基本级叶片扩压器扩压度改进的闭式试验研究

推进技术 ›› 2017, Vol. 38 ›› Issue (5): 1047-1054.

基本级叶片扩压器扩压度改进的闭式试验研究

程超^1,2,秦国良¹,张家忠¹,陈党民²,李新宏²

西安交通大学能源与动力工程学院，陕西西安 710049; 西安陕鼓动力股份有限公司，陕西西安 710075,西安交通大学能源与动力工程学院，陕西西安 710049,西安交通大学能源与动力工程学院，陕西西安 710049,西安陕鼓动力股份有限公司，陕西西安 710075,西安陕鼓动力股份有限公司，陕西西安 710075

发布日期:2021-08-15
作者简介:程超，男，博士生，研究领域为真实气体压缩机性能改进和试验。
基金资助:
国家重点基础研究发展计划(2012CB026000)；高端压缩机组高效可靠及智能化基础研究。

Close Loop Real Test of Improved Vaned Diffuser Ratio for Basic Stage

School of Energy and Power Engineering，Xi’an Jiaotong University，Xi’an 710049，China; Xi’an Shaangu Power Co.Ltd，Xi’an 710075，China,School of Energy and Power Engineering，Xi’an Jiaotong University，Xi’an 710049，China,School of Energy and Power Engineering，Xi’an Jiaotong University，Xi’an 710049，China,Xi’an Shaangu Power Co.Ltd，Xi’an 710075，China and Xi’an Shaangu Power Co.Ltd，Xi’an 710075，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究真实气体条件下改进叶片扩压器扩压度对级性能的影响，基于真实气体闭式试验，对用于单轴多级离心压缩机的某基本级进行了扩压器入口安装角度调整，采用两种试验气体N2和CO₂，对调整后的基本级进行了真实气体闭式系统下的性能试验。试验结果表明:在真实气体闭式系统下，通过扩压器入口安装角度调整，叶轮和叶片扩压器匹配得到优化，基本级性能得到改进，基本级的能头系数增大1.86%，多变效率提高1.10%，喘振和阻塞裕度均有所改善。同时，两种试验气体N2和CO₂下基本级的无量纲性能偏差很小，表明无量纲性能是基本级的特性。

关键词: 离心压缩机；基本级；性能改进；闭式试验；无量纲性能

Abstract: In order to study the impact of improved vaned diffuser ratio for stage performance in real gas condition for a basic stage with single-shaft multi-stage centrifugal compressor，vaned diffuser entrance angle was adjusted and performance close loop test was carried out with nitrogen and carbon dioxide，respectively. Test results show that on close loop real gas test system by adjusting vaned diffuser entrance angle，impeller and vaned diffuser matching was optimized and the basic stage performance has been improved. By further transferring the test performance into dimensionless performance，results show that energetic coefficient increases by 1.86%，polytropic efficient increases by 1.1%，surge and blocking margin is improved on the improved basic stage，and dimensionless performance deviation of nitrogen and carbon dioxide on the basic stage is small. This confirms the dimensionless performance of basic stage.

Key words: Centrifugal compressor；Basic stage；Performance improvement；Closed loop test；Dimensionless performance

程超,秦国良,张家忠,陈党民,李新宏. 基本级叶片扩压器扩压度改进的闭式试验研究[J]. 推进技术, 2017, 38(5): 1047-1054.

CHENG Chao^1,2,QIN Guo-liang¹,ZHANG Jia-zhong¹,CHEN Dang-min²,LI Xin-hong². Close Loop Real Test of Improved Vaned Diffuser Ratio for Basic Stage[J]. Journal of Propulsion Technology, 2017, 38(5): 1047-1054.

