不同宽度吸力面小翼控制压气机叶栅间隙流动的实验研究

推进技术 ›› 2016, Vol. 37 ›› Issue (3): 471-478.

不同宽度吸力面小翼控制压气机叶栅间隙流动的实验研究

韩少冰,钟兢军,陆华伟

大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026

发布日期:2021-08-15
作者简介:韩少冰，男，博士，讲师，研究领域为叶轮机械气动热力学。
基金资助:
国家自然科学基金(51436002；51406021)；辽宁省教育厅科学研究一般项目资助(L2014197)，辽宁省高校创新团

Experimental Investigation of Compressor Cascade Tip Leakage Flow Control Using Suction-Side Winglet with Different Widths

Marine Engineering College，Dalian Maritime University，Dalian 116026，China,Marine Engineering College，Dalian Maritime University，Dalian 116026，China and Marine Engineering College，Dalian Maritime University，Dalian 116026，China

Published:2021-08-15

摘要/Abstract

摘要： 为了进一步揭示吸力面叶尖小翼控制压气机叶栅间隙泄漏流动的作用机制，实验研究了三种不同宽度吸力面小翼在3%弦长间隙下对压气机叶栅气动性能的影响，并建立了带吸力面小翼的压气机叶栅旋涡结构模型。研究结果表明，吸力面小翼使得泄漏流在翼顶通道内发生掺混，延缓了泄漏涡的形成并降低了泄漏涡强度，三种宽度吸力面小翼分别使叶栅损失降低6.9%，7.7%和8.2%。吸力面小翼对叶栅损失值的降低量并不与其自身宽度增加量成线性关系。较大宽度的吸力面小翼会导致近端壁区气流欠偏转程度增加及泄漏流掺混损失等附加损失增大。

关键词: 吸力面小翼；压气机叶栅；间隙流动；实验研究

Abstract: In order to further reveal the action mechanism of suction-side winglet controlling tip leakage flow in compressor cascade，detailed experimental investigations have been carried out. For a fixed tip gap of 3% chord，three kinds of suction-side winglets with different width were tested，and the vortex model of the compressor cascade with suction-side winglet was established. The results show that the tip leakage flow mixing occurs inside the tip gap above the winglet and the formation of tip leakage vortex is delayed. Meanwhile，the strength of tip leakage vortex is reduced. The loss coefficient is reduced by about 6.9%，7.7% and 8.2%，respectively，for the three kinds of suction-side winglet cases. The aerodynamic loss reduction by the suction-side winglet is not linear with the increase amount of winglet width. The suction-side winglet with a larger width increases the flow underturning degree near the casing and the additional losses made by leakage flow mixing process etc.

Key words: Suction-side winglet；Compressor cascade；Tip leakage flow；Experimental investigation

韩少冰,钟兢军,陆华伟. 不同宽度吸力面小翼控制压气机叶栅间隙流动的实验研究[J]. 推进技术, 2016, 37(3): 471-478.

HAN Shao-bing,ZHONG Jing-jun,LU Hua-wei. Experimental Investigation of Compressor Cascade Tip Leakage Flow Control Using Suction-Side Winglet with Different Widths[J]. Journal of Propulsion Technology, 2016, 37(3): 471-478.

