内直外旋气液同轴式喷嘴流量及雾化特性

推进技术 ›› 2016, Vol. 37 ›› Issue (7): 1280-1286.

内直外旋气液同轴式喷嘴流量及雾化特性

刘阳阳,何国强,魏祥庚,石磊

西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072,西北工业大学燃烧、热结构与内流场重点实验室，陕西西安 710072

发布日期:2021-08-15
作者简介:刘阳阳，男，硕士生，研究领域为航空宇航推进理论与工程。

Flow Rate and Spray Characteristics of Gas Centered

Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory，Northwestern Polytechnical University，Xi’an 710072，China,Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory，Northwestern Polytechnical University，Xi’an 710072，China,Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory，Northwestern Polytechnical University，Xi’an 710072，China and Science and Technology on Combustion，Internal Flow and Thermal-Structure Laboratory，Northwestern Polytechnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 针对气体中心直流、液体涡流器离心式内缩进气液同轴喷嘴，采用高速摄影和PDPA测量了其流量和雾化特性。发现在常温常压下，喷嘴流量近似与喷注压降的0.477次方成正比。喷嘴喷雾场为空心锥形，雾化角约为[110°]，随液体压降增加，雾化锥角增大。液体压降不变，雾化锥角受中心气体卷吸作用随气体压降增加而减小。液膜破碎距离与雾化锥角有关，雾化锥角越大，液膜破碎距离越短，反之亦然。随径向距离增加，雾化液滴轴向速度、径向速度减小，SMD先增大然后略有减小，沿径向呈“马鞍”状双峰分布；随轴向距离增加，粒子轴向速度减小，SMD减小。

关键词: 气液同轴式喷嘴；流量特性；喷雾特性

Abstract: To study the flow rate and spray characteristics of the gas-liquid recess coaxial injector，which consists of the gas-centered orifice injector and the liquid swirl injector，High-speed Photography Technique and Phase Doppler Particle Analyzer (PDPA) were used. At?normal temperature and pressure，the flux?is proportional to the pressure drop to the power of 0.477 nearly. The spray field is a hollow cone with a fixed spray angle，approximately，[110°]. The spray angle becomes bigger with the pressure drop of the liquid propellant bigger. In the case of the fixed pressure drop of the liquid propellant，the spray angle is affected by the gas and it declines due to the entrainment. The breakup length is related to the spray angle and it decreases when the angle increases and vice versa. In the case of fixed axial length away from the outlet of the injector，the axial and radial speed of the particles decline while the radial length rises. Additionally，with the radial length increasing，the Sauter Mean Diameter becomes bigger，followed by little decrease. The distribution shape of SMD along the radial direction has two peaks，as a saddle. In the case of the fixed radial length，the axial speed and SMD go down when the axial length goes up.

Key words: Gas-liquid coaxial injector；Flow rate；Spray characteristics

刘阳阳,何国强,魏祥庚,石磊. 内直外旋气液同轴式喷嘴流量及雾化特性[J]. 推进技术, 2016, 37(7): 1280-1286.

LIU Yang-yang,HE Guo-qiang,WEI Xiang-geng,SHI Lei. Flow Rate and Spray Characteristics of Gas Centered[J]. Journal of Propulsion Technology, 2016, 37(7): 1280-1286.

参考文献

[1] Huang Y,Yang V. Dynamics and Stability of Lean-Premixed Swirl-Stabilized Combustion[J]. Progress in Energy and Combustion Science, 2009, 35: 293-364.
[2] 王振国, 周进, 鄢小清, 等. 气液同轴离心式喷嘴雾化特性实验研究[J]. 国防科技大学学报, 1996, 18(1): 7-11.
[3] 孙纪国, 庄逢辰, 王珏. 缩进深度对同轴式喷嘴流量特性的影响[J]. 推进技术, 2003, 24(5): 452-455. (SUN Ji-guo, ZHUANG Feng-chen, WANG Jue. Effects of Recess on Coaxial Injector's Discharge Coefficient and Performance[J]. Journal of Propulsion Technology, 2003, 24(5): 452-455.)
[4] 王国辉, 蔡体敏, 何国强, 等. 一种旋流式喷嘴的实验和数值研究[J]. 推进技术, 2003, 24(1): 28-32. (WANG Guo-hui, CAI Ti-min, HE Guo-qiang, et al. Experimental and Numerical Investigation of a Swirl Atomizer[J]. Journal of Propulsion Technology, 2003, 24(1): 28-32.)
[5] 刘娟, 孙明波, 李清廉, 等. 基于VOF方法分析离心式喷嘴结构参数对性能影响[J]. 航空动力学报, 2011, 26(12): 2826-2832.
[6] 张蒙正, 李鳌, 李进贤, 等. 气/液同轴离心式喷嘴流量及雾化特性实验[J]. 推进技术, 2004, 25(1): 19-22. (ZHANG Meng-zheng, LI Ao, LI Jin-xian, et al. Experimental Study on Flow Rate and Spray Characteristic of Coaxial Centrifugal Injector[J]. Journal of Propulsion Technology, 2004, 25(1): 19-22.)
[7] 何浩波. 气/液同轴喷嘴常压雾化燃烧实验研究[D]. 西安:西北工业大学, 2003.
[8] 康忠涛, 李清廉, 张新桥, 等. 气液同轴双离心式喷嘴喷雾特性[J]. 国防科技大学学报, 2014, 36(5): 50-57.
[9] Ji-Hyuk Im, Seongho Cho, Yoon Y, et al. Comparative Study of Spray Characteristics of Gas-Centered and Liquid-Centered Swirl Coaxial Injectors[J]. Journal of Propulsion and Power, 2010, 26(6): 1196-1204.
[10] Byung-Jik Lim, Seonghyeon Seo, Munki Kim, et al. Combustion Characteristics of Swirl Coaxial Injectors at Kerosene-Rich Conditions[J]. Fuel, 2013, (106): 639-645.
[11] Hamid A H A, Atan R. Spray Characteristics of Jet–Swirl Nozzles for Thrust Chamber Injector[J]. Aerospace Science and Technology, 2009, 13(4-5): 192-196.
[12] Soller S, Wagner R, Kau H P, et al. Characterisation of Main Chamber Injectors for GOx/Kerosene in a Single Element Rocket Combustor[R]. AIAA 2005-3750.
[13] Zhuang F C, Sun J G. Effects of Swirl Coaxial Injector Parameters on LOx/GH2 Engine Combustion Performance[R]. AIAA 2002-3697.
[14] Yang L J, Ge M H, Zhang M Z, et al. Spray Characteristics of Recessed Gas-Liquid Coaxial Swirl Injector[J].Journal of Propulsion and Power, 2008, 24(6): 1332-1339.
[15] 周进, 胡小平, 黄玉辉, 等. 液体火箭发动机气液同轴式喷嘴混合特性实验研究[J]. 国防科技大学学报, 1997, 19(4): 9-13. 　　(编辑:朱立影)　　　　　　　　　　　*　收稿日期:2015-03-06；修订日期:2015-05-05。作者简介:刘阳阳,男,硕士生,研究领域为航空宇航推进理论与工程。E-mail: liu_yangy@126.com