参考文献

[1] 沈天耀. 离心叶轮的内流理论基础[M]. 杭州:浙江大学出版社, 1986.
[2] 苏长荪. 高等工程热力学[M]. 北京: 高等教育出版社, 1987.
[3] 徐忠. 离心压缩机原理[M]. 西安: 西安交通大学出版社, 1990.
[4] 王尚锦. 离心压缩机三元流动理论及应用[M]. 西安: 西安交通大学出版社, 1991.
[5] 陶文铨. 计算传热学的近代进展[M]. 北京: 科学出版社, 2000.
[6] 景思睿, 张鸣远. 流体力学[M]. 西安: 西安交通大学出版社, 2001.
[7] Takanori Shibata, Manabu Yagi, Hideo Nishida, et al. Performance Improvement of a Centrifugal Compressor Stage by Increasing Degree of Reaction and Optimizing Blade Loading of a 3D Impeller[J]. Journal of Turbomachinery, 2011, 133(2): 1-8.
[8] Ju YP, Zhang CH, Chi XL, et al. Optimization of Centrifugal Impellers for Uniform Discharge Flow and Wide Operating Range[J]. Journal of Propulsion and Power, 2012, 28(5): 888-899.
[9] 韩戈, 卢新根, 赵胜丰, 等. 喉部长度和扩张角对离心压气机管式扩压器影响研究[J]. 推进技术, 2014, 35(12): 1607-1614. (HAN Ge, LU Xin-gen, ZHAO Sheng-feng, et al. Effects of Diffuser Throat Length and Divergence Angle on Performance of Centrifugal Compressor with Pipe Diffuser[J]. Journal of Propulsion Technology, 2014, 35(12): 1607-1614.)
[10] 徐磊磊, 阮灿, 方骁远, 等. 前置扩压器几何参数对突扩扩压器性能的影响[J]. 推进技术, 2015, 36(7): 1054-1061. (XU Lei-lei, RUAN Can, FANG Xiao-yuan, et al. Effects of Pre-Diffuser on Performance of Dump Diffuser[J]. Journal of Propulsion Technology, 2015, 36(7): 1054-1061.)
[11] 刘帆, 张楚华, 王宝潼, 等. 实际气体R134a在离心叶轮内部流动的数值研究[J]. 工程热物理学报, 2007, 28(1): 136-138.
[12] 谭永前, 陈凤义, 吴峰, 等. 循环氢离心压缩机采用不同代用气体的性能试验[J]. 风机技术, 2009, (5): 11-13.
[13] Lettieri C, Baltadjiev N, Casey M, et al. Low-Flow-Coefficient Centrifugal Compressor Design for Supercritical CO₂[J]. Journal of Turbomachinery, 2014, 136(8): 1-9.
[14] 朱昌允, 秦国良, 吴让利. 基于试验的离心压缩机两种相似换算的比较[J]. 风机技术, 2011, (1): 24-27.
[15] 董帆, 田奇勇, 朱卫春. 离心风机性能相似换算误差修正算法研究[J]. 风机技术, 2014, (5): 44-48.
[16] Waleed Albusaidi, Pericles Pilidis. An Iterative Method to Derive the Equivalent Centrifugal Compressor Performance at Various Operating Conditions, Part II: Modeling of Gas Properties Impact[J]. Journal of Energies, 2015, 8(8): 8516-8536.
[17] Gu Lili, Zemp Armin, Abhari Reza S. Numerical Study of the Heat Transfer Effect on a Centrifugal Compressor Performance[J]. Proceedings of the Institution of Mechanical Engineers, 2015, 229(12): 2207-2220.
[18] 王洪伟, 刘涛, 宁方飞, 等. 大小叶片压气机级的计算与实验校验[J]. 推进技术, 2014, 35(3): 335-340. (WANG Hong-wei, LIU Tao, NING Fang-fei, et al. Numerical Simulation and Experimental Validation of a Compressor Stage with Splittered Rotor[J]. Journal of Propulsion Technology, 2014, 35(3): 335-340.)　　　　　　　　　　　　　*　收稿日期:2016-03-07；修订日期:2016-05-10。基金项目:国家重点基础研究发展计划(2012CB026000)；高端压缩机组高效可靠及智能化基础研究。作者简介:程超,男,博士生,研究领域为真实气体压缩机性能改进和试验。E-mail: shangu_cc@126.com(编辑:史亚红)