离心压气机非轴对称流动特性分析

推进技术 ›› 2017, Vol. 38 ›› Issue (1): 103-111.

离心压气机非轴对称流动特性分析

王磊磊¹,侯红娟¹,杨策²,老大中²,李延昭³

河北工程大学装备制造学院，河北邯郸 056038,河北工程大学装备制造学院，河北邯郸 056038,北京理工大学机械与车辆学院，北京 100081,北京理工大学机械与车辆学院，北京 100081,康跃科技股份有限公司，山东寿光 262711

发布日期:2021-08-15
作者简介:王磊磊，男，博士，讲师，研究领域为叶轮机械与增压技术。E-mail: wangll@hebeu.edu.cn 通讯作者:侯红娟，女，硕士，讲师，研究领域为内燃机。
基金资助:
国家自然科学基金资助项目(51276017)；博士点基金项目(20111101130002)；河北省高校科研项目

Non-axisymmetric Flow Characteristics in Centrifugal Compressor

College of Equipment Manufacturing，Hebei University of Engineering，Handan 056038，China,College of Equipment Manufacturing，Hebei University of Engineering，Handan 056038，China,School of Mechanical Engineering，Turbomachinery Institute，Beijing Institute of Technology，Beijing 100081，China,School of Mechanical Engineering，Turbomachinery Institute，Beijing Institute of Technology，Beijing 100081，China and Kangyue Technology Limited Company，Shouguan 262711，China

Published:2021-08-15

摘要/Abstract

摘要： 为探求离心压气机蜗壳周向不对称结构引起的内部非轴对称流动现象，采用实验和数值模拟(湍流模型为S-A模型)相结合的方法进行研究。结果表明:非设计工况下蜗壳高静压区域产生的扰动压力波向上游逆向传播，使压气机内部出现非轴对称流动。大流量工况(0.40kg/s)下蜗壳静压的不均匀程度比小流量工况(0.26kg/s)更明显，叶轮出口较强的扰动压力波可以逆向传播到叶轮进口大约180°的周向位置。流经扩压器的气流径向和切向速度的周向不均匀程度在小流量工况下较为显著，但大流量工况下蜗壳进口气流随时间的波动程度更明显。叶轮内部的非轴对称流动特性对叶片载荷分布及其波动形式产生影响，大流量工况下主叶片表面载荷波动主要受基频影响，而小流量工况下主要受2倍频的影响。

关键词: 离心压气机；非轴对称流动；流量；载荷

Abstract: To investigate the non-axisymmetric flow in centrifugal compressor internal caused by the asymmetric structure of the volute，the combined experimental and numerical methods(Turbulence model choosing S-A model) are used. The results show that the perturbing pressure wave caused by the high static pressure zone of the volute propagates to the upstream in off-design conditions，which brings the non-axisymmetric flow in the compressor. The non-uniform degrees of the static pressure distribution of the volute in the large flow conditions(0.40kg/s) are more obvious than those of the small flow conditions(0.26kg/s). The strong disturbance pressure wave of the impeller outlet can be transmitted to the circumferential position of the impeller inlet about 180°. In the small flow conditions，the circumferential non-uniform degrees of the radial and tangential velocity of the gas flow through the diffuser are more significant. In the large flow conditions，the air flow fluctuations at volute inlet are more obvious. The blade loading distribution and its fluctuations are also affected by the the non-axisymmetric flow. The loading fluctuations of the main blades in the large flow conditions are mainly affected by the blade pass frequency，but in the small flow condition，they are mainly influenced by the two times of the blade pass frequency.

Key words: Centrifugal compressor；Non-axisymmetric flow；Mass flow；Load

王磊磊,侯红娟,杨策,老大中,李延昭. 离心压气机非轴对称流动特性分析[J]. 推进技术, 2017, 38(1): 103-111.

WANG Lei-lei¹,HOU Hong-juan¹,YANG Ce²,LAO Da-zhong²,LI Yan-zhao³. Non-axisymmetric Flow Characteristics in Centrifugal Compressor[J]. Journal of Propulsion Technology, 2017, 38(1): 103-111.

