贫油预混预蒸发燃烧室排放试验研究

推进技术 ›› 2016, Vol. 37 ›› Issue (4): 691-697.

贫油预混预蒸发燃烧室排放试验研究

邓远灏^1,2,马存祥²,郭凯²,徐华胜²,张靖周¹

南京航空航天大学能源与动力学院，江苏南京 210016; 中国燃气涡轮研究院，四川成都 610500,中国燃气涡轮研究院，四川成都 610500,中国燃气涡轮研究院，四川成都 610500,中国燃气涡轮研究院，四川成都 610500,南京航空航天大学能源与动力学院，江苏南京 210016

发布日期:2021-08-15
作者简介:邓远灏，男，博士生，高级工程师，研究领域为发动机燃烧。

Experimental Investigation on Emission of Lean Premixed Pre-evaporation Combustor

College of Energy and Power Engineering，Nanjing University of Aeronautics and Astronautics，Nanjing 210016，China;China Gas Turbine Establishment，Chengdu 610500，China,China Gas Turbine Establishment，Chengdu 610500，China,China Gas Turbine Establishment，Chengdu 610500，China,China Gas Turbine Establishment，Chengdu 610500，China and College of Energy and Power Engineering，Nanjing University of Aeronautics and Astronautics，Nanjing 210016，China

Published:2021-08-15

摘要/Abstract

摘要： 提出一种采用直接喷射和部分预混预蒸发(DIPME)混合燃烧技术的中心分级燃烧室，这种DIPME燃烧室具有低工况稳定燃烧，高工况低NO_x排放的特征。对采用该燃烧技术的单头部DIPME燃烧室进行LTO循环4个工况(慢车、返场、爬升和起飞)试验研究。研究结果表明:除慢车工况的燃烧效率接近0.99外，其余工况的燃烧效率均大于0.995；在LTO循环内DIPME燃烧室的CO，UHC和NO_x排放均满足CAEP/6排放标准，其中NO_x比CAEP/6低60.8%；同采用富油燃烧技术的燃烧室相比，采用该技术的DIPME燃烧室在降低CO和UHC排放上并没有什么优势，但在降低NO_x排放上潜力巨大。

关键词: 贫油预混预蒸发；燃烧室；起飞着陆循环；燃烧效率；排放

Abstract: A center stage combustor using direct injection and lean partial premixed pre-evaporation (DIPME) combustion technology was put forward. The characteristics of DIPME combustor are combustion stabilization in lower condition and low NO_x emission in higher condition. The LTO cycle 4 conditions (idle，approach，climb-out and take-off) of experiment investigation were conducted on single-dome DIPME combustor. The investigation results show that combustion efficiency of idle condition is near 0.99 and in other conditions exceeds 0.995. CO，UHC and NO_x emissions in LTO cycle are lower than CAEP/6 standard，especially 60.8% NO_x emission reduction of CAEP/6 standard. The DIPME combustor is compared with rich technology combustor，there is no advantage to reducing CO and UHC emission，but reducing NO_x emission is very potential.

Key words: Lean pre-mixing pre-evaporation；Combustor；Landing and take-off (LTO)；Combustion efficiency；Emission

邓远灏,马存祥,郭凯,徐华胜,张靖周. 贫油预混预蒸发燃烧室排放试验研究[J]. 推进技术, 2016, 37(4): 691-697.

DENG Yuan-hao^1,2,MA Cun-xiang²,GUO Kai²,XU Hua-sheng²,ZHANG Jing-zhou¹. Experimental Investigation on Emission of Lean Premixed Pre-evaporation Combustor[J]. Journal of Propulsion Technology, 2016, 37(4): 691-697.

参考文献

[1] Environment Branch of the International Civil Aviation Organization (ICAO), ICAO Environmental Report 2013: Aviation and Climate Change[EB/OL].http://www.icao.int, 2013
[2] 徐华胜, 邓远灏, 马存祥. 民用航空发动机低排放燃烧室技术[J]. 航空科学技术, 2012, 23(4).
[3] Mongia　H　C. TAPS－A 4th Generation Propulsion Combustor Technology for Low Emissions[R]. AIAA 2003-2657.
[4] Michael J Foust , Doug Thomsen, Rick Stickles, et al. Development of the GE Aviation Low Emissions TAPS Combustor for Next Generation Aircraft Engines[R]. AIAA 2012-0936.
[5] Scott D Stouffer, Joseph Zelina, Hukam C Mongia. Development and Combustion Performance of a High-Pressure WER and TAPS Combustor[R]. AIAA 2005-1416.
[6] Waldemar Lazik, Thomas Doerr, Sebastian Bake. Low NO_x Combustor Development for the Engine3E Core Engine Demonstrator [R]. ISABE 2007-1190.
[7] Lazik W, Doerr Th, Bake S, et al. Development of Lean-Burn Low-NO_x Combustion Technology at Rolls-Royce Deutschland [R]. ASME GT-2008-51115.
[8] Holger Klinger, Sebastian Bake, Hans-Frieder Vogt, et al. Altitude Testing of the E3E Core Engine[R]. ASME GT-2011-45876.
[9] Osamu Funatogawa. Research and Technology Development in Japanese Environmentally Compatible Engine for Small Aircraft Project[R]. ISABE 2005-1010.
[10] Takeshi Yamamoto, Kazuo Shimodaira, Yoji Korosawa, et al. Research and Development of Staging Fuel Nozzle for Aeroengine[R]. ASME GT-2009-59852.
[11] Fujiwara H, Matsuura K, Shimodaira K, et al. Suppression of NO_x Emission of a Lean Staged Combustor for an Aircraft Engine[R].ASME GT-2011-46256.
[12] Ryusuke Matsuyama, Masayoshi Kobayashi, Hideki Ogata, et al. Development of a Lean Staged Combustor for Small Aero-Engines[R]. ASME GT-2012-68272.
[13] 邓远灏, 朱嘉伟, 颜应文, 等. 试验研究LPP低污染燃烧室冷态流场与油雾特性[J]. 南京航空航天大学学报, 2013, 34(3).
[14] 邓远灏, 颜应文, 朱嘉伟, 等. LPP低污染燃烧室两相喷雾燃烧数值研究[J]. 推进技术, 2013, 34(3). (DENG Yuan-hao, YAN Ying-wen, ZHU Jia-wei, et al. Numerical Study of Two-Phase Spray Combustion for Lean Premixed Prevaporized Low-Emission Combustor[J]. Journal of Propulsion Technology, 2013, 34(3).)
[15] 马存祥,邓远灏,徐华胜. 一种模型低污染燃烧室三维两相数值模拟[J]. 燃气涡轮试验与研究, 2012, 25(2).
[16] 邓远灏, 马存祥, 徐华胜, 等.一种部分预混预蒸发燃烧室[P]. 中国专利: ZL.2010 2 0701308.6, 2011.
[17] International Civil Aviation Organization. International Standard and Recommended Practices Environment Protection, Annex16, Vol. II, Aircraft Engine Emissions, [S]. 2008.
[18] International Civil Aviation Organization. ICAO Engine Emissions Databank 20B[S].2014.　　　　　　　　　　　　　*　收稿日期:2014-11-24；修订日期:2015-03-06。作者简介:邓远灏,男,博士生,高级工程师,研究领域为发动机燃烧。E-mail: dengyuanhao_gte@163.com(编辑:张荣莉)