参考文献

[1] Freeman C.Tip Clearance Effects in Axial Turbomachines[R]. VKI-LS 1985-05.
[2] Thompson D W, King P I, Rabe D C. Experimental Investigation of Steeped Tip Gap Effects on the Performance of a Transonic Axial-Flow Compressor Rotor[J]. ASME Journal of Turbomachinery, 1998, 120: 477-486.
[3] Nezym V Y. Use of Turing Additional Blade in Compressor Rotor[R]. ASME GT 2005-68069.
[4] Jothiprasad G, Murray R C, Essenhigh K, et al. Control of Tip-Clearance Flow in a Low Speed Axial Compressor Rotor with Plasma Actuation[J]. ASME Journal of Turbomachinery, 2012, 134: 021019.
[5] Jinwoo Bae. Active Control of Tip Clearance Flow in Axial Compressors[J]. ASME Joural of Turbomachinery, 2005, 127: 352-362.
[6] Suder K L, Hathaway M D, Thorp S A. Compressor Stability Enhancement Using Discrete Tip Injection[J]. ASME Journal of Turbomacinery, 2001, 123: 14-23.
[7] Wbitcomb R T. A Design Approach and Selected Wind-Tunnel Results at High Subsonic Speeds for Wing-Tip Mounted Winglets[R]. NASA TN D-8260, 1976.
[8] 依凤鸣. 带附加导叶轴流风机的实验研究[J]. 流体工程, 1990, 19 (7) : 224.
[9] 吕文灿. 旋转导叶风机的理论分析与试验研究[J]. 华中理工大学学报, 1991, 19(1): 69-75.
[10] Yen S C, Lin F K T. Exit Flow Field and Performance of Axial Flow Fans[J]. ASME Journal of Fluids Engineering, 2006, 128: 332-340.
[11] Corsini A, Rispoli F, Sheard A G. Investigation on Improved Blade Tip Concept for Axial Flow Fan[R]. ASME GT 2006-90592.
[12] Booth T C, Dodge P R. Rotor-Tip Leakage: Part Ⅰ-Basic Methodology[J]. ASME Journal of Engineering for Power, 1982, 104: 154-161.
[13] Wadia A R, Booth T C. Rotor-Tip Leakage: Part Ⅱ-Design Optimization Through Viscous Analysis and Experiment[J]. ASME Journal of Engineering for Power, 1982, 104: 163-169.
[14] Yaras M I, Sjolander S A. Measurements of the Effects of Winglets on Tip-Leakage Losses in a Linear Turbine Cascade[R]. ISABE 91-7011:127-135.
[15] Harvey N W, Ramsden K. A Computation Study of a Novel Turbine Rotor Partial Shroud[J]. ASME Journal of Turbomachinery, 2001, 123: 534-543.
[16] Dey D, Camci C. Tip Desensitization of an Axial Turbine Rotor Using Tip Platform Extensions[R]. VKI-LS 2004-02.
[17] Kusterer K, Moritz N, Bohn D, et al. Reduction of Tip Clearance Losses in an Axial Turbine by Shaped Design of the Blade Tip Region[R]. ASME GT 2007-27303.
[18] Stephens J E, Corke T, Morris S C. Turbine Blade Tip Leakage Flow Control: Thick/Thin Blade Effects and Separation Line Studies[R]. ASME GT 2008-50705.
[19] Zhou C, Hodson H, Tibbott I, et al. The Aero-Thermal Performance of a Cooled Winglet Tip in a High Pressure Turbine Cascade[R]. ASME GT 2011-46369.
[20] Zhou C, Hodson H, Tibbott I, et al. Effects of Endwall Motion on the Aero-Thermal Performance of a Winglet Tip in a HP Turbine[R]. ASME GT 2011-46373.
[21] Yong Cheol Seo, Sang Woo Lee. Tip Gap Flow and Aerodynamic Loss Generation in a Turbine Cascade Equipped with Suction-Side Winglets[J]. Journal of Mechanical Science and Technology, 2013, 27(3): 703-712.
[22] 韩少冰, 钟兢军, 严红明. 不同长度吸力面小翼对压气机叶栅间隙流场影响的数值研究[J]. 航空动力学报, 2011, 26(3): 656-661.
[23] 韩少冰, 钟兢军. 变冲角下吸力面小翼对压气机叶栅气动性能的影响[J]. 推进技术, 2012, 33(3):384-390. (HAN Shao-bing, ZHONG Jing-jun. Effects of Suction-Side Winglet on Aerodynamic Performance of Compressor Cascade at Different Incidences[J]. Journal of Propulsion Technology, 2012, 33(3): 384-390.)
[24] Schrapp H, Stark U, Saathoff H. Breakdown of the Tip Clearance Vortex in a Rotor Equivalent Cascade and in a Single-Stage Low-Speed Compressor[R]. ASME GT 2008-50195.
[25] Saathoff H, Stark U. Endwall Boundary Layer Separation in a Single-Stage Low-Speed Compressor and a High-Stagger Compressor Cascade[J]. Engineering Research, 2000, 65: 217-224.
[26] Sakulkaew S, Tan C S, Donahoo E, et al. Compressor Efficiency Variation with Rotor Tip Gap from Vanishing to Large Clearance[J]. ASME Journal of Turbomachinery, 2013, 135: 031030.
[27] 韩少冰, 钟兢军, 陆华伟, 等. 叶尖泄漏与压气机叶栅三维角区分离相互作用的实验研究[J]. 推进技术, 2013, 34(2):187-193. (HAN Shao-bing, ZHONG Jing-jun, LU Hua-wei, et al. Experimental Investigation on Interaction between Tip Clearance Flow and Three-Dimensional Separation in Compressor Cascade[J]. Journal of Propulsion Technology, 2013, 34(2): 187-193.)
[28] Storer J A. Tip Clearance Flow in Axial Compressor[D]. Cambridge: University of Cambridge, 1991.
[29] Kang S. Investigation of the Three Dimensional Flow within a Compressor Cascade with and without Tip Clearance [D]. Brussel: Vrije Universiteit Brussel, 1993.(编辑:史亚红)　　　　　　　　　　　　　*　收稿日期:2015-06-10；修订日期:2015-08-14。基金项目:国家自然科学基金(51436002；51406021)；辽宁省教育厅科学研究一般项目资助(L2014197),辽宁省高校创新团队支持计划资助(LT2015004),中央高校基本科研业务费专项资金资助(3132015208；3132014319)。作者简介:韩少冰,男,博士,讲师,研究领域为叶轮机械气动热力学。E-mail: hanshaobing@126.com