参考文献

[1] Hawley J G, Wallace F J, Cox A, et al. Variable Geometry Turbocharging for Lower Emissions and Improved Torque Characteristics[J]. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1999, 213(2): 145-159.
[2] Reunanen A, Pitkanen H, Larjola J, et al. Computational and Experimental Comparison of Different Volute Geometries in a Radial Compressor[R]. ASME 2000-GT-469.
[3] Sorokes J M, Borokes C and Koch J M. Investigation of the Circumferential Static Pressure Non-Uniformity Caused by a Centrifugal Compressor Discharge Volute[R]. ASME 1998-GT-326
[4] 高鹏, 楚武利, 吴艳辉, 等, 带周向槽机匣处理的离心压气机扩稳机理分析[J]. 推进技术, 2007, 28(4): 383-387. (GAO Peng, CHU Wu-li, WU Yan-hui, et al. Mechanism of Stall Margin Improvement in a Centrifugal Compressor with Circumferential Grooves Casing Treatment[J]. Journal of Propulsion Technology, 2007, 28(4): 383-387.)
[5] 高鹏, 楚武利, 杨泳. 低速离心压气机非稳态流和机匣处理的数值分析[J]. 推进技术, 2007, 28(1):32-35. (GAO Peng, CHU Wu-li, YANG Yong. Numerical Analysis for the Unsteady Flow and Casing Treatment in a Low Speed Centrifugal Compressor[J].Journal of Propulsion Technology, 2007, 28(1): 32-35.)
[6] Van den Braembussche R A, H?nde B M. Experimental and Theoretical Study of the Swirling Flow in Centrifugal Compressor Volutes[J]. Journal of Turbomachinery,1990, 112(1): 38-43.
[7] Gu F, Engeda A. A Numerical Investigation on the Volute/Impeller Steady-state Interaction Due to Circumferential Distortion[R]. ASME 2001-GT-0328.
[8] Zheng X Q, Huenteler J, Yang M Y, et al. Influence of the Volute on the Flow in a Centrifugal Compressor of a High-Pressure Ratio Turbocharger[J]. Proceedings of the Institution of Mechanical Engineers, Part A:Journal of Power and Energy, 2010, 224(8): 1157-1169.
[9] Hawley J G, Wallace F J, Cox A, et al. Variable Geometry Turbocharging for Lower Emissions and Improved Torque Characteristics[J]. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1999, 213(2): 145-159.
[10] Yang M Y, Zheng X Q, Zhang Y J, et al. Stability Improvement of High Pressure Ratio Turbocharger Centrifugal Compressor by Asymmetric Flow Control-Part I:Non-Axisymmetric Flow in Centrifugal Compressor[R]. ASME 2010- GT-22581.
[11] Hagelstein D, Hillewaert Koen, Van den Braembussche R A, et al. Experimental and Numerical Investigation of the Flow in a Centrifugal Compressor Volute[J]. Journal of Turbomachinery, 2000, 122(1): 22-31.
[12] 康顺, 刘强, 祁明旭. 一个高压比离心叶轮的CFD 结果确认[J]. 工程热物理学报, 2005, 26(3):400-404.
[13] 初雷哲. 高转速高压比离心压气机内部流动研究[D]. 北京:中国科学院工程热物理研究所, 2008.　　　　　　　　　　　　　*　收稿日期:2015-09-18；修订日期:2015-12-21。基金项目:国家自然科学基金资助项目(51276017)；博士点基金项目(20111101130002)；河北省高校科研项目 (ZD2016095)。作者简介:王磊磊,男,博士,讲师,研究领域为叶轮机械与增压技术。E-mail: wangll@hebeu.edu.cn通讯作者:侯红娟,女,硕士,讲师,研究领域为内燃机。E-mail: houhongjuan@hebeu.edu.cn(编辑:史亚红)