微尺度阵列射流冲击结构换热特性实验研究

推进技术 ›› 2016, Vol. 37 ›› Issue (9): 1681-1687.

微尺度阵列射流冲击结构换热特性实验研究

闫建坤¹,郭涛¹,朱惠人¹,郑杰¹,郭文²,苏云亮²

西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,西北工业大学动力与能源学院，陕西西安 710072,中国燃气涡轮研究院涡轮室，四川成都 610500,中国燃气涡轮研究院涡轮室，四川成都 610500

发布日期:2021-08-15
作者简介:闫建坤，男，硕士生，研究领域为航空发动机高温部件冷却技术。
基金资助:
国家重点基础研究发展规划资助项目(2013CB035702)。

Experimental Investigation of Heat Transfer Characteristics

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710072，China,Turbine Group，China Gas Turbine Establishment ，Chengdu 610500 ，China and Turbine Group，China Gas Turbine Establishment ，Chengdu 610500 ，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究真实发动机尺寸下带有长圆形扰流柱阵列射流冲击结构的换热特性，选取雷诺数Re范围为1000～10000，并保证与真实发动机工况相同的克努森数Kn条件下，进行了实验研究。扰流柱排布方式分为顺排和叉排，冲击孔径D=0.4mm，0.5mm，0.6mm，冲击距H/D=1，1.5，2，详细分析了几何参数对结构整体平均对流换热系数的影响。结果表明:扰流柱的排布方式对平均换热系数影响很小，原因在于长圆形扰流柱的导流作用强于扰流作用；相同雷诺数时，孔径减小，流量减小33%，换热系数最大下降幅度10%，小孔结构具有保持相同换热强度、减小流量的应用潜力；相同雷诺数时，换热系数随着冲击距的减小而增大。

关键词: 微尺度；阵列冲击；换热系数；微尺度实验；克努森数；雷诺数

Abstract: In order to investigate the heat transfer characteristics of array jet impingement with oblong pin-fin in real engine size，experimental study was taken with the Reynolds number varying from 1000 to 10000 and the Knudsen number equal to the real working condition of engine. The arrangement of pin-fin arrays was divided into in-line and staggered. The diameter of impingement holes were 0.4mm，0.5mm and 0.6mm，respectively. Ratios of the distance between the impingement wall and the target wall to the impingement hole diameter(H/D)were 1，1.5 and 2，respectively. The effects of these geometries on the average heat transfer coefficient of the structure were studied. The results reveal that the arrangement of pin-fin arrays has little influence on average heat transfer coefficient of the channel. The oblong pin-fin is more likely to guide the flow than turbulent it .With the same Reynolds number when the impingement hole diameter decreases，the mass flow rate of the cooling-air decreases by 33%，but the average heat transfer coefficient drops 10% at most. The structure with smaller hole has the potential to keep the same heat transfer intensity and reduce the mass flow rate of the cooling-air at the same time. And with the same Reynolds number，the average heat transfer coefficient of the structure decreases as the H/D increases.

Key words: Micro-scale；Jet impingement array；Heat transfer coefficient；Micro-scale experiment; Knudsen number；Reynolds

闫建坤,郭涛,朱惠人,郑杰,郭文,苏云亮. 微尺度阵列射流冲击结构换热特性实验研究[J]. 推进技术, 2016, 37(9): 1681-1687.

YAN Jian-kun¹,GUO Tao¹,ZHU Hui-ren¹,ZHENG Jie¹,GUO Wen²,SU Yun-liang². Experimental Investigation of Heat Transfer Characteristics[J]. Journal of Propulsion Technology, 2016, 37(9): 1681-1687.

