润滑系统管路流动与换热耦合计算研究

推进技术 ›› 2016, Vol. 37 ›› Issue (3): 504-510.

润滑系统管路流动与换热耦合计算研究

任国哲,刘振侠,朱鹏飞,吕亚国

西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072

发布日期:2021-08-15
作者简介:任国哲，男，博士生，研究领域为航空发动机滑油系统。

Calculation on Heat-Fluid Coupling of Pipes in Aero-Engine Lubrication System

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China and School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究沿程管路换热与滑油流动之间的耦合问题，通过分析主要元件的流动和换热特性，引入元件换热的能量方程，结合管路流动的连续性方程和动量方程，建立了润滑系统管路热流耦合计算模型。针对一段发动机供油管路，利用MATLAB/Simulink建模仿真工具包，建立其热流耦合网络计算模型，获得滑油流量、温度以及管壁温度等参数，采用商业软件Flowmaster对其进行验证。模型计算结果与Flowmaster计算结果非常接近，滑油流量和温度的最大误差均不超过3%，管道壁温的计算误差不超过2.4%，说明建立的热流耦合计算模型具有良好的仿真精度，适用于考虑沿程管路换热的发动机润滑系统计算分析。

关键词: 润滑系统；热流耦合；能量方程；换热；计算模型

Abstract: In order to investigate the heat-fluid coupling of pipes in aero-engine lubrication system，the flow and heat transfer characteristics of main components were analyzed，and the important energy equation of component was added. Combined with the continuity and momentum equations，the heat-fluid coupling model was established for lubrication pipeline system. Using the simulation tool box Simulink of MATLAB，the coupling calculation model of oil supply line was built. After simulation calculation，oil flow rate，temperature and pipe wall temperature were obtained. Results were verified by commercial software Flowmaster，showing that the maximum error of oil flow rate is less than 3%，as well as the temperature. Besides，the maximum error of pipe wall temperature does not exceed 2.4%. Thus，the model established has good simulation accuracy，and can be used to analyze the characteristics of aero-engine lubrication system considering heat transfer.

Key words: Lubrication system；Heat-fluid coupling；Energy equation；Heat transfer；Calculation model

任国哲,刘振侠,朱鹏飞,吕亚国. 润滑系统管路流动与换热耦合计算研究[J]. 推进技术, 2016, 37(3): 504-510.

REN Guo-zhe,LIU Zhen-xia,ZHU Peng-fei,LV Ya-guo. Calculation on Heat-Fluid Coupling of Pipes in Aero-Engine Lubrication System[J]. Journal of Propulsion Technology, 2016, 37(3): 504-510.

参考文献

[1] 利特尔. 内流空气动力学手册[M]. 北京:国防工业出版社, 1982.
[2] 吴丁毅. 内流系统的网络计算方法[J]. 航空学报, 1996, 17(6): 653-657.
[3] 杜马钦柯 H T, 克拉维茨 A C. 燃气涡轮发动机的滑油系统[M]. 毛可久译. 北京:国防工业出版社, 1978.
[4] 刘振侠, 黄生勤, 吕亚国, 等. 航空发动机润滑系统通用分析软件开发[J]. 航空动力学报, 2007, 22(1): 12-17.
[5] 林基恕, 张振波. 21世纪航空发动机动力传输系统的展望[J]. 航空动力学报, 2001, 16(2): 108-114.
[6] Chun S M. Network Analysis of an Engine Lubrication System[J]. Tribology International, 2003, 36: 609-617.
[7] Karleine M, Justice, Jeffrey S. Lube Oil and Bearing Thermal Management System[R]. ASME GT2009-60048.
[8] 苏立超, 刘振侠, 吕亚国. 航空发动机润滑系统滑油压力仿真计算[J]. 科学技术与工程, 2012, 12(1): 97-101.
[9] 岳阳, 梁新刚, 徐向华, 等. 柴油发动机润滑系统流动与换热仿真研究[J]. 工程热物理学报, 2012, 33(8): 1411-1414.
[10] 张效伟. 涡扇发动机润滑系统性能计算与分析[D]. 西安:西北工业大学, 2006.
[11] LU Yaguo, LIU Zhenxia, HUANG Shengqin. Numerical Simulation of Areo-Engine Lubrication System[J]. ASME Journal of Engineering for Gas Turbines and Power, 2009, 131(5): 1-4.
[12] 黎林林, 谢光华. 某型号涡喷发动机滑油系统设计[J]. 推进技术, 2001, 22(6): 493-495. (LI Lin-lin , XIE Guang-hua. Oil System Design of a Certain Turbo-jet Engine[J]. Journal of Propulsion Technology, 2001, 22(6): 493-495.)
[13] 朱鹏飞, 刘振侠, 任国哲, 等. 航空发动机管路系统流动与换热的仿真平台[J]. 推进技术, 2014, 35(17): 1523-1529. (ZHU Peng-fei, LIU Zhen-xia, REN Guo-zhe, et al. Simulation Platform of Aero-Engine Pipeline System on Flow and Heat Transfer[J]. Journal of Propulsion Technology, 2014, 35(17): 1523-1529.)
[14] Miller D S. Internal Flow System[M]. Cranfield: BHR Group Limited, 1990.
[15] Ghajar A J, Tam L M. Heat Transfer Measurements and Correlations in the Transition Region for a Circular Tube with Three Different Inlet Configurations[J]. Expansion Thermal and Fluid Science, 1994, 8(1): 79-90.
[16] John H Lienhard. A Heat Transfer Text Book[M]. Cambridge: Phlogiston Press, 2006.
[17] 杨世铭, 陶文铨. 传热学[M]. 北京:高等教育出版社, 2006.
[18] Churchill S W, Bernstein M. A Correlating Equation for Forced Convection from Gases and Liquids to a Circular Cylinder in Cross Flow[J]. Journal of Heat Transfer-Transactions of the ASME, 1997, 99(1): 300-306.　　　　　　　　　　　　　*　收稿日期:2015-01-11；修订日期:2015-03-20。作者简介:任国哲,男,博士生,研究领域为航空发动机滑油系统。E-mail: renguozhe7917@163.com(编辑:朱立影)