Ma4一级内并联式TBCC发动机模态转换性能分析

推进技术 ›› 2017, Vol. 38 ›› Issue (2): 315-322.

Ma4一级内并联式TBCC发动机模态转换性能分析

张明阳¹,王占学^1,2,刘增文¹,张晓博¹

西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129; 中国空气动力研究与发展中心超高速空气动力研究所高超声速冲压发动机技术重点实验室，四川绵阳 621000,西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129

发布日期:2021-08-15
作者简介:张明阳，男，博士生，研究领域为航空发动机总体性能。

Analysis of Mode Transition Performance for a Mach 4 Over-Under TBCC Engine

School of Power and Energy，Northwestern Polytechnical University，Xi’an 710129，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710129，China; Science and Technology on Scramjet Laboratory，Hypervelocity Aerodynamics Institute of CARDC， Mianyang 621000，China,School of Power and Energy，Northwestern Polytechnical University，Xi’an 710129，China and School of Power and Energy，Northwestern Polytechnical University，Xi’an 710129，China

Published:2021-08-15

摘要/Abstract

摘要： 涡轮基组合循环(TBCC)发动机是未来远程高速飞行器和可重复使用双级入轨(TSTO)飞行器第一级运载器的理想动力，而模态转换是实现TBCC发动机工程实用所必须解决的关键技术之一。针对Ma4一级内并联式TBCC发动机，分析了其工作原理，发展了相应的总体性能计算模型，该模型考虑了进气道与发动机的流量匹配关系，改进了发动机模型的迭代求解方法。通过对比涡轮模态与冲压模态的净推力、单位燃油消耗率沿飞行轨迹的变化规律，确定模态转换马赫数为3.0。根据模态转换期间发动机推力、空气流量连续变化的基本要求，提出了一种根据涡轮发动机工作状态分三阶段进行的模态转换策略，确定了模态转换过程的参数调节规律。模态转换动态性能模拟结果表明，基本实现了涡轮模态至冲压模态的平稳转换，但在涡轮发动机加力关闭时，为保证发动机空气流量连续变化，发动机总推力将出现短暂的下降，降幅约为12.5%。

关键词: 内并联式TBCC；模态转换策略；动态性能；数值模拟

Abstract: The Turbine-Based Combined-Cycle Engine (TBCC) is a favored solution for powering both the future long-range high-speed vehicle and the Two-Stage-To-Orbit (TSTO) reusable launch vehicle. Mode Transition from the low-speed propulsion system to the high-speed propulsion system is one of the most critical TBCC enabling technologies. In this paper，the principles of the Mach 4 over-under TBCC engine were analyzed，and a flexible TBCC simulation model，which considered the inlet/engine mass flow matching and improved the iterative technique for engine model solving，was developed for the steady-state and transient performance analysis of all modes of operation，including mode transition. Through comparing the variations of net thrust and SFC along the flight trajectory between turbo mode and ram mode，the mode transition Mach number is selected as 3.0. Based on the basic principle of smooth thrust and air mass flow variations during mode transition，a three-phase mode transition strategy according to the turbine engine operation was proposed，and control schedules of the regulated parameters during mode transition was designed. The simulation results of mode transition dynamic performance show that the proposed strategy can basically realize the stable mode transition from turbo mode to ram mode，but there exists a short-time decrease of total thrust by about 12.5% when the turbine engine afterburner shuts down during mode transition to ensure that the total air mass flow maintains constant.

Key words: Over-under TBCC；Mode transition strategy；Dynamic performance；Numerical simulation

张明阳,王占学,刘增文,张晓博. Ma4一级内并联式TBCC发动机模态转换性能分析[J]. 推进技术, 2017, 38(2): 315-322.

ZHANG Ming-yang¹,WANG Zhan-xue^1,2,LIU Zeng-wen¹,ZHANG Xiao-bo¹. Analysis of Mode Transition Performance for a Mach 4 Over-Under TBCC Engine[J]. Journal of Propulsion Technology, 2017, 38(2): 315-322.

