可控扩散叶型与双圆弧叶型实验对比研究

推进技术 ›› 2017, Vol. 38 ›› Issue (1): 61-68.

可控扩散叶型与双圆弧叶型实验对比研究

魏巍¹,刘波²,杜炜¹,任思源¹

中国空气动力研究与发展中心高速空气动力研究所，四川绵阳 621000,西北工业大学动力与能源学院，陕西西安 710072,中国空气动力研究与发展中心高速空气动力研究所，四川绵阳 621000,中国空气动力研究与发展中心高速空气动力研究所，四川绵阳 621000

发布日期:2021-08-15
作者简介:魏巍，男，硕士，工程师，研究领域为叶轮机械气动热力学。

Experimental Comparison of Controlled Diffusion Airfoils with Double Circle Airfoils

High Speed Aerodynamics Institute，Chinese Aerodynamic Research and Development Center， Mianyang 621000，China,School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China,High Speed Aerodynamics Institute，Chinese Aerodynamic Research and Development Center， Mianyang 621000，China and High Speed Aerodynamics Institute，Chinese Aerodynamic Research and Development Center， Mianyang 621000，China

Published:2021-08-15

摘要/Abstract

摘要： 为对比不同压气机叶型的流动特征，在高亚声速平面叶栅风洞内对相同设计速度三角形的可控扩散叶型和双圆弧叶型进行了平面叶栅实验，对两套叶型的表面马赫数、尾迹总压等参数分布进行了测量。实验结果表明:设计点可控扩散叶型总压损失比双圆弧叶型小近1倍，出口气流角小2.0°；在吸力面气流分离前，出口气流角随攻角和马赫数变化小于1.0°，尾迹核心区位置保持不变；双圆弧叶型吸力面近尾缘存在一定区域气流分离，受分离区影响，随进口马赫数增加，出口气流角变化达到4°，尾迹核心区移动了近20%栅距。

关键词: 可控扩散叶型；双圆弧叶型；平面叶栅；气流分离；压气机

Abstract: In order to compare the flow characteristics of different compressor airfoils，experiments has been made on a controlled diffusion airfoil (CDA)，as well as a double circle airfoil (DCA) in a high subsonic cascade wind tunnel. The two airfoils are designed for the same velocity triangle at subsonic condition，and the experiments contain the measurement of surface Mach number and the wakes profiles. The results show that the total pressure loss of the controlled diffusion airfoil is nearly half of the double circle airfoil，so is the exit flow angle 2° smaller than that of the double circle airfoil. Before the flow separates on the suction side of CDA，the variations of exit flow angles are within 1° with the incidence and inlet Mach number varying. The core region of the wakes keep fixed among the pitch. However，there is a small flow separation region near the trailing edge of the double circle airfoil，which results in the flow loss and the deficit of flow turning. With the inlet Mach number increasing，the variations of the exit flow angles amount up to 4°，and the core region of the wakes move nearly 20% pitch.

Key words: Controlled diffusion airfoil；Double circle airfoil；Cascade；Flow separation；Compressor

魏巍,刘波,杜炜,任思源. 可控扩散叶型与双圆弧叶型实验对比研究[J]. 推进技术, 2017, 38(1): 61-68.

WEI Wei¹,LIU BO²,DU Wei¹,REN Si-yuan¹. Experimental Comparison of Controlled Diffusion Airfoils with Double Circle Airfoils[J]. Journal of Propulsion Technology, 2017, 38(1): 61-68.

