旋转冲压压缩转子试验系统通流部分数值研究

推进技术 ›› 2016, Vol. 37 ›› Issue (4): 758-768.

旋转冲压压缩转子试验系统通流部分数值研究

韩吉昂,管健,钟兢军,苑辰光

大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026,大连海事大学轮机工程学院，辽宁大连 116026

发布日期:2021-08-15
作者简介:韩吉昂，男，博士，副教授，研究领域为发动机气动力学。
基金资助:
国家自然科学基金资助项目(51406022)；辽宁省自然科学基金资助项目(2013020129)；

Numerical Research on Flow Passage of Ram-Rotor Test System

Marine Engineering College，Dalian Maritime University，Dalian 116026，China,Marine Engineering College，Dalian Maritime University，Dalian 116026，China,Marine Engineering College，Dalian Maritime University，Dalian 116026，China and Marine Engineering College，Dalian Maritime University，Dalian 116026，China

Published:2021-08-15

摘要/Abstract

摘要： 为了评估旋转冲压压缩转子试验系统的气动性能，采用Fluent软件对其通流部分在设计转速下的流场进行了全通道数值模拟。分析了旋转冲压压缩转子达到最高效率时，试验系统各部分的总体性能以及导叶段、旋转冲压压缩转子段和出口支板段的流动特征。计算结果表明，进口段和导叶段内气流损失较小，总压恢复系数分别为0.995和0.979，且气流在导叶内基本实现了预期的偏转和加速。旋转冲压压缩转子压比较高，单转子压比可到2.756。超声速压缩面区域不同节距方向的激波系结构有较大差异，同时存在正常反射和马赫反射现象。出口支板段存在大范围的流动分离，不利于出口气流顺畅的流出。

关键词: 旋转冲压压缩转子；试验系统；通流部分；气动性能；数值模拟

Abstract: In order to evaluate the aerodynamic performance of the ram-rotor test system，FLUENT software was used to carry out numerical simulation on the flow passage of the ram-rotor test system at the design speed. Overall performance of each segment of the test system was analyzed at peak efficiency condition of the ram-rotor，and the flow characteristics of the vane，the ram-rotor and the support segments were also discussed. It has been found that the flow loss in the inlet and vane segments is low，and the total pressure recovery coefficients are 0.995 and 0.979，respectively. The flow in the vane passage is deflected and accelerated as expected. There is a high total pressure ratio of 2.756 in the ram-rotor segment. The structure of shock waves along the pitch direction is different in the zone of the supersonic compression ramp，and normal and Mach reflection of shock waves are observed at the same time. It has the large scale flow separation in the support segment，and the outflow of the test system can not benefit from this.

Key words: Ram-rotor；Test system；Flow passage；Aerodynamic performance；Numerical simulation

韩吉昂,管健,钟兢军,苑辰光. 旋转冲压压缩转子试验系统通流部分数值研究[J]. 推进技术, 2016, 37(4): 758-768.

HAN Ji-ang,GUAN Jian,ZHONG Jing-jun,YUAN Chen-guang. Numerical Research on Flow Passage of Ram-Rotor Test System[J]. Journal of Propulsion Technology, 2016, 37(4): 758-768.