参考文献

[1] 韩介勤, 桑地普·杜达,斯瑞纳斯·艾卡德. 燃气轮机传热和冷却技术[M]. 西安:西安交通大学出版社,2005.
[2] 陶然,权晓波, 徐建中. 微尺度流动研究中的几个问题[J]. 工程热物理学报, 2001, 22(5): 575-577.
[3] Tuckerman D B, Pease R F W. High-Performance Heat Sinking For VLSI[J]. Electron Device Letters, IEEE, 1981, 2(5): 126-129.
[4] Adams T M, Abdel-Khalik S I, Jeter S M, et al. An Experimental Investigation of Single-Phase Forced Convection in Microchannels[J]. International Journal of Heat and Mass Transfer, 1998, 41(6): 851-857.
[5] Celata, Gian Piero, Cumo M, et al. ? Thermal-Hydraulic Characteristics of Single-Phase Flow in Capillary Pipes[J]. Experimental Thermal and Fluid Science, 2004, 28(2): 87-95.
[6] Weaver S A, Barringer M D, Thole K A. Microchannels with Manufacturing Roughness Levels[J]. Journal of Turbomachinery, 2011, 133(4).
[7] Daxiang Deng, Ruxiang Chen, Hao He, et al. Effects of Heat Flux, Mass Flux and Channel Size on Flow Boiling Performance of Reentrant Porous Microchannels[J]. Experimental Thermal and Fluid Science, 2015, 64: 13-22.
[8] Yeshayahou Levy, Arvind G Rao, Erenburg V, et al. Pressure Losses for Jet Array Impingement with Crossflow[R]. ASME GT-2012-68386.
[9] Afzal Husain, Jun-Hee Kim, Kwang-Yong Kim. Thermal Characterization of Multiple Micro-Jet Impingement Cooling Model[R]. ASME ICNMM-2014-21736.
[10] 邬小波, 过增元. 微细光滑管内气体的流动与传热特性研究[J]. 工程热物理学报, 1997, 18(3): 326-330.
[11] 秦丰华, 姚久成, 孙德军, 等. 微尺度圆管内气体流量的实验测量[J]. 实验力学, 2001, 16(2): 119-126.
[12] 赵清民, 岳湘安, 王斐, 等. 高压气体在微圆管中的流动特性[J]. 中国石油大学学报(自然科学版), 2012, 36(4): 129-133.
[13] 陈志静. 微尺度流道相变传热特性的实验研究[J]. 节能技术, 2013, 31(2): 104-107.
[14] 许艳芝, 朱惠人, 郑杰. 克努森数在微尺度相似流动特性研究中的作用[J]. 航空动力学报, 2013, 28(8): 1752-1758.
[15] 郑杰, 朱惠人, 郭涛, 等. 克努森数对微尺度相似流动特性影响的实验[J]. 航空动力学报, 2014, 29(8): 1782-1788.
[16] 郑杰, 朱惠人, 郭涛, 等. 微尺度冲击冷却通道换热特性实验研究[J]. 推进技术, 2015, 36(1): 82-88. (ZHENG Jie, ZHU Hui-ren, GUO Tao, et al. Experimental Investigation on Jet Impingement Heat Transfer for Micro-Channel[J]. Journal of Propulsion Technology, 2015, 36(1): 82-88.)
[17] 刘静. 微米/ 纳米尺度传热学[M] . 北京:科学出版社, 2001.
[18] Matsumoto R, Kikkawa S, Senda M. Effect of Pin Fin Arrangement on Endwall Heat Transfer[J]. JSME International Journal Series B, 1997, 40(1): 142-151.
[19] Jenn-Jiang Huang, Chau-chin Lu. Detailed Heat Transfer Characteristic Comparison in Straight and 90-Deg Turned Trapezoidal Ducts with Pin-Fin Arrays[J].Journal of Heat Transfer, 1999, 42(21): 4005-4016.
[20] 毛军逵, 刘震雄, 郭文. 小间距冲击凹柱面靶板换热特性实验[J]. 推进技术, 2008, 29(2): 143-148. (MAO Jun-kui, LIU Zhen-xiong, GUO Wen. Experiment of Heat Transfer on Concave Surface in Single Jet Impingment Cooling System in Small Jet-to-Target Space[J]. Journal of Propulsion Technology, 2008, 29(2): 143-148.)(编辑:梅瑛)　　　　　　　　　　　　　*　收稿日期:2015-03-23；修订日期:2015-05-05。基金项目:国家重点基础研究发展规划资助项目(2013CB035702)。作者简介:闫建坤,男,硕士生,研究领域为航空发动机高温部件冷却技术。E-mail: dxyjkd@126.com