参考文献

[1] Smith N HS. Aeroengine Design: From State of the Art of Turbofans Towards Innovative Architectures[R]. Belgium: Lecture Series 2013 of Von Karman Institute for Fluid Dynamics, 2013.
[2] Lotfi O, Teixeira J A, Lvey P C. Shape Optimization of Axial Fan Blades Using Genetic Algorithms and a 3D Naver-Stokes Solver[R]. ASME GT2006-90659.
[3] Benjamin W, Siva N. Constrained Adjoint-Based Aerodynamic Shape Optimization of a Single-Stage Transonic Compressor[J]. Journal of Turbomachinery, 2013, 135(3).
[4] Behlke R F. The Development of a Second Generation of Controlled Diffusion Airfoils for Multistage Compressor[J]. Journal of Turbomachinery, 1986, 108(7): 32-40.
[5] Rechter H, Steinert W, Lehmann K. Comparison of Controlled Diffusion Airfoils with Conventional NACA 65 Airfoils Developed for Stator Blade Application in a Multistage Axial Compressor[J]. Journal of Turbomachinery, 1985, 107(4): 494-498.
[6] Sanjosé M, Moreau S, Pérot F. Direct Self-Noise Simulation of the Installed Controlled Diffusion Airfoil[R]. AIAA 2011-2716.
[7] Bauer F, Garabedian P, Korn D A Jameson. Supercritical Wing Sections Ⅱ[M]. New York: Springer-Verlag, 1975.
[8] Schmidt E. Computation of Supercritical Compressor and Turbine Cascades with a Design Method for Transonic Flows[J]. Journal of Engineering for Power, 1980(1): 68-74.
[9] Sanger N L. The Use of Optimization Techniques to Design Controlled Diffusion Compressor Blading[J]. Journal of Engineering for Power, 1983(4): 256-264.
[10] Caspar J R, Hobbs D E, Davis R L. The Calculation of Two Dimensional Compressible Potential Flow in Cascades Using Finite Area Techniques[J]. AIAA Journal, 1982(1).
[11] 刘波. 流-势函数法人工密度格式在叶型设计中的应用[J]. 航空动力学报, 1988(3): 223-226.
[12] 周亚峰. 可控扩散叶栅设计与试验[J]. 航空发动机, 1994(3): 8-27.
[13] 程荣辉, 周拜豪, 余华蔚. 定制叶型技术及其在压气机设计中的应用[J]. 燃气涡轮试验与研究, 2000(1): 15-22.
[14] Hobbs D E, Weingold H D. Development of Controlled Diffusion Airfoils for Multistage Compressor Application[J]. Journal of Engineering for Gas Turbines and Power, 1984(106): 271-278.
[15] Elazar Y, Shreeve R P. Viscous Flow in a Controlled Diffusion Compressor Cascade with Increasing Incidence[J]. Journal of Turbomachinery, 1990(112): 256-265.
[16] Shreeve R P, Elazar Y, Dreon J W. Wake Measurements and Loss Evaluation in a Controlled Diffusion Compressor Cascade[J]. Journal of Turbomachinery,1991(113): 591-599.
[17] Hobson G V, Andrew Williams J H, Humberto J. Laser-Doppler Velocimetry Measurements in a Cascade of Compressor Blades at Stall[R]. ASME 96-GT-484.
[18] Alan D H, Gregory J W. Observations of Transition Phenomena on a Controlled Diffusion Compressor Stator with a Circular Arc Leading Edge[J]. Journal of Turbomachinery, 2010(132): 031002 1-9.
[19] McMullan W A, Page G J. Large Eddy Simulation of a Controlled Diffusion Compressor Cascade[J]. Flow Turbulence Combustion, 2011(86): 207-230.
[20] Christophe J, Anthoine J. Trailing Edge Noise of a Controlled- Diffusion Airfoil at Moderate and High Angle of Attack[R]. AIAA 2009-3196.
[21] Goodhand M N, Miller R J. Compressor Leading Edge Spikes: a New Performance Criterion[J]. Journal of Turbomachinery, 2011(133): 021006 1-8.
[22] 程荣辉. 跨声速可控扩散叶型叶栅设计与分析[J]. 燃气涡轮试验与研究, 1994(2): 23-26.
[23] 程荣辉, 仲永兴, 严汝群. 大弯度可控扩散叶型叶栅槽道中气体流动的试验研究[J]. 航空动力学报, 1993(8):221-224.
[24] 刘宝杰, 袁春香, 于贤君. 前缘形状对可控扩散叶型性能影响[J]. 推进技术, 2013, 34(7): 890-897. (LIU Bao-jie, YUAN Cun-xiang, YU Xian-jun. Effects of Leading-Edge Geometry on Aerodynamic Performance in Controlled Diffusion Airfoil[J]. Journal of Propulsion Technology, 2013, 34(7): 890-897.)
[25] 赵鹏程, 刘波, 宣扬, 等. 基于遗传算法的压气机叶型优化设计[J]. 航空计算技术, 2011(6): 12-15.
[26] Cumpsty N A. Compressor Aerodynamics[M]. New York: Longman Scientific & Technical, 1989.　　　　　　　　　　　　　*　收稿日期:2015-08-04；修订日期:2015-09-11。作者简介:魏巍,男,硕士,工程师,研究领域为叶轮机械气动热力学。E-mail: nwtu@163.com (编辑:史亚红)