高旋转数下直肋U型方通道的换热特性研究

推进技术 ›› 2016, Vol. 37 ›› Issue (3): 428-435.

高旋转数下直肋U型方通道的换热特性研究

冯晓星¹,田淑青¹,邓宏武²,李洋²

中航商用航空发动机有限责任公司设计研发中心，上海 201108,中航商用航空发动机有限责任公司设计研发中心，上海 201108,北京航空航天大学航空发动机气动热力国家级重点实验室，北京 100191,北京航空航天大学航空发动机气动热力国家级重点实验室，北京 100191

发布日期:2021-08-15
作者简介:冯晓星，男，硕士，工程师，研究领域为航空发动机热端部件冷却结构设计。

Heat Transfer in a Rotating Square U-Duct at High Rotation Numbers with 90° Ribs

R&D center，AVIC Commercial Aircraft Engine Corporation，LTD，Shanghai 201108，China,R&D center，AVIC Commercial Aircraft Engine Corporation，LTD，Shanghai 201108，China,National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，Beijing University of Aeronautics and Astronautics，Beijing 100191，China and National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，Beijing University of Aeronautics and Astronautics，Beijing 100191，China

Published:2021-08-15

摘要/Abstract

摘要： 通过提高U型通道气体压力到500kPa以上，将实验雷诺数Re和旋转数Ro范围分别扩展到10000～70000和0～2.0，从而匹配真实发动机转子叶片的工作条件。在此基础上实验研究了高旋转数下带直肋的、方形截面的U型通道的换热特性。研究结果表明:第一通道前缘面的努塞尔数比随旋转数的增大先下降后增强，该临界旋转数为定值Roc=0.26；随着旋转数的增大，第二通道前缘面的努塞尔数比一直高于后缘面，与光滑通道中的换热规律不同；随着旋转数的增大，第二通道内外侧面努塞尔数比的差异逐渐减小，在临近出口处几乎没有差异，与光滑通道相比正好相反。

关键词: 雷诺数；高旋转数；直肋；U型通道；换热特性

Abstract: To match the real engine operating condition，Reynolds and Rotation number range of current experiment are expanded from 10000 to 70000 and 0 to 2.0 through increasing the absolute pressure of the air in the U-duct to 500kPa. Experiments have been conducted to investigate the heat transfer characteristics in a square U-duct with 90° ribs. The results indicate that Nusselt number ratio of leading wall in the first passage firstly decreases and then increases as the rotation number increasing，and the critical rotation number is constant，Roc=0.26. In the second passage，Nusselt number ratio of leading wall behaves constantly better than trailing wall with the increasing of the rotation number，which is totally different from that of the smooth channel. And contrary to the difference of Nusselt number ratio between inner and outer wall in the second passage of the smooth channel，it becomes smaller along the second passage of U-duct with 90° ribs.

Key words: Reynolds number；High rotation number；90° Rib；U-duct；Heat transfer characteristics

冯晓星,田淑青,邓宏武,李洋. 高旋转数下直肋U型方通道的换热特性研究[J]. 推进技术, 2016, 37(3): 428-435.

FENG Xiao-xing¹,TIAN Shu-qing¹,DENG Hong-wu²,LI Yang². Heat Transfer in a Rotating Square U-Duct at High Rotation Numbers with 90° Ribs[J]. Journal of Propulsion Technology, 2016, 37(3): 428-435.

