holes on Nusselt number of impinged surface is slight，the overall cooling effect decrease with the increase of angles of inclination，the value of 15° model lower 2.8% than 10° model. The coolant heat load increase with the increase of angle of inclination with the minimum value lower 30.7% than the maximum. The average discharge coefficient of all holes is only slightly affected by the angles of inclination but the discharge coefficients of downstream holes are affected by the upstream holes.

Key words: Lamilloy cooled heat shield；Film cooling；Film cooling hole；Angle of inclination； Afterburner

刘友宏,任浩亮. 气膜孔倾角对层板隔热屏冷却性能影响[J]. 推进技术, 2016, 37(2): 281-288.

LIU You-hong,REN Hao-liang. Effects of Film Cooling Hole Angles of Inclination on Cooling Performance of Lamilloy Heat Shield[J]. Journal of Propulsion Technology, 2016, 37(2): 281-288.

参考文献

[1] 《航空发动机设计手册》总编委会. 航空发动机设计手册[M]. 北京:航空工业出版社,2001.
[2] 王寅会, 常海萍, 王玉梅. 纵向波纹隔热屏气膜孔流量系数的实验[J]. 航空动力学报, 2010, 25(8):1758-1762.
[3] 陆永华, 常海萍, 谈浩元. 纵向波纹隔热屏通道的换热特性[J]. 推进技术, 2002, 23(3): 230-232. (LU Yong-hua, CHANG Hai-ping, TAN Hao-yuan. Heating Transfer of Longitudinal Ripple Heat Shield Tunnel[J]. Journal of Propulsion Technology, 2002, 23(3):230-232.)
[4] 唐婵, 常海萍. 发散孔纵向波纹隔热屏气膜冷却特性[J]. 航空动力学报, 2009, 24(1): 18-24.
[5] Jeffery A L, Torence P B, Derk S P. Development Needs for Advanced Afterburner Designs[R]. AIAA 2004-4192.
[6] Jobin T R, Gamble E J, Bachmann J G. Development of a Computer Program for Thermal Analysis of Aircraft Cooling Liners[R]. AIAA 2006-986.
[7] 宋双文, 杨卫华, 胡好生, 等. 冲击+逆向对流+气膜冷却传热特性的研究[J]. 航空动力学报, 2007, 22(9): 1417-1422.
[8] 方昌德. 世界航空发动机手册[M]. 北京:航空工业出版社, 1996.
[9] Huber A M, Viskanta R. Effect of Jet-Jet Spacing on Convective Heat Transfer to Confined Impinging Arrays of Axisymmetric Air Jets[J]. International Journal of Heat and Mass Transfer, 1994, 37(18): 2859-2869.
[10] Dabagh A L, Andrews A M. Impingement/Effusion Cooling: The Influence of the Number of Impingement Holes and Pressure Loss on the Heat Transfer Coefficient[J]. Journal of Turbomachinery, 1990, 112(3):467-476.
[11] Andrew G E, Dabagh A L. Impingement/Effusion Cooling: Influence of the Numbers of Holes on the Cooling Effectiveness for an Impingement X/D of 10.5 and Effusion X/D of 7.0[C]. Japan: Proceedings of 7th IGTC, 1999.
[12] Hong S K, Rhee D H, Cho H H. Effects of Fin Shapes and Arrangements on Heat Transfer for Impingement/Effusion Cooling with Crossflow[J]. Journal of Heat Transfer, 2007, 129(12): 1697-1707.
[13] Rhee D H, Nam Y W, Cho H H. Local Heat/Mass Transfer with Various Rib Arrangements in Impingement/Effusion Cooling System with Crossflow[R]. ASME GT 2004-53686.
[14] Kim K M, Moon H, Park J S, et al. Optimal Design of Impinging Jets in an Impingement/Effusion Cooling System[J]. Energy, 2014, 66:839-848.
[15] 毛军逵, 刘震雄, 郭文, 等. 双层壳型冲击/气膜结构内表面换热特性实验[J]. 推进技术, 2007, 28(3):235-239. (MAO Jun-kui, LIU Zhen-xiong, GUO Wen, et al. Experiment on Local Heat Transfer Coefficient of a Double-Decker Jet Impingment/Film Cooling Structure[J]. Journal of Propulsion Technology, 2007, 28(3):235-239.)
[16] 李鑫, 毛军逵, 王小平, 等. 双层壳型涡轮叶片中冲击旋流换热增益效果试验[J]. 推进技术, 2010, 31(3): 325-330. (LI Xin, MAO Jun-kui, WANG Xiao-ping, et al. Experiments on Heat Transfer Enhancement with Vortex in a Double-Decker Jet/Film Cooling Structure[J]. Journal of Propulsion Technology, 2010, 31(3):325-330.)
[17] 杨旭, 刘友宏. 孔径比与冲击距对冲击/发散冷却隔热屏冷却性能影响[J]. 推进技术, 2014, 35(5):668-674. (YANG Xu, LIU You-hong. Effects of Diameter Ratio of Holes and Impingement Distance on Cooling Performance of Impingement/Effusion Cooled Heat Shield[J]. Journal of Propulsion Technology, 2014, 35(5):668-674.)
[18] Thornton E A. Coupled Flow Thermal and Structural Analysis of Aerodynamically Heat Panels[J]. Journal of Aircraft, 1988, 25(11): 1052-1059.
[19] 全栋梁, 刘松龄, 李江海, 等. 层板冷却特性的实验与数值模拟研究[J]. 推进技术, 2004, 25(2): 134-138. (QUAN Dong-liang, LIU Song-ling, LI Jiang-hai, et al. Experimental and Numerical Investigation of the Cooling Characteristics in a Laminate Porous Plate[J]. Journal of Propulsion Technology, 2004, 25(2):134-138.)
[20] 杨旭. 加力燃烧室冲击/发散冷却层板隔热屏冷却性能初步研究[D]. 北京:北京航空航天大学, 2014.
[21] 许全宏, 林宇震, 刘高恩. 冲击加多斜孔双层壁冷却方式流量系数研究[J]. 推进技术, 2000, 21(5):49-52. (XU Quan-hong, LIN Yu-zhen, LIU Gao-en. Discharge Coefficient of Double Wall with Discrete-Hole and Inclined Multihole for Combustor Liner[J]. Journal of Propulsion Technology, 2000, 21(5): 49-52.)(编辑:张荣莉)　　　　　　　　　　　　　*　收稿日期:2014-09-23；修订日期:2014-10-31。作者简介:刘友宏,男,博士,教授,研究领域为气动热力、热防护等领域。E-mail:liuyh@buaa.edu.cn