油冷涡轮动叶方案中旋转冷却效应分析

推进技术 ›› 2017, Vol. 38 ›› Issue (2): 399-407.

油冷涡轮动叶方案中旋转冷却效应分析

秦江¹,孙红闯¹,白新阳¹,谢公南²,韩杰才³

哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,西北工业大学机电学院，陕西西安 710072,哈尔滨工业大学航天学院，黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:秦江，男，博士，副教授(博士生导师)，研究领域为发动机主动热防护、能量管理。
基金资助:
面上项目(51476044；51276047)；国家自然科学基金(51421063)。

Analysis of Rotating Cooling Effects with Oil for Turbine Blade

School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Mechatronics，Northwestern Polytechnical University，Xi’an 710072，China and School of Astronautics，Harbin Institute of Technology，Harbin 150001，China

Published:2021-08-15

摘要/Abstract

摘要： 空气涡轮技术可用于超燃冲压发动机，解决燃料和电力供给问题，其面临的主要障碍是冷源受限条件下涡轮动叶的冷却措施。提出了一种用燃料作为冷却剂的油冷方案，对涡轮动叶进行冷却。针对该方案，建立了三维模型并通过数值模拟方法评估该方案的可行性，并研究了旋转条件下的流动换热问题。结果表明:油冷方案可以在基本不影响涡轮性能的基础上有效降低动叶温度；单个叶片用1g/s流量的燃料就能使叶片的温度大幅降低；高速转动下，冷却通道中压力最高可达114.5MPa；旋转效应增强了冷却通道中流动的湍流度，提高了冷却剂与叶片之间的对流换热系数。

关键词: 涡轮动叶；燃料冷却；旋转冷却；数值模拟

Abstract: The air turbine can be used to solve the problems of fuel and power supply for Scramjet. The main obstacle is the cooling measure of turbine blades under limited cooling source. In this article，a new scheme was proposed to cool the blades with fuel used as coolant. Based on this oil cooling scheme，a three dimensional model was established to evaluate the feasibility and study heat transfer under rotation by numerical simulation. The results show that oil cooling scheme can efficiently reduce the temperature of blade with few negative effects on the performance of turbine. The temperature of blade can decrease greatly with the fuel mass flow rate of 1g/s. The maximum pressure of the coolant in the cooling channel can reach 114.5MPa in the rotating condition. Rotation effect enhances the turbulence intensity in the cooling channel and strengthens heat convection between the blade and fuel.

Key words: Turbine blade；Fuel cooling；Rotating cooling；Numerical simulation

秦江,孙红闯,白新阳,谢公南,韩杰才. 油冷涡轮动叶方案中旋转冷却效应分析[J]. 推进技术, 2017, 38(2): 399-407.

QIN Jiang¹,SUN Hong-chuang¹,BAI Xin-yang¹,XIE Gong-nan²,HAN Jie-cai³. Analysis of Rotating Cooling Effects with Oil for Turbine Blade[J]. Journal of Propulsion Technology, 2017, 38(2): 399-407.

参考文献

[1] Zhang D, Qin J, Feng Y, et al. Performance Evaluation of Power Generation System with Fuel Vapor Turbine Onboard Hydrocarbon Fueled Scramjets[J]. Energy, 2014, 77: 732-741.
[2] 王永鑫, 崔宇. 冲压空气涡轮在民用涡桨飞机中的应用[J]. 航空制造技术, 2014, 458(14): 86-88.
[3] 汪涛, 楚武利, 卢家玲, 等. 亚音速涵道式冲压空气涡轮性能数值仿真[J]. 计算机仿真, 2009, (10): 34-38.
[4] 李成, 蔡元虎, 屠秋野. 吸气式空气涡轮冲压发动机的过渡态性能[J]. 航空动力学报, 2013, (2): 385-389.
[5] 朱凯迪. 高速飞行器空气涡轮气动及冷却结构设计[D]. 哈尔滨:哈尔滨工业大学, 2014.
[6] Krivonosova V, Lebedev A, Simin N, et al. Experimental and Numerical Analysis of High Temperature Gas Turbine Nozzle Vane Convective and Film Cooling Effectiveness[R]. ASME GT2011-45294.
[7] Ruan B, Meng H. Numerical Model Development and Validation for Hydrocarbon Fuel Supercritical Heat Transfer with Endothermic Pyrolysis[J]. Acta Aeronautica et Astronautica Sinica, 2011, 32(12): 2220-2226.
[8] Yang Y, Yang J, Fang D. Research Progress on Thermal Protection Materials and Structures of Hypersonic Vehicles[J]. Applied Mathematics and Mechanics, 2008, 29: 51-60.
[9] Liu S, Zhang B. Effects of Active Cooling on the Metal Thermal Protection Systems[J]. Aerospace Science and Technology, 2011, 15(7): 526-533.
[10] Je-CHinHan, Sandip Dutta, Srinath V Ekkad. 燃气轮机传热和冷却技术[M]. 程代京, 谢永慧, 译. 西安:西安交通大学出版社, 2005.
[11] 邓宏武, 陶智, 徐国强, 等. 旋转带肋 U 型通道内流动与换热的数值模拟[J]. 推进技术, 2005, 26(4): 296-301. (DENG Hong-wu, TAO Zhi, XU Guo-qiang, et al. Simulation of Turbulent Flow and Heat Transfer in a Rotating Ribbed Serpentine Passage[J]. Journal of Propulsion Technology, 2005, 26(4): 296-301.)
[12] 刘宁, 孙纪宁. 旋转对气膜冷却影响的大涡模拟[J]. 推进技术, 2011, 32(2): 245-252. (LIU Ning, SUN Jining. Large Eddy Simulation of the Effect of Rotation on Film Cooling[J]. Journal of Propulsion Technology, 2011, 32(2): 245-252)
[13] 赵曙, 朱惠人, 郭涛, 等. 旋转带肋回转通道流动换热数值模拟[J]. 西安交通大学学报, 2014, 48(2): 125-130.
[14] Huang S C, Liu Y H. High Rotation Number Effect on Heat Transfer in a Leading Edge Cooling Channel of Gas Turbine Blades with Three Channel Orientations[J]. Journal of Thermal Science and Engineering Applications, 2013, 5(4).
[15] 汪新智, 马军军, 彭稳根, 等. 高超声速飞行器主动冷却系统优化设计[J]. 航空学报, 2014, 35(3): 624-633.
[16] 赵曙. 旋转状态下回转通道内部流动与换热特性研究[D]. 西安:西北工业大学, 2014.　　收稿日期:2016-10-09；修订日期:2016-10-25。基金项目:面上项目(51476044；51276047)；国家自然科学基金(51421063)。作者简介:秦江,男,博士,副教授(博士生导师),研究领域为发动机主动热防护、能量管理。E-mail: qinjiang@hit.edu.cn(编辑:梅瑛)