航空动压式油气分离器分离性能的实验研究

推进技术 ›› 2016, Vol. 37 ›› Issue (5): 852-857.

航空动压式油气分离器分离性能的实验研究

朱卫兵¹,王冬兰²,张小彬¹,段安鹏¹

哈尔滨工程大学航天与建筑工程学院，黑龙江哈尔滨 150001,北京动力机械研究所，北京 100074,哈尔滨工程大学航天与建筑工程学院，黑龙江哈尔滨 150001,哈尔滨工程大学航天与建筑工程学院，黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:朱卫兵，男，博士，教授，研究领域为燃烧、传热与多相流体动力学。

Experimental Study on Performance of Dynamic Pressure Type Lubricant-Air Separator

College of Aerospace and Civil Engineering，Harbin Engineering University，Harbin 150001，China,Beijing Power Machinery Institute，Beijing 100074，China,College of Aerospace and Civil Engineering，Harbin Engineering University，Harbin 150001，China and College of Aerospace and Civil Engineering，Harbin Engineering University，Harbin 150001，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究航空发动机动压式油气分离器的分离性能，采用容积法判别分离效率，并以此为据对结构形式、筒体直径及长度、入口管倾斜角和出气管长度等因素对分离性能的影响进行了研究。结果表明:采用内置式出气管与切向出油管相结合的形式，可使分离性能达到最佳；实验工况范围内，大的筒体直径更易于油气分离；入口管倾斜角存在最佳值，其值在10°～15°；当出气管长度取0.2～0.22倍分离器长度时，分离性能最佳；分离器长度过长会降低分离性能，实验条件下选5倍筒体直径为宜。

关键词: 航空发动机；动压式油气分离器；含气率；分离性能

Abstract: In order to investigate the separation performance of the dynamic pressure type lubricant-air separator，separation efficiency was obtained by the volumetric method. According to the volumetric method，the effects of structure form，cylinder diameter and length，inclination angle of inlet tube，air outlet length on the separation efficiency were studied. The results show that combined interior type air outlet pipe with tangential lubricant outlet，the separator can reach the best separation performance. Under the experimental condition，greater cylinder diameter can be helpful for the separation of gas-liquid. The most suitable angle of downward inclined tangential inlet tube changes from 10° to 15°. When the ratio of air outlet length to cylinder length was designed to vary from 0.2 to 0.22，the separation performance can achieve the best. Increasing cylinder length too much can reduce the separation performance. It is found that the appropriate ratio of cylinder length to diameter is about 5.

Key words: Aero-engine；Dynamic pressure type lubricant-air separator；Gas fraction；Separation performance

朱卫兵,王冬兰,张小彬,段安鹏. 航空动压式油气分离器分离性能的实验研究[J]. 推进技术, 2016, 37(5): 852-857.

ZHU Wei-bing¹,WANG Dong-lan²,ZHANG Xiao-bin¹,DUAN An-peng¹. Experimental Study on Performance of Dynamic Pressure Type Lubricant-Air Separator[J]. Journal of Propulsion Technology, 2016, 37(5): 852-857.

参考文献

[1] 航空工业总编委会. 《航空发动机设计手册》第12册[M]. 北京:航空工业出版社, 2002.
[2] 于尧. 动压式油气分离器和离心通风器的设计与仿真模拟[D]. 沈阳:东北大学, 2010.
[3] Kouba G E, Shoham O, Shirazi S. Design and Performance of Gas Liquid Cylindrical Cyclone Separator[C]. Cannes: The BHR Group 7th International Conference, 1995.
[4] Movafaghian S, Jaua-Marturet J A, Mohan R S, et al. The Effects of Geometry, Fluid Properties and Pressure on the Hydrodynamics of Gas-Liquid Cylindrical Cyclone Separators[J]. International Journal of Multiphase Flow, 2000, 26(6): 999-1018.
[5] Erdal F M, Shirazi S A. Local Velocity Measurements and Computational Fluid Dynamics (CFD) Simulations of Swirling Flow in a Cylindrical Cyclone Separator[C]. Houston: Proceedings of the Engineering Technology Conference 2001: 823-833.
[6] 金向红, 金有海, 王振波, 等. 气液旋流分离器排气管结构试验[J]. 中国石油大学学报(自然科学版), 2008(2): 108-113.
[7] 金向红, 金有海, 王振波, 等. 筒体结构对轴流式气液旋流器分离性能的影响[J]. 流体机械, 2008(1):10-13.
[8] 金向红, 金有海, 王建军, 等. 气液旋流器的分离性能[J]. 中国石油大学学报(自然科学版), 2009(5):124-129.
[9] 冯健美, 杨鑫, 高翔, 等. 旋风式油气分离器数值模拟与实验研究[J]. 西安交通大学学报, 2011(7): 55-59.
[10] Tachih H, Chen D, Greenberg P S, et al. Effect of Geometric Configuration on the Collection Efficiency of Axial Flow Cyclones[J]. Journal of Aerosol Science, 2011, 42(2): 78-86.
[11] 赵立新, 宋民航, 蒋明虎, 等. 柱状气液分离器长径比优选及实验研究[J]. 化工机械, 2013(1):30-33+115.
[12] 金向红. 轴流式气液旋流分离器的试验研究与数值模拟[D]. 青岛:中国石油大学(华东), 2009.
[13] Gomez L E, Mohan R S, Shoham O, et al. Enhanced Mechanistic Model and Field-Application Design of Gas/Liquid Cylindrical Cyclone Separators[J]. SPE Journal, 2000, 5(2): 190-198.
[14] 张小彬, 朱卫兵, 杨春苗, 等. 基于气泡轨迹模型研究动压式油气分离器的分离性能[J]. 推进技术, 2014, 35(8):1016-1022. (ZHANG Xiao-bin, ZHU Wei-bing, YANG Chun-miao, et al. Study on Performance of Dynamic Pressure Oil-Gas Separator Using Bubble Trajectory Model[J]. Journal of Propulsion Technology, 2014, 35(8): 1016-1022.)
[15] Gomea L, Mohan R, Shoham O. Swirling Gas-Liquid Two-Phase Flow-Experiment and Modeling Part I: Swirling Flow Field[J]. Journal of Fluids Engineering, Transactions of the ASME, 2004, 126(6): 935-942.(编辑:朱立影) 　　　　　　　　　　　　　*　收稿日期:2014-12-02；修订日期:2015-03-10。作者简介:朱卫兵,男,博士,教授,研究领域为燃烧、传热与多相流体动力学。E-mail: zhuweibing@hrbeu.edu.cn