参考文献

[1] 韩介勤, 桑地普·杜达, 斯瑞纳斯·艾卡德. 燃气轮机传热和冷却技术[M]. 西安:西安交通大学出版社, 2005.
[2] 高潮, 丁一民, 王宝官. 模拟旋转内冷通道中压力测量的实验研究[J]. 推进技术, 1998, 19(3): 98～101. (GAO Chao, DING Yi-min, WANG Bao-guan. An Investigation of Measurement of Flow Pressure in Rotating Tubes[J]. Journal of Propulsion Technology, 1998, 19(3): 98～101.)
[3] Wanger J H, Johnson B V, Graziani R A, et al. Heat Transfer in Rotating Serpentine Passage with Trips Normal to the Flow[J]. ASME Journal of Turbomachinery, 1992, 114:847-857.
[4] Taslim M E, Chrysafis C, Kercher D M. An Experimental Investigation of Heat Transfer Coefficients in a Spanwise Rotating Channel with Two Opposite Rib-Roughened Walls[J]. ASME Journal of Turbomachinery, 1991, 113:75-82.
[5] 邓宏武, 张炜, 陶智. 旋转状态下带肋U形通道内换热的实验研究[J]. 推进技术, 2000, 21(1): 26～29. (DENG Hong-wu, ZHANG Wei, TAO Zhi. Experimental Investigation on Heat Transfer within a Rotating Ribber Serpenting passage [J]. Journal of Propulsion Technology, 2000, 21(1): 26～29.)
[6] Liou T M, Chang S W, Hung J H, et al. High Rotation Number Heat Transfer of a 45 Degrees Rib-Roughened Rectangular Duct with Two Channel Orientations[J]. International Journal of Heat and Mass Transfer, 2007, 50 (19-20): 4063-4078.
[7] Zhou Fuguo, Lagrone J, Acharya S. Internal Cooling in 4:1 AR Passages at High Rotation Numbers[J]. ASME Journal of Heat Transfer, 2007, 129: 1666-1675.
[8] Chang S W, Liou T M, Liou, et al. Coriolis and Rotating Buoyancy Effects on Detailed Heat Transfer Distributions in a Two-Pass Square Channel Roughened by 45° Ribs at High Rotation Numbers[J]. International Journal of Heat and Mass Transfer, 2010, 53: 1349–1363.
[9] 王宝官, 王武, 吉洪湖. 模拟涡轮叶片内部冷却通道方管和收缩管换热的实验研究[J]. 工程热物理学报, 1997, 18(5): 608-611.
[10] 邓宏武, 陶智, 徐国强, 等. 旋转状态下有转角带肋U形通道内换热实验研究[J]. 大连理工大学学报, 2001, 41(1): 38-41.
[11] 邓宏武, 魏喆, 陶智, 等. 旋转状态下蛇形通道内流动与换热的机理研究[J]. 航空学报, 2005, 26(4):411-416.
[12] 刘传凯, 陶智, 丁水汀, 等. 旋转对光滑U形通道内换热的影响研究[J]. 航空动力学报, 2006, 21(3): 512-517.
[13] 程俊华, 倪彬, 邓宏武, 等. 高旋转数内冷通道换热实验技术及验证[J]. 航空动力学报, 2014, 29(8): 1817-1823.
[14] 邓宏武, 程俊华, 陈豪, 等. 高旋转数下光滑回转通道的换热特性[J]. 北京航空航天大学学报, 2014, 40(5): 701-706.
[15] Deng H W, Qiu L, Tao Z, et al. Heat Transfer Study in Rotating Smooth Square U-Duct at High Rotation Numbers[J]. International Journal of Heat transfer and Mass Transfer, 2013, 66: 733-744.
[16] Qiu L, Deng H W, Sun J N, et al. Pressure Drop and Heat Transfer in Rotating Smooth Square U-Duct under High Rotation Numbers[J]. International Journal of Heat Transfer and Mass Transfer, 2013, 66: 543-552.
[17] Dutta S, Andrews M J, Han J C. Prediction of Turbulent Heat Transfer in Rotating Smooth Square Ducts[J]. International Journal of Heat and Mass Transfer, 1996, 39(12): 2505-2514.(编辑:史亚红)　　　　　　　　　　　　　*　收稿日期:2014-12-01；修订日期:2015-02-11。作者简介:冯晓星,男,硕士,工程师,研究领域为航空发动机热端部件冷却结构设计。E-mail: fxx_2659@163.com