参考文献

[1] Saunders J D, Stueber T J, Thomas S R, et al. Testing of the NASA Hypersonics Project’s Combined Cycle Engine Large Scale Inlet Mode Transition Experiment (CCE LIMX)[R]. NASA/TM 2012-217217.
[2] Lynn E S, Daric W E, Rich L D, et al. Turbine Based Combination Cycle (TBCC) Propulsion Subsystem Integration[R]. AIAA 2004-3649.
[3] Andre W M, Ashwani K G, Mark J L, et al. Critical Issues in TCC Modeling[R]. AIAA 2004-3827.
[4] Daniel A H, Eric J G. Integrated Turbine-Based Combined Cycle Dynamic Simulation Model[C]. Arlington:58th Joint Army-Navy-NASA-Air-Farce (JANNAF) Interagency Propulsion, 2011.
[5] Christopher A S, Jaime J M. The Design and Performance Estimates for the Propulsion Module for the Booster of a TSTO Vehicle[R]. AIAA 91-3136.
[6] James R D, Anthony C M. Propulsion and Aerodynamic Analysis of the Beta Ⅱ Two-Stage-to-Orbit Vehicle[R]. AIAA 92-4245.
[7] 朱大明, 陈敏, 唐海龙, 等. 高超声速涡轮/冲压组合发动机方案[J]. 北京航空航天大学学报, 2006, 32(3): 263-266.
[8] 王永胜, 王占学, 刘增文, 等. 并联式涡轮冲压组合发动机安装性能数值模拟[J]. 推进技术, 2011, 32(3):312-317. (WANG Yong-sheng, WANG Zhan-xue, LIU Zeng-wen, et al. Numerical Simulation of Installed Performance for Parallel Turbo-Ramjet Combined Cycle Engine[J]. Journal of Propulsion Technology, 2011, 32(3): 312-317.)
[9] 张华军, 郭荣伟, 谢旅荣. 内并联型TBCC进气道方案设计及验证[J]. 航空动力学报, 2012, 27(11):2475-2483.
[10] 莫建伟, 徐惊雷, 乔松松. 并联式TBCC发动机排气系统性能数值模拟[J]. 推进技术, 2013, 34(4):463～469. (MO Jian-wei, XU Jing-lei, Qiao Song-song. Numerical Study of the Over-Under TBCC Exhaust System[J]. Journal of Propulsion Technology, 2013, 34(4): 463-469.)
[11] 张晓博, 王占学, 蔡元虎. 面向对象的航空发动机性能仿真系统研究[J]. 机械设计与制造, 2010, 11:133-135.
[12] Kowalski E J. A Computer Code for Estimating Installed Performance of Aircraft Gas Turbine Engines: Vol.Ⅰ- Final Report[R]. NASA CR 159691.
[13] 刘增文, 王占学, 蔡元虎. 涡轮基组合循环发动机性能数值模拟[J]. 推进技术, 2009, 30(1): 1-4. (LIU Zeng-wen, WANG Zhan-xue, CAI Yuan-hu, et al. Numerical Simulation of Performance for Turbine Based Combined Cycle Propulsion System[J]. Journal of Propulsion Technology, 2009, 30(1): 1-4.)
[14] Simion C K, Jay D D, George C, et al. A Scoping Study for Hypersonic Transport Propulsion Systems[R]. ASME 92-GT-409.
[15] Peter J O. Mode Transition Design Considerations for an Airbreathing Combined-Cycle Hypersonic Vehicle[R]. AIAA 2008-2621.
[16] Miyagi H, Miyagawa H, Monji T, et al. Combined Cycle Engine Research in Japanese HYPR Program[R]. AIAA 95-2751.　收稿日期:2016-10-10；修订日期:2016-10-25。作者简介:张明阳,男,博士生,研究领域为航空发动机总体性能。E-mail: my_npu@163.com(编辑:梅瑛)