参考文献

[1] De Viasi V. 485-kW Turbine Rated 35% Simple Cycle at 1700 F Firing Temperature[J]. Gas Turbine World, 2002,32(5): 13-16.
[2] Lawlor S P, Hinkey J B, Mackin S G, et al. Supersonic Compression Stage Design and Test Results[R]. ASME 2004-IMECE-59914.
[3] Steele R, Baldwin P, Kesseli J. Insertion of Shock Wave Compression Technology into Micro Turbines for Increased Efficiency and Reduced Costs[R]. ASME-2005-GT-68203.
[4] Lawlor S P, Baldwin P. Conceptual Design of a Supersonic CO₂ Compressor[R]. ASME 2005-GT- 68349.
[5] Grosvenor A D, Brown P M, Lawlor S P. Design Methodology and Predicted Performance for a Supersonic Compressor Stage[R]. ASME 2006-GT-90409.
[6] Grosvenor A D, Taylor D A, Bucher J R, et al. Measured and Predicted Performance of a High Pressure Ratio Supersonic Compressor Rotor[R]. ASME 2008-GT-50150.
[7] 于达仁, 何保成, 吕晓武, 等. 旋转冲压发动机进气道压比特性分析[J]. 推进技术, 2008, 29(3): 329-333. (YU Da-ren, HE Bao-cheng, LV Xiao-wu, et al. Characteristics Analysis of Pressure Ratios for Rotated Ramjet Inlets[J]. Journal of Propulsion Technology, 2008, 29(3): 329-333.)
[8] 田新, 刘占生. 旋转冲压发动机进气道流场及气流对转子的作用力研究[J]. 振动与冲击, 2008, 27(S):32-35.
[9] 亢维佳, 刘占生, 张广辉, 等. 背压脉动作用下旋转冲压转子进气道流场激励特性[J]. 推进技术, 2013, 34(07): 880-889. (KANG Wei-jia, LIU Zhan-sheng, ZHANG Guang-hui, et al. Flow Excitation Characteristics of Rampressor Inlet under Back Pressure Pulsation[J]. Journal of Propulsion Technology, 2013, 34(07): 880-889.)
[10] 亢维佳, 刘占生, 卢江波, 等. 转子涡动对旋转冲压转子进气道起动及性能的影响[J]. 推进技术, 2014, 35(10): 1333-1341. (KANG Wei-jia, LIU Zhan-sheng, LU jiang-bo, et al. Effects of Rotor Whirl on Starting Ability and Flow Performance of Rampressor Rotor Inlet[J]. Journal of Propulsion Technology, 2014, 35(10): 1333-1341.)
[11] 肖翔, 赵晓路, 徐建中. 高压比旋转冲压叶轮研究[J]. 工程热物理学报, 2009, 29(5): 759-762.
[12] 肖翔, 刘锡阳, 赵晓路, 等. 对转冲压压气机冲压叶栅实验研究[J]. 工程热物理学报, 2009, 30 (11): 1837-1840.
[13] 扈延林, 唐菲, 赵庆军, 等. 冲压叶栅边界层抽吸处理分析[J]. 推进技术, 2012, 33(03): 356-362. (HU Yan-lin, TANG Fei, ZHAO Qing-jun, et al. Numerical Investigation on the Effects of Boundary Layer Suction in a Ramrotor Cascade[J]. Journal of Propulsion Technology, 2012, 33(03): 356-362.)
[14] 扈延林, 孙小磊, 唐菲, 等. 冲压转子流场和轮毂抽吸处理分析[J]. 工程热物理学报, 2011, 32(7): 1111-1114.
[15] 韩吉昂. 旋转冲压压缩转子进气流道数值仿真及性能研究[D]. 哈尔滨:哈尔滨工业大学, 2009.
[16] 韩吉昂, 严红明, 钟兢军, 等. 旋转冲压压缩转子二维进气流道数值研究[J]. 航空动力学报, 2008, 23(6): 1054-1060.
[17] 韩吉昂, 钟兢军, 严红明, 等. 旋转冲压压缩转子三维进气流道数值研究[J]. 航空动力学报, 2009, 24(5): 1079-1088.
[18] HAN Ji-ang, ZHONG Jing-jun, PAN Zhen-sheng, et al. Effect of Tip Clearance Size on the Ram-Rotor Performance[R]. ASME 2014-GT-26084.
[19] 杨凌. 旋转冲压压缩转子结构与性能研究[D]. 大连:大连海事大学, 2011.
[20] 杨凌, 钟兢军, 韩吉昂, 等. 关键几何参数对旋转冲压压缩转子流场及性能影响研究[J]. 工程热物理学报, 2012, 33(03): 388-392.
[21] 钟兢军, 韩吉昂, 杨凌, 等. 旋转冲压压缩转子研究进展及发展前景[J]. 航空动力学报, 2011, 26(10): 2293-2301.
[22] Denton J D. Lessons from Rotor 37[J]. Journal of Thermal Science, 1997, 6(1): 1-13.
[23] Chima R V. Calculation of Tip Clearance Effects in a Transonic Compressor Rotor[J]. Journal of Turbomachinery, 1998, 120(1): 131-140.　　　　　　　　　　　　　*　收稿日期:2014-11-15；修订日期:2015-01-28。基金项目:国家自然科学基金资助项目(51406022)；辽宁省自然科学基金资助项目(2013020129)；辽宁省教育厅科学研究一般项目(L2013199)。作者简介:韩吉昂,男,博士,副教授,研究领域为发动机气动力学。E-mail: hit_hja@hotmail.com(编辑